Lecture 13 OUTLINE pn Junction Diodes (cont’d) Charge control model

Slides:



Advertisements
Similar presentations
Chapter 6-1. PN-junction diode: I-V characteristics
Advertisements

Lecture 14 OUTLINE pn Junction Diodes (cont’d)
Semiconductor Device Physics Lecture 8 PN Junction Diodes: I-V Characteristics Dr. Gaurav Trivedi, EEE Department, IIT Guwahati.
Lecture 5 OUTLINE PN Junction Diodes I/V Capacitance Reverse Breakdown
PN Junction Diodes.
Spring 2007EE130 Lecture 20, Slide 1 Lecture #20 OUTLINE pn Junctions (cont’d) – small-signal model – transient response turn-off Reading: Chapters 7,
Department of Aeronautics and Astronautics NCKU Nano and MEMS Technology LAB. 1 Chapter IV June 14, 2015June 14, 2015June 14, 2015 P-n Junction.
OUTLINE pn junction I-V characteristics Reading: Chapter 6.1
Spring 2007EE130 Lecture 19, Slide 1 Lecture #19 OUTLINE pn junctions (cont’d) – Charge control model Reading: Finish Chapter 6.3.
EE105 Fall 2011Lecture 3, Slide 1Prof. Salahuddin, UC Berkeley Lecture 3 OUTLINE Semiconductor Basics (cont’d) – Carrier drift and diffusion PN Junction.
Spring 2007EE130 Lecture 17, Slide 1 Lecture #17 OUTLINE pn junctions (cont’d) – Reverse bias current – Reverse-bias breakdown Reading: Chapter 6.2.
Example 5-3 Find an expression for the electron current in the n-type material of a forward-biased p-n junction.
Lecture 13 OUTLINE pn Junction Diodes (cont’d) Charge control model
EE130/230A Discussion 7 Peng Zheng.
Lecture 9 OUTLINE pn Junction Diodes – Electrostatics (step junction) Reading: Pierret 5; Hu
EE130/230A Discussion 14 Peng Zheng.
Empirical Observations of VBR
President UniversityErwin SitompulSDP 8/1 Lecture 8 Semiconductor Device Physics Dr.-Ing. Erwin Sitompul President University
EE130/230A Discussion 6 Peng Zheng.
Lecture 14 OUTLINE pn Junction Diodes (cont’d) – Transient response: turn-on – Summary of important concepts – Diode applications Varactor diodes Tunnel.
Lecture 14 OUTLINE pn Junction Diodes (cont’d)
Lecture 11 OUTLINE pn Junction Diodes (cont’d) – Narrow-base diode – Junction breakdown Reading: Pierret 6.3.2, 6.2.2; Hu 4.5.
Lecture 14 OUTLINE pn Junction Diodes (cont’d)
Lecture 12 OUTLINE pn Junction Diodes (cont’d) Junction breakdown
PN-junction diode: I-V characteristics
ECE 333 Linear Electronics
Chapter 6. pn Junction Diode
Lecture 8 OUTLINE Metal-Semiconductor Contacts (cont’d)
Lecture 25 OUTLINE The Bipolar Junction Transistor Introduction
Lecture 10 OUTLINE pn Junction Diodes (cont’d)
Lecture 10 OUTLINE pn Junction Diodes (cont’d)
Lecture 13 OUTLINE pn Junction Diodes (cont’d) Charge control model
Lecture 27 OUTLINE The BJT (cont’d) Breakdown mechanisms
Professor Ronald L. Carter
BJT Static Characteristics
Lecture #12 OUTLINE Metal-semiconductor contacts (cont.)
Quasi-Fermi Levels The equilibrium EF is split into the quasi-Fermi
Lecture 27 OUTLINE The BJT (cont’d) Breakdown mechanisms
Lecture 8 OUTLINE Metal-Semiconductor Contacts (cont’d)
Lecture #17 OUTLINE pn junctions (cont’d) Reverse bias current
Lecture #21 ANNOUNCEMENTS No coffee hour today 
Lecture 26 OUTLINE The BJT (cont’d) Ideal transistor analysis
Lecture 28 OUTLINE The BJT (cont’d) Small-signal model
EE130/230A Discussion 5 Peng Zheng.
pn Junction Diodes: I-V Characteristics
Lecture 13 OUTLINE pn Junction Diodes (cont’d) Charge control model
Lecture #18 OUTLINE pn junctions (cont’d)
Deviations from the Ideal I-V Behavior
Lecture 11 OUTLINE pn Junction Diodes (cont’d) Narrow-base diode
pn Junction Electrostatics
Lecture 25 OUTLINE The Bipolar Junction Transistor Introduction
Chapter 1 – Semiconductor Devices – Part 2
Physics of Bipolar Junction Transistor
Lecture 25 OUTLINE The BJT (cont’d) Ideal transistor analysis
pn Junction Electrostatics
Lecture 10 OUTLINE pn Junction Diodes (cont’d)
Lecture 25 OUTLINE The BJT (cont’d) Ideal transistor analysis
Lecture 3 OUTLINE Semiconductor Basics (cont’d) PN Junction Diodes
Lecture 11 OUTLINE pn Junction Diodes (cont’d) Narrow-base diode
Lecture 10 OUTLINE pn Junction Diodes (cont’d)
Lecture 9 OUTLINE pn Junction Diodes Electrostatics (step junction)
Lecture 26 OUTLINE The BJT (cont’d) Ideal transistor analysis
BJT Static Characteristics
Lecture 12 OUTLINE pn Junction Diodes (cont’d)
Lecture 11 OUTLINE pn Junction Diodes (cont’d) Narrow-base diode
Lecture 10 OUTLINE pn Junction Diodes (cont’d)
Lecture 12 OUTLINE pn Junction Diodes (cont’d)
Lecture 12 OUTLINE pn Junction Diodes (cont’d) Junction breakdown
Lecture 9 OUTLINE pn Junction Diodes Electrostatics (step junction)
Lecture 9 OUTLINE pn Junction Diodes Electrostatics (step junction)
Presentation transcript:

