OBEDIENCE SIN SIN Plinko-Type Board GOD’S WILL The board could be a piece of plywood (about 4 ft tall and 3 ft wide) with a stand to prop it up at a 60 degree or 70 degree angle to the ground. In the center of the board, paint a (white) eight-inch stripe running from the top to the bottom. In big, block letters, it should say “OBEDIENCE” (going from the bottom to the top). Along the very bottom of the board should be a painted six-inch stripe (red) on each side of the “OBEDIENCE” stripe that says, “SIN” in bold, block letters. At the bottom, in the white, OBEDIENCE stripe, should be the words, “GOD’S WILL.” Everywhere on the board should be screws or nails or dowels that will change the direction of the Plinko disk as it falls to the bottom. These should be 3.5-4 inches apart from each other and staggered (like how you would arrange bricks in a wall). The board will need borders along the sides and the bottom, and these should be about two inches tall. Finally, you will need a clear, plastic shield to cover the top of the board and keep the Plinko disks from falling out. (I used two plastic picture frame covers.) Kids will place the Plinko disk at the top of the board and allow it to fall through the screws/nails until it reaches the bottom. The screws/nails represent choices, and only some choices are “OBEDIENCE” to God. If they make other choices, it will lead them into SIN, but if they choose OBEDIENCE, it will lead them to GOD’S WILL. GOD’S WILL SIN SIN