Making) LED table lamp.

Slides:

Advertisements

Similar presentations

Simple Electric Circuits Click to start Question 1 This circuit is…. A parallel circuit with both lamps OFF A parallel circuit with both lamps ON A series.

Advertisements

Connecting Your Computer Monitor Cable Electrical power for monitor.

Switches, Pushbuttons, and LEDs Digilent Spartan 3 Board Lecture L2.1.

1 times table 2 times table 3 times table 4 times table 5 times table

Image of Arduino. Arduino discussion Address issues with circuit walk-through – Electricity, Programming, Arduino Concepts Work on BeatTable (next week)

A Simple Tour of the MSP430. Light LEDs in C LEDs can be connected in two standard ways. Active high circuit, the LED illuminates if the pin is driven.

NPN Foundations of Technology NPN © 2013 International Technology and Engineering Educators Association, STEM  Center for Teaching and Learning™ Foundations.

Build a track for the ‘train’ to go back and forth across. It should switch directions after a set amount of time.

310 Series Basic Leveling Procedure

Logarithms Definition Graphing. What’s a Log? the logarithm of a number to a given base is the power or exponent to which the base must be raised in order.

How an NPN Transistor Works

Announcements To join clicker to class today: – Turn on the Clicker (the red LED comes on). – Push “Join” button followed by “20” followed by the “Send”

This game made with EmanE Games Start the presentation to play the game Games emanegames.ga Release 3.

1 - Remove LED from 13 and GND - Bring out your breadboard from HW#4 Arduino Overview:

Electronics Investigation Investigation 1. Circuits Flow of electricity is current Current flows in a circuit Flows in one direction Closed = complete.

$100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300.

Tables Learning Support

On the screens click on the number you think is the right answer. Three times tables Good luck!

Lab Components and Breakouts TYWu. Basic Components Arduino UNO12 unitsR3: 7 units, Others: 5 units Breadboard12 unitsL: 9 units, S: 3units Dupont Wire2.

AND Gate Inputs Output Input A (Switch) Input B (Switch) Output Y (Lamp) 0 (Open) 0 (OFF) A B Lamp.

Hubble Sight/Insight: Color the Universe Activity 4: Cooking with Color.

Find the words that rhyme with... When you think you have found them all, click to go on.

ISA CLICK CONTROL #38 – FALL 2014 ERIC BRUNNGRABER DRAKE ISABIRYE.

1 Transistor. 2 Transistors are used to turn components on and off They come in all different shapes and sizes.

SETTING UP NEW PROJECT IN CUBASE – (I’VE USED CUBASE BEFORE) MUSIC TECH.

Starter: use Pg to complete the table

Resistors How can we intentionally change the amount of resistance in our circuit?

Four push-button wall panel remote.

Lab02 :Logic Gate Fundamentals:

Wireless 3 Buttons Touch Panel

Light bulbs investigation Light bulbs investigation

HOW TO RESET BROTHER PRINTER HL 2250DN Quick step up Guide to reset your Brother Printer HL 2250DN

Call to Fix Canon Pixma MX340 printer Error 5200

Pushbutton Piano using an Arduino Redboard

Chapter 2 Push button and Potentiometer

सोलर पॅनेलचा उपयोग करुन रीचर्जेबल टॉर्च बनवणे.

Match the circuit symbols How many of these can you name?

Transformation of Energy Digestion Lab Lab Quest Directions

CS-4540 Robotics - Lab 05 Switch inputs to the Arduino Uno

LIGHTING OVEN Steps to Follow.

Basic circuits Electrical circuits Electrical properties Ohm’s law

Chapter 1 Introduction of Arduino

Sensors and actuators Sensors Resistive sensors

Electrical Quantities

PowerPoint Triggers ICTGAMES.TK Previous Next.

1 To go to the next slide, click this button instead. A random slide will come up.

micro:bit for primary schools – mb4ps.co.uk

How an NPN Transistor Works

Term Project: Poker Game

310 Series Basic Leveling Procedure

LED and a Button.

Lab 1 Components List.

Making) Melody timer.

Click Summary Value Button to Show Source of Integral or Time

CLICK TO START.

2. ATP INITIALIZATION PLACE ATP SWITCH TO “1” OR “NORMAL” POSITION A

Arduino Uno circuit basics

3 times tables.

6 times tables.

CLICK TO START.

Logarithms Definition Graphing.

How well do you KNOW your 2 times table ?

Logic Gates and Memory.

Call Now : Click : -

Call Now : Click : -

Call Now : Click : -

Presentation transcript:

Making) LED table lamp

LED table lamp Get your Arduino ready with four white LED and a push button. You are making an LED table lamp with four LEDs. You will have to find appropriate resistors. Your push button is a switch that controls the brightness of the lamp. Clicking on the push button should increase the number of turned-on LEDs by 01234. When all four LEDs are on, clicking the push button will turn them all. The push button should respond only when its status changes from RELEASED to PUSHED.