Point (Datum Point Tool) Create a point on a corner. Create a point on an edge/line. Create a point by using sketch Create a point by using offset coordinate system

Create a point on a corner To create a point: Click Point -> Select a reference corner by click on it ->OK Note: Turn on/off the switch to show the point

Create a point on an edge/line To create a point: Click Point -> Select a reference edge/line by click on it -> change Offset ->OK Note: Select Ratio & Real to see the difference, also check the Next End option

Create a point by using sketch To create a point: Click Sketch Point -> Select a reference plane to sketch -> draw a point -> give the exact position to the point ->OK

Using Offset Coordinate System To create a point: Click on Offset Coordinate System -> Select a reference Cartesian Coordinate System by click on it -> enter x, y, z values for the point you want to add into the pop out table ->OK

Exercise #1: Points, Curve & Sweep

Exercise #2: Point & Reference Pattern