Eclipse® Membrane Modules Potted bundle

Slides:

Advertisements

Similar presentations

The Concept of the Basic Liquid

Advertisements

Tomáš Jiříček Tomáš Jiříček

MEMBRANE TECHNOLOGY MODULE MEMBRANE.

International Atomic Energy Agency IX.4.3. Waste management.

The AFC Process What Is AFC? Key Operations are  Balancing of incoming waste streams  Thermophilic activated sludge (AFC) to oxidise the organic.

© 2003 Innovation Scotch-Brite ™ Hand Pads Quality that Works.

Maintenance Aerosols & Liquids Manufactured by Amrep, Inc.

Super-M Hollow Fiber membranes for Purification, Separation & Concentration About Super-M PHILOSEP Super-M is UF/MF membrane module optimized to separation,

Transition Metals Noadswood Science, Transition Metals To understand the properties of transition metals Monday, May 04, 2015.

Configuration.Modules.Transport.Fouling

Chinese Rubber Industry Use of Semi-Permanent Release Agents to Maximize Profitability Bill D. Stephens, EZ-Kote Inc.

Chapter 3. The covalent bond of a water molecule Oxygen being more electronegative than hydrogen attracts the electron of Hydrogen close to it. This results.

I.1 ii.2 iii.3 iv.4 1+1=. i.1 ii.2 iii.3 iv.4 1+1=

I.1 ii.2 iii.3 iv.4 1+1=. i.1 ii.2 iii.3 iv.4 1+1=

Combined Ozonation-Nanofiltration for Drinking Water Treatment B. S

Reverse Osmosis Lec. 9 Dr. Ola Abdelwahab.

Air Cleaning Devices. 2 Is An Air Cleaner Needed ?  Toxicity of materials discharged  Amount of material to be discharged  Value of material to be.

Basic Chemistry for Biology Water and Solutions. Water’s Life Supporting Properties Important to all living things 1.Moderation of temperature 2.Lower.

Teflon By Andrew Tucker IED. Evolution of Teflon.

Gasifier/Feedstock Effect on Syngas Composition Department of Mechanical Engineering, Yuan Ze University 1.

Alternative Separations

Rajni Patel Gopani Product Systems 13 th Sep

Immobilized Enzyme Systems

Properties of Matter Physical Properties: Can be observed without changing a substance into another substance. Boiling point, density, mass, volume, etc.

Radiation – the transfer of energy through space. Heat transfer by radiation takes place with no direct contact between a heat source and an object. Example.

The properties of water Life depends on them!. Water is polar Covalent bond.

8.1.4 Can it still be factored? Factoring Completely I can factor out a common factor.

By: Nadia and Tiffany and Kemuelle. Covalent Network: Linear Chain.

Novel Waterborne Epoxy Curing Agent Technology

Packed Column Internals

Presentation for project in Israel

Mixtures and Solutions Notes  Pure substance: matter that has definite chemical and physical properties  Mixture: matter that contains two or more substances.

Plant flexibility Market factors – Flexibility to produce alternative products – Produce multiple products simultaneously Societal trends – Utilization.

Batch at the limit?!. Current situation of the process  capacity usage at the maximum  optimized processes  standardized formulations  limited capacities.

Neoprene By Christopher White What is it? Versatile synthetic rubber Originally an oil-resistant substitute or natural rubber The basic chemical.

World’s Best Ceramic water filters

 Most important inorganic molecule in living things.  Living organisms = 75-80% H 2 O.  Many biological processes require H 2 O › Survive days.

Physical vs. Chemical. Physical Property: A Feature of a material that can be observed or measured without changing the composition of the material –Ex:

The properties of water Life depends on them!. Water is polar Covalent bond.

Macroscopic assembled, ultrastrong and H 2 SO 4 - resistant fibers of polymer-grafted graphene oxide Xiaoli Zhao and Chao Gao* Introduction A.

