The Electrochemical and Thermal Performances of Ca3Co4O9-δ as a cathode material for IT-SOFCs UCCS K. Nagasawaa, O. Mentreb, S. Daviero-Minaudb, N. Preuxb,

Slides:



Advertisements
Similar presentations
Ruizhen Li School of Chemistry and Environment South China Normal University Guangzhou China Study on Lead Based Rare Earth Alloys for Positive Grids of.
Advertisements

NPRE 498 Energy Storage Systems Garrett Gusloff 11/21/2014
Fig. 22-1a (p.629) A galvanic electrochemical cell at open circuit
Improving the electrolyte/ cathode assembly for advanced Solid Oxide Fuel Cells N. Hildenbrand, B.A. Boukamp, D.H.A. Blank (a) P. Nammensma, G. Rietveld.
We demonstrate the applicability of LAMOX oxide ion conductor as the electrolyte of single-chamber SOFC, using two compositions La 0.9 Dy 0.1 Mo 2 O 9.
Solid Oxide Fuel Cells Rodger McKain, PhD.
Lecture 6a Cyclic Voltammetry.
Electrochemistry in membrane fuel cells 1 Getting started with electrochemistry in polymer electrolyte membrane fuel cells (PEMFC): Francois Lapicque Laboratoire.
ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY (EIS): A TOOL FOR THE CHARACTERIZATION OF SPUTTERED NIOBIUM FILMS M. Musiani Istituto per l’Energetica e le Interfasi,
2 Section.
Electrochemical Cells
Crystal Structural Behavior of CoCu₂O₃ at High Temperatures April Jeffries*, Ravhi Kumar, and Andrew Cornelius *Department of Physics, State University.
M a t e r i a l s Swiss Federal Institute of Technology Zürich Nonmetallic Materials Brandon E. Bürgler Nonmetallic Inorganic Materials ETH Zürich Single.
Capacity Fade Studies of LiCoO 2 Based Li-ion Cells Cycled at Different Temperatures Bala S. Haran, P.Ramadass, Ralph E. White and Branko N. Popov Center.
Nanoscale Electrode Development for Fundamental Studies of Mixed Ionic and Electronic Conductors as High Temperature Fuel Cell Components Jeevitha Evanjeline.
Electrochemistry Chapter 20.
Summer Course on Exergy and Its Applications EXERGY ANALYSIS of FUEL CELLS C. Ozgur Colpan July 2-4, 2012 Osmaniye Korkut Ata Üniversitesi.
PREPARATION OF ZnO NANOWIRES BY ELECTROCHEMICAL DEPOSITION
Integrated Micropower Generator
Nelson Research, Inc – N. 88 th St. Seattle, WA USA aol.com Calculation of Internal Electrical Resistance and Power.
A study of Fe – substituted (La 0.8 Sr 0.2 ) 0.95 MnO 3-y as cathode material for solid oxide fuel cells B. N. Wani, Mrinal Pai, S.J. Patwe, S. Varma,
Chemical and Materials Engineering Department, University of Cincinnati, Cincinnati, OH Nanoscale Ni/NiO films for electrode and electrochemical Devices.
Chapter 17 Corrosion and Degradation of Materials.
Introduction to Electrochemical Impedance Spectroscopy (EIS)
SOLID OXIDE FUEL CELL BASED ON PROTON- CONDUCTING CERAMIC ELECTROLYTE* U. (Balu) Balachandran, T. H. Lee, and S. E. Dorris Argonne National Laboratory.
Integrated Micropower Generator Sossina M. Haile, Zongping Shao, Chan Kwak, Peter Babilo California Institute of Technology, Materials Science Micro- SOFC.
Salt Power Chloe Shreve and Helen Row.  It uses an electrochemical cell. In the cell there are anodes, cathodes and electrolytes that concert chemical.
In-situ Scanning Tunneling Microscopy Study of Bismuth Electrodeposition on Au(100) and Au(111) S.H. Zheng a, C.A. Jeffrey a,b, D.A. Harrington b E. Bohannan.
Ho-Gun Kim, Seung-Ho Ahn, Jung-Gu Kim, *Se-Jun Park, *Kwang-Ryol Lee, **Rizhi Wang SungKyunKwan University, Korea *Korea Institute of Science and Technology,
1 4.1 Introduction to CASTEP (1)  CASTEP is a state-of-the-art quantum mechanics-based program designed specifically for solid-state materials science.
