What is a beam antenna? A. An antenna built from aluminum I-beams

Slides:



Advertisements
Similar presentations
Amateur Radio Technician Class Element 2 Course Presentation
Advertisements

Technician Licensing Class “T9”
5 Foundation Course Feeders & Antennas EKRS KARL DAVIES 1.
1 Chelmsford Amateur Radio Society Foundation Licence Course Murray Niman G6JYB Slide Set 5: v1.2, 16-Dec-2007 (5) Feeders & Antennas Chelmsford Amateur.
1 Chelmsford Amateur Radio Society Intermediate Licence Course Carl Thomson G3PEM Slide Set 9: v1.2, 31-May-2009 Antennas & Feeders Chelmsford Amateur.
Bab: Antenna.
EMLAB 1 4. Linear wire antenna. EMLAB 2 Simulation of dipole antennas.
APRS ANTENNAS by ED LAWRENCE WA5SWD SIMPLIFIED & TRANSMISSION LINES.
Technician License Course Chapter 4 Lesson Plan Module 10 – Practical Antennas.
Foundation Licence Feeders and Antennas. What they do Feeder: transfers RF current between a transceiver and antenna without radiating radio waves. (Hope.
1 Chelmsford Amateur Radio Society M3 Foundation Licence Course Murray Niman G6JYB Slide Set 5 (5) Feeders & Antennas Chelmsford Amateur Radio Society.
Technician License Course Chapter 4 Propagation, Antennas and Feed Lines Lesson Plan Module 10: Practical Antennas.
Antenna & Feed Lines Chapter 2 Lesson 2.5. Antenna Basics Two basic types used by hams 1.Ground plane antenna: radiates a signal from the vertical wire.
Antennas.
Chapter 19: Antennas By: James VE3BUX. Definition The Modern Dictionary of Electronics defines an antenna as: That portion, usually wires or rods, of.
Chapter 6 Antennas Antenna Basics
ESTeem Training Class Antenna Fundamentals. Decibels (dB) Used for all mathematical calculations in the radio world. – dB is a logarithmic number dB =10.
Antenna Systems ARRL Book Section 3.2. Mobile Antennas Isotropic radiator sends radio energy out equally in all directions – may not always be what you.
Technician License Course Chapter 4 Lesson Plan Module 9 – Antenna Fundamentals, Feed Lines & SWR.
Technician License Class Gordon West Technician Class Manual Pages Antennas Presented by Heart Of Texas Amateur Radio Club (HOTARC)
Technician Licensing Class Antennas Section 18. Antennas T9A3 A simple dipole mounted so the conductor is parallel to the Earth's surface is a horizontally.
Antenna Types Dipole Folded Dipole Monopole
CHAPTER 8 ANTENNAS.
Technician Licensing Class Antennas Page 151 to 157.
General Licensing Class
Technician License Course Chapter 4 Lesson Plan Module 9 – Antenna Fundamentals, Feed Lines & SWR.
Technician Licensing Class Supplement T9, Questions Only Antennas, Feedlines 2 Exam Questions, 2 Groups.
General Licensing Class G9A – G9D Antennas Your organization and dates here.
Technician License Course Chapter 3 Operating Station Equipment Practical Antennas.
SUBELEMENT T9 Antennas and feed lines [2 Exam Questions - 2 Groups] 1Antennas & Feedlines 2014.
Simple radio communications system. Electric field around elements.
Technician License Course Chapter 4 Propagation, Antennas and Feed Lines Lesson Plan Module 10: Practical Antennas.
SUBELEMENT G9 ANTENNAS AND FEEDLINES [4 Exam Questions–4 Groups]
G9 - Antennas 1 G9 – Antennas and Feedlines [4 exam questions - 4 groups] G9A - Antenna feed lines: characteristic impedance and attenuation; SWR calculation,
Technician License Course Chapter 4 Lesson Plan Module 9 – Antenna Fundamentals, Feed Lines & SWR.
Technician Licensing Class Antennas Lake Area Radio Klub Spring 2012.
Technician Licensing Class
Part I: Dipoles by Marc C. Tarplee Ph.D. N4UFP
Hi-Landers Ham Class Instructed by Rich Bugarin W6EC.
1 Chelmsford Amateur Radio Society Intermediate Licence Course Carl Thomson G3PEM Slide Set 9 Antennas & Feeders Chelmsford Amateur Radio Society Intermediate.
Practice Questions 2015 General License Course. How does antenna gain stated in dBi compare to gain stated in dBd for the same antenna? A. dBi gain figures.
Moxon Beams Design & Building by WB5CXC 2006 Ham - Com.
Antenna Basics.
G9 - Antennas 1 G9 – Antennas and Feedlines [4 exam questions - 4 groups] G9A - Antenna feed lines: characteristic impedance and attenuation; SWR calculation,
Technician Licensing Class
Technician License Course Chapter 4
Technician License Course Module Eleven Operating Station Equipment
AMATEUR RADIO TRAINING
Basic Electricity Circuits
AMATEUR RADIO TRAINING
Chapter 7 Antennas Antennas Jim Siemons, AF6PU.
Technician License Course Chapter 4
Antennas 10/18/2017.
Technician Licensing Class
Vertical Antenna Myths
Antennas with Loads and Traps – What are these things and why are they used in our antennas? By: Dave Brown K3CTN.
Antennas.
Amateur Extra Q & A Study Pool
Technician License Course Chapter 4
Technician Licensing Class
Technician Licensing Class
Ham ANTENNAS: A practical introduction to The THEORY AND operation
CHAPTER 8 ANTENNAS.
Technician License Course Chapter 4
Before You Start To be able to properly view this PowerPoint you have to be in Slide Show mode. If all you see is this slide you should be all ready to.
Visit for more Learning Resources
WELCOME.
Technician License Course Chapter 4
Propagation, Antennas and Feed Lines American Radio Relay League
Presentation transcript:

What is a beam antenna? A. An antenna built from aluminum I-beams B. An omnidirectional antenna invented by Clarence Beam C. An antenna that concentrates signals in one direction D. An antenna that reverses the phase of received signals T9A01 HRLM (4 - 16)

What is a beam antenna? A. An antenna built from aluminum I-beams B. An omnidirectional antenna invented by Clarence Beam C. An antenna that concentrates signals in one direction D. An antenna that reverses the phase of received signals (C) T9A01 HRLM (4 - 16)

Which of the following describes a type of antenna loading? A. Inserting an inductor in the radiating portion of the antenna to make it electrically longer B. Inserting a resistor in the radiating portion of the antenna to make it resonant C. Installing a spring in the base of a mobile vertical antenna to make it more flexible D. Strengthening the radiating elements of a beam antenna to better resist wind damage T9A02 HRLM (4 - 13)

Which of the following describes a type of antenna loading? A. Inserting an inductor in the radiating portion of the antenna to make it electrically longer B. Inserting a resistor in the radiating portion of the antenna to make it resonant C. Installing a spring in the base of a mobile vertical antenna to make it more flexible D. Strengthening the radiating elements of a beam antenna to better resist wind damage (A) T9A02 HRLM (4 - 13)

Which of the following describes a simple dipole oriented parallel to the Earth's surface? A. A ground-wave antenna B. A horizontally polarized antenna C. A rhombic antenna D. A vertically polarized antenna T9A03 HRLM (4 - 12)

Which of the following describes a simple dipole oriented parallel to the Earth's surface? A. A ground-wave antenna B. A horizontally polarized antenna C. A rhombic antenna D. A vertically polarized antenna (B) T9A03 HRLM (4 - 12)

What is a disadvantage of the “rubber duck” antenna supplied with most handheld radio transceivers when compared to a full-sized quarter-wave antenna? A. It does not transmit or receive as effectively B. It transmits only circularly polarized signals C. If the rubber end cap is lost, it will unravel very easily D. All of these choices are correct T9A04 HRLM (4 - 15)

What is a disadvantage of the “rubber duck” antenna supplied with most handheld radio transceivers when compared to a full-sized quarter-wave antenna? A. It does not transmit or receive as effectively B. It transmits only circularly polarized signals C. If the rubber end cap is lost, it will unravel very easily D. All of these choices are correct (A) T9A04 HRLM (4 - 15)