Scrubbers Colloquium N. Maximova and the class. Puu

Ready-to-Use Consumables for Laboratory Filtration Lab Products & Services Filtration Devices.

1 Chapter 10 States of Matter. Essential Question What are physical & chemical properties of liquids and solids? Standard 2h Students will identify solids.

Matter: Chapter 2 Lesson 3: What are mixtures?. A mixture is a combination of two or more substances. Substances in a mixture can be separated. This means.

© 2015 Carl Lund, all rights reserved A First Course on Kinetics and Reaction Engineering Class 35.

Vocabulary Set #1. Condensation the process of changing from a gas to a liquid.

8.4: Earth’s Layered Structure

Chemical Layers of the Earth page 91. Remember when the Earth was molten? …

1 1. What is Sterilization? 2. Type of Sterilization Methods. 3. What is ETO Sterilization? 4. Why & where ETO Sterilization used? 5. Fact about ETO.

PROPERTIES OF WATER waterwiseeducation.org/.../power points/MRCWaterWalk_waterpro pertiesqu...

Chapter 6 Reverse Osmosis and Nanofiltration

ALPOLEN® ‐ UMWH 1000 & ALPOLEN® ‐ HMW 500 Diversity.

Integrating extraction and stirring in microextraction techniques R. Lucena Analytical Chemistry Department, University of Córdoba, Spain.

WP 6A Existing/potential industrial symbioses

Water Properties.

SEPABEADS FUNCTIONALISED POLYMERS FOR CHROMATOGRAPHY

SEDIMENTATION 9/11/2018.

Mentioned in the operator manual B lower pump

NTI Nanotech International

Chapter 3: Water and the Fitness of the Environment

Cell Transport.

Maintenance Aerosols & Liquids

Axalta™ Coating Systems Precidium™ Flooring Systems

Chemical Vapor Deposition Design and Synthesis of Polymers

Mechanical Separation

Immobilized Enzyme Systems

Yongtaek Lee, Ph.D., Professor

Chapter 10 States of Matter & Water Cycle

Separation Techniques

Semi-Permanent Release Agents for Silicone Rubber

Presentation transcript:

Eclipse® Membrane Modules Potted bundle PTFE Dead end and Cross Flow Small Fiber Filtration Modules (Type I) Center Core MD, OMD, Degassing, Gas/liquid contacting modules (Type II) · Enables both high operating temperatures (85°C ) and cleaning cycles · Chemically resistant to the most aggressive cleaning systems including strong alkali, organic solvents, acids and ozone cleaning agents. · Low leachables extractables · Fiber design tailored to process stream, solids · High fiber packing density maximizes surface area of module. · More robust than alternative polymeric membranes · Enables both high temperature operations (85°C ) and cleaning cycles · Chemically resistant to the most aggressive cleaning systems including strong alkali, acids, organic solvents and ozone cleaning agents. · Low leachables extractables · Hydrophobic membrane maximizes performance and enhances economics · Design flexibility in wetted parts construction allows tailoring to specific process needs · Most robust polymeric membrane High Solids Cross Flow Filtration Modules (Type III) Membrane Liquid Extraction Modules (Type IV) Pin/Tubesheet PTFE · Enables highest operating temperatures of any polymeric membrane module. · Chemically resistant to the most aggressive cleaning systems including strong alkali, acids, organic solvents, and ozone cleaning agents. · No leachables extractables · Longer life than alternative polymeric membranes and lower cost than ceramics · Lumen diameter adjusted to solids level providing optimal process flexibility · Individual fibers can easily be replaced with minimal downtime. · Enables highest operating temperatures of any polymeric membrane module. · Chemically resistant to the most aggressive cleaning systems including strong alkali, acids, organic solvents, and ozone cleaning agents. · No leachables extractables · Monolithic membrane structure that is tough and abrasion resistant results in longer life than alternative polymeric membranes · Lumen sized to accommodate solids levels and flow patterns Individual fibers can easily be replaced with minimal downtime. · Filtration Separation