2. Sample Structure Effect of sintering temperature on dielectric loss, conductivity relaxation process and activation energy in Ni 0.6 Zn 0.4 Fe 2 O 4.
Electrochemical Methods: Intro Electrochemistry Basics Electrochemical Cells The Nernst Equation Activity Reference Electrodes (S.H.E) Standard Potentials.
Production of NTCR Thermistor Devices based on NiMn2O4+d
KCS 2016 Multilevel Resistive Switching Memory based on Two-Dimensional (2D) Nanomaterials Gwang Hyuk Shin, Byung Chul Jang, Myung Hun Woo, and Sung-Yool.
Study on Double Perovskite as a Solid Oxide Regenerative Fuel Cell Cathode Material YoungJin Kwon† and Joongmyeon Bae (Dept. of Mechanical Engineering,
Date of download: 10/15/2017 Copyright © ASME. All rights reserved.
Lecture 7a Cyclic Voltammetry.
Basic Corrosion Theory
Chap.6 Fuel Cell modeling
M. Kanuchova1, M. Majoros2,J. Kanuch1,Y,Ding3, M. D. Sumption2, and E
Date of download: 10/27/2017 Copyright © ASME. All rights reserved.
Universidad Complutense de Madrid, Departamento Física Aplicada III
Date of download: 11/14/2017 Copyright © ASME. All rights reserved.
Date of download: 12/22/2017 Copyright © ASME. All rights reserved.
Centro de Investigación y de Estudios Avanzados del Institúto Politécnico Nacional (Cinvestav IPN) Palladium Nanoparticles Formation in Si Substrates from.
Fuel Cell Electric Prime Movers
Overview of Lithium-Air (Lithium-Oxygen) Batteries
Abstract Questions Results Methods & Materials A Learning Process
Advanced Higher Chemistry Unit 2(e)
Solar-Thermal Decoupled Electrolysis: Assessment of MnxOy Systems
Complex Anode Kinetics Chronocoulometry Evidence
The Role of Catalysis in Next Generation Direct Hydrocarbon Solid Oxide Fuel Cell Anodes Steven McIntosh, Department of Chemical Engineering, University.
The Role of Catalysis in Next Generation Direct Hydrocarbon Solid Oxide Fuel Cell Anodes Steven McIntosh, Department of Chemical Engineering, University.
K. Nagasawa1), O. Mentré2), S. Daviero-Minaud2),
Areum Jeong1 , Jaeyeung Song1 , Jin Hyun Nam2*, Charn-Jung Kim1
Crystal structure, electric and magnetic properties in NaxCoO2
H.Nakatsugawa1), K.Nagasawa1) and Y.Okamoto2)
The Effectiveness Model for Electrochemical Reaction in SOFCs and Explanation of Its Physical Implication Dongwoo Shin1 , Jin Hyun Nam2,* , Charn-Jung.
High temperature p - type and n - type thermoelectric properties of Pr1-xSrxFeO3 (0.1≦x≦0.9) Hiroshi Nakatsugawa 1,*, Itsuki Ishikawa 1, Miwa Saito 2,
Crystal structure, electric and magnetic properties in NaxCoO2
H.Nakatsugawa1), K.Nagasawa1) and Y.Okamoto2)
K.Nagasawa1), H.Nakatsugawa1) and Y.Okamoto2)
Masaki Kubota, Yosuke Watanabe, Hiroshi Nakatsugawa
An Effectiveness Model for Predicting
Ionic liquid gating of VO2 with a hBN interfacial barrier
Themoelectric properties of Pb and Sr doped Ca3Co4O9
Dielectric studies and ac conductivity of terbium fumarate heptahydrate single crystals. Dr. M.D.Shah Deptt. of Physics GDC Tral.
Chemo-Mechanical Challenges in Solid-State Batteries
Three-dimensional graphene/Pt nanoparticle composites as freestanding anode for enhancing performance of microbial fuel cells by Shenlong Zhao, Yuchen.
Superlattices of Perovskite Structured Materials for Solid Oxide Fuel Cells Yayoi Takamura, Department of Chemical Engineering and Materials Science, UC.
