xSpider DEMO – Simultaneous Factor and Parallel Sources Instructional animated presentation

During operational state „Normal“ parallel TRANSFORMERS are connected Parallel Generators Parallel Transformers FILE: Default State During operational state „Normal“ parallel TRANSFORMERS are connected Click for next slide

Parallel Transformers Because of more sources working parallel, network is evaluated as meshed network (regardless that entire load part is radial network) Click for next slide

In network nodes are SET Simultaneous Factors Click for next slide

Because of connected parallel transformers, Simultaneous factors are IGNORED Click for next slide

Sources are OVERLOADED FILE: Default State Sources are OVERLOADED Click for next slide

Switch to file „Virtual Sources“ Click for next slide

Default Sources Rated power of virtual source = TOTAL rated power of DEFAULT parallel sources Click for next slide

Network is RADIAL Click for next slide

In network nodes are SET Simultaneous Factors Click for next slide

Because of ONE virtual source, Simultaneous factors will NOT be ignored Click for next slide

The same concept shall be used to replace generators OK Source is not overloaded, because algorithm takes Simultaneous factors into account The same concept shall be used to replace generators Click for END

More information available at the address: www.xspider.eaton.eu xspider@eaton.com Eaton Industries (Austria) GmbH Scheydgasse 42, A-1215 Wien, Austria Tel.: +43 0 28 53 7 02-0