CAT5 cable Before: following Data sheet Fig2 : Bit Error rate 10^-6 for 100m cable (1) After : remove red circle as.

Slides:

Advertisements

Similar presentations

18 Bit ADC Status Collaboration meeting May 18, 2007.

Advertisements

Does each sentence begin with a capital letter? Underline the beginning letter of each sentence. Is there a. ! ? after each sentence? Circle the punctuation.

Operational Amplifiers

Fig. 4-1, p Fig. 4-2, p. 109 Fig. 4-3, p. 110.

Operational Amplifiers

Mains Supply Noadswood Science, 2012.

Handling Data Pie Charts Data (numbers) can be shown much more clearly using charts and graphs.

Combinational Logic and Verilog. XORs and XNORs XOR.

P.464. Table 13-1, p.465 Fig. 13-1, p.466 Fig. 13-2, p.467.

Fig. 11-1, p p. 360 Fig. 11-2, p. 361 Fig. 11-3, p. 361.

Table 6-1, p Fig. 6-1, p. 162 p. 163 Fig. 6-2, p. 164.

Learning Bit by Bit Clustering. Supervised vs. Unsupervised Training vs. Exploring.

Digital Circuit Why Digital Circuit? – Digital signals ( 0 and 1) are very easy to handle with electronic circuits only 2 states needed: Switch ON or OFF,

Adaptive Integrated Microsystems Example mid-term questions ECE 412 Algorithms of Circuit Design (Fall 2010) Class website:

Jumpering a New Line Providing a new line usually involves two jumpers, though some small exchanges may only require an MDF jumper. This page deals with.

Figure 1.1 The observer in the truck sees the ball move in a vertical path when thrown upward. (b) The Earth observer views the path of the ball as a parabola.

Figure 2. 1in X 1in, 2-layer FR4 capacitance test board (left) top view, (right) bottom view. Figure 1. Recommended test setup for measuring capacitance.

Alternating Current and RMS Derivation Whiteboards.

Circle Graphs Math 7. Things We Need To Know The inside of a circle has ___º. (this is 100% of the circle) Half the inside of a circle has ___ º. (this.

Do now! Can you spell the following words correctly in your book please? Elektricity, elektorns, curent, ameter, volttmeter He’s going to blow! Be careful.

1 Applied Control Systems Technology. 2 Pin configuration Applied Control Systems.

$100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300.

Unit 6 Lesson 1 An inequality is like an equation, but instead of an equal sign (=) it has one of these signs: < : less than ≤ : less than or equal to.

Aim of the lesson:Be able to approximate numbers to a given number of decimal places. ROUNDING BIRKDALE HIGH SCHOOL.

LKr Calorimeter Control and monitoring R. Fantechi 19/02/2010 R. Fantechi.

Series Current Series Voltage Drops In a series circuit the sum of the voltage drops across each resistor or device is equal to the potential difference.

Do now! Can you continue the sheet you started last lesson? (“Another current model”)

Reading Rhythm. A Circle the correct rhythm. Question 1 Which rhythm do you hear? B C.

Copyright Carnegie Mellon Robotics Academy all rights reserved Vex 1.0 © 2005 Carnegie Mellon Robotics Academy Inc. Multimeters Testing for continuity.

Series and Parallel Circuits. Learning Intentions – Today we will be… Developing our knowledge of series and parallel circuits I can set up a series circuit.

Today we are going to look at: Current: Measured in “Amperes” or “Amps” (A) “The rate of flow of electrons through a circuit” Voltage: Measured in “Volts”

Noise and Data Errors Nominal Observation for “1” Nominal Observation for “0” Probability density for “0” with Noise Probability density for “1” with Noise.

Wheatstone Bridge Circuits

TECH DEMO QUIZ sound. 1. How do we set the audio switches on the C100 camera to enable the on board mic to be activated?

Operational Amplifiers Chapter 10 Boylestad Electronic Devices and Circuit Theory.

UOP ECT 246 Week 3 iLab Op - Amps Check this A+ tutorial guideline at For more classes.

Warm up (9/13 and 14) x 1023 FIND YOUR NEW SEATS!

PUSAT PENGAJIAN KEJURUTERAAN KOMPUTER & PERHUBUNGAN

1. Make sure supply voltage is off, unplug the USB, and close the GUI.

SAR ADC Input Types TIPL 4003 TI Precision Labs – ADCs

Analogue Electronic 2 EMT 212

Electrical Conductivity Elementary Grade

Testing Validity With Venn Diagrams

Basic Digital Logic.

Is it no problem to use like that?

Quiz: Introduction to SAR ADC Component Selection TIPL 4401 TI Precision Labs – ADCs Hello, and welcome to the TI Precision Lab discussing input offset.

Ammeter and Voltmeter.

1. A 6 kg cat is running 4 m/s. What is the energy?

Programming Micro Controllers

Fractions 1/2 1/8 1/3 6/8 3/4.

Problems With Assistance Module 4 – Problem 2

Basic Electrical Calculations

Attribute Blocks Ring.

Round the following number to 1dp

Ammeter and Voltmeter.

Value to Make Ratios Equal

Problem 1 (20 points). There are four circuit elements shown in Figure 1. Use ALL FOUR circuit elements to construct a circuit in which the power absorbed.

Schematic to Pictorial

Arduino Part 4 Let there be more light.

examination of TUSB9261 recognition error additional test

Symmetry in Circles Isosceles triangles have two equal sides and two equal angles. e° f° b° 30° n° e = (180 – 30)°  2 m° a° 70° = 75° 110° a = 70°

A complete Jewellery shop Management Software Powered by :

Quiz: Introduction to SAR ADC Component Selection TIPL 4401 TI Precision Labs – ADCs Hello, and welcome to the TI Precision Lab discussing input offset.

Wireless Embedded Systems

DEMO-board schematic:

Be able to approximate numbers to a given number of decimal places.

Types of Errors And Error Analysis.

Presentation transcript:

CAT5 cable Before: following Data sheet Fig2 : Bit Error rate 10^-6 for 100m cable (1) After : remove red circle as DEMO-board(2) case : No error (1)In case ~10m , no problem even ‘ Before’ case (2)http://www.ti.com/lit/df/snlr010/snlr010.pdf

Before Vcm=3.3V After Vcm is ~ 1.5V As per customer, even tough ‘Before’ case, Peak to peak differential voltage , and its slew rate should be same , no deformation even though ‘ Before ‘ case. Question : Data sheet Fig6-2 is correct? Or DEMO-board(snlr010.odf is correct?) Customer think DP83816 has equalizer inside, so customer think it should be work with no-error even though ‘ Before’ case, but please advise customer’s corrective action is correctly or no. ( Customer don’t know internal bias of receiver circuit at TPRDP/DM, but he should follow data sheet as ‘Before’ case??)