Presentation transcript:

The Electrochemical and Thermal Performances of Ca3Co4O9-δ as a cathode material for IT-SOFCs UCCS K. Nagasawaa, O. Mentreb, S. Daviero-Minaudb, N. Preuxb, A. Rolleb, and H. Nakatsugawaa  a Graduate School of Engineering, Yokohama National University, 79-5 Tokiwadai, Hodogaya Word, Yokohama, Kanagawa, 240-8501, Japan b UCCS - Unite de Catalyse et de Chimie du Solide – UMR CNRS 8181, Ecole Nationale Superieure de Chimie de Lille, Batiment C7a – BP.90, 108, 59652, Villeneuve d'Ascq cedex, France Abstract Introduction Layered calcium cobalt oxide Ca3Co4O9-δ is most known for thermoelectric material due to the high figure of merit. From the oxygen deficient nature of the rock-salt layers and from the excellent electronic transport of similar [CoO2] layers, Ca3Co4O9-δ could be considered as a natural intergrowth between electronic and potential O2- conducting units. We surmise that this new candidate for IT-SOFC cathode is well from the point of view of electrochemistry, thermal expansion and chemical stability[1]. And finally, we proved the electrochemical power generation tests using Ca3Co4O9-δ cathode. [1] K.Nagasawa, S.Daviero-Minaud, N.Preux, A.Rolle, P.Roussel, H.Nakatsugawa, O.Mentré, Chemistry of Materials, (2009), in press. Fig.2. Crystal structure of Ca3Co4O9-δ. Fig.1. Construction of SOFC. Results and discussion -Chemical Reactivity- -Thermal Dilatometory- The comparison of TEC between electrode and electrolyte is constitutive attribute along with electrochemical properties. Figure 4 is shown the linear thermal expansion and TEC for Ca3Co4O9-δ. It yields TEC values of about 10.0-11.0×10-6 K-1 in the investigated region. On the other hand, TEC value for CGO electrolyte is 11-12.0×10-6. In fact, this apparently good mechanical compatibility is a contributing factor for IT-SOFC cathode application. Fig.3. X-ray diffraction pattern in reactivity tests. Fig.4. Liner thermal expansion and thermal expansion coefficient. We carried out preliminary chemical reactivity tests between layered Ca3Co4O9-δ and several electrolytes. Ca3Co4O9-δ. No impurity phase was observed between Ca3Co4O9-δ.and CGO electrolyte, confirming a good compatibility between them. -Impedance Spectra- -SEM Observations- Fig.6. Oxygen partial pressure dependence of impedance spectra of Ca3Co4O9-δ (a) and 30%CGO-Ca3Co4O9-δ (b) deposited CGO pellet. Fig.5. Scanning electron micrograph of cutting cross section (left) and surface (right) of cell. We carried out the impedance spectroscopy measurements for Ca3Co4O9-δ electrode deposited CGO electrolyte. Figure 6 shows Nyquist plots in dependence of several oxygen partial pressures or temperatures. In ambient air, the resulting ASR values are 3.0 and 24.5 Ωcm2 at 700 and 600 ºC respectively. Typical SEM image of the cross section is shown on Figure 5. It was observed that the adherence between the electrode and electrolyte is good without any evidence for surficial cracks. The porosity appears of medium quality. The thickness of cathode cross section is estimated to about 30-40 μm. Fig.7. Calculated activation energy. -Single Cell Power Generation Tests- We attempted the power generation tests using Ca3Co4O9-δ cathode, NiO-Gd0.1Ce0.9Ox anode and Ce0.9Gd0.1O1.95 electrolyte. Fabricated SOFC single cell showed values of 0.8-1.0[V] in open circuit voltage and demonstrated the generation of electricity as Ca3Co4O9-δ cathode material for SOFC. Furthermore, relatively low polarization resistance in electrode ware obtained. Fig.8. Power generation tests results. Open circuit voltage (left), I-V characteristics (middle), Impedance spectra (right). Conclusions Postscript These results are considered to apply for US patent now. We are looking for the US company that can make a license agreement with us. If you have an interest in this matter, please contact following address. naka@ynu.ac.jp -Good chemical compatibility with CGO (TEC, Chemical reactivity). -Good adherence between electrode and electrolyte, no crack surface. -Relatively Low ASR value of Ca3Co4O9 and 30%CGO-Ca3Co4O9 cell. -Proof of power generation in SOFC single cell using Ca3Co4O9-δ cathode.