How would you change a dipole antenna to make it resonant on a higher frequency? A. Lengthen it B. Insert coils in series with radiating wires C. Shorten it D. Add capacitive loading to the ends of the radiating wires T9A05 HRLM (4 - 13)

How would you change a dipole antenna to make it resonant on a higher frequency? A. Lengthen it B. Insert coils in series with radiating wires C. Shorten it D. Add capacitive loading to the ends of the radiating wires (C) T9A05 HRLM (4 - 13)

What type of antennas are the quad, Yagi, and dish? A. Non-resonant antennas B. Log periodic antennas C. Directional antennas D. Isotropic antennas T9A06 HRLM (4 - 16)

What type of antennas are the quad, Yagi, and dish? A. Non-resonant antennas B. Log periodic antennas C. Directional antennas D. Isotropic antennas (C) T9A06 HRLM (4 - 16)

What is a disadvantage of using a handheld VHF transceiver, with its integral antenna, inside a vehicle? A. Signals might not propagate well due to the shielding effect of the vehicle B. It might cause the transceiver to overheat C. The SWR might decrease, decreasing the signal strength D. All of these choices are correct T9A07 HRLM (4 - 15)

What is a disadvantage of using a handheld VHF transceiver, with its integral antenna, inside a vehicle? A. Signals might not propagate well due to the shielding effect of the vehicle B. It might cause the transceiver to overheat C. The SWR might decrease, decreasing the signal strength D. All of these choices are correct (A) T9A07 HRLM (4 - 15)

What is the approximate length, in inches, of a quarter-wavelength vertical antenna for 146 MHz? B. 50 C. 19 D. 12 T9A08 HRLM (4 - 13)

What is the approximate length, in inches, of a quarter-wavelength vertical antenna for 146 MHz? B. 50 C. 19 D. 12 (C) T9A08 HRLM (4 - 13)

What is the approximate length, in inches, of a half-wavelength 6 meter dipole antenna? B. 50 C. 112 D. 236 T9A09 HRLM (4 - 13)

What is the approximate length, in inches, of a half-wavelength 6 meter dipole antenna? B. 50 C. 112 D. 236 (C) T9A09 HRLM (4 - 13)

In which direction does a half-wave dipole antenna radiate the strongest signal? A. Equally in all directions B. Off the ends of the antenna C. Broadside to the antenna D. In the direction of the feed line T9A10 HRLM (4 - 12)

In which direction does a half-wave dipole antenna radiate the strongest signal? A. Equally in all directions B. Off the ends of the antenna C. Broadside to the antenna D. In the direction of the feed line (C) T9A10 HRLM (4 - 12)

What is the gain of an antenna? A. The additional power that is added to the transmitter power B. The additional power that is lost in the antenna when transmitting on a higher frequency C. The increase in signal strength in a specified direction compared to a reference antenna D. The increase in impedance on receive or transmit compared to a reference antenna T9A11 HRLM (4 - 7)

What is the gain of an antenna? A. The additional power that is added to the transmitter power B. The additional power that is lost in the antenna when transmitting on a higher frequency C. The increase in signal strength in a specified direction compared to a reference antenna D. The increase in impedance on receive or transmit compared to a reference antenna (C) T9A11 HRLM (4 - 7)

What is an advantage of using a properly mounted 5/8 wavelength antenna for VHF or UHF mobile service? A. It has a lower radiation angle and more gain than a 1/4 wavelength antenna B. It has very high angle radiation for better communicating through a repeater C. It eliminates distortion caused by reflected signals D. It has 10 times the power gain of a 1/4 wavelength design T9A12 HRLM (4 - 12)

What is an advantage of using a properly mounted 5/8 wavelength antenna for VHF or UHF mobile service? A. It has a lower radiation angle and more gain than a 1/4 wavelength antenna B. It has very high angle radiation for better communicating through a repeater C. It eliminates distortion caused by reflected signals D. It has 10 times the power gain of a 1/4 wavelength design (A) T9A12 HRLM (4 - 12)