Lecture 13 OUTLINE pn Junction Diodes (cont’d) Charge control model Small-signal model Transient response: turn-off Reading: Pierret 6.3.1, 7, 8.1; Hu 4.4, 4.10-4.11

Minority-Carrier Charge Storage Under forward bias (VA > 0), excess minority carriers are stored in the quasi-neutral regions of a pn junction: EE130/230A Fall 2013 Lecture 13, Slide 2

Derivation of Charge Control Model Consider the n quasi-neutral region of a forward-biased pn junction: The minority carrier diffusion equation is (assuming GL=0): Since the electric field is very small, Therefore EE130/230A Fall 2013 Lecture 13, Slide 3

Derivation Assuming a Long Base Integrating over the n quasi-neutral region: Note that So EE130/230A Fall 2013 Lecture 13, Slide 4

Charge Control Model We can calculate pn-junction current in 2 ways: From slopes of np(-xp) and pn(xn) From steady-state charges QN, QP stored in each excess-minority-charge distribution: EE130/230A Fall 2013 Lecture 13, Slide 5

Charge Control Model for Narrow Base For a narrow-base diode, replace tp and/or tn by the minority-carrier transit time ttr time required for minority carrier to travel across the quasi-neutral region For holes in narrow n-side: Similarly, for electrons in narrow p-side: EE130/230A Fall 2013 Lecture 13, Slide 6

Charge Control Model Summary Under forward bias, minority-carrier charge is stored in the quasi-neutral regions of a pn diode. Long base: Narrow base: EE130/230A Fall 2013 Lecture 13, Slide 7

The steady-state diode current can be viewed as the charge supply required to compensate for charge loss via recombination (for long base) or collection at the contacts (for narrow base). Long base (both sides): Narrow base (both sides): where and Note that EE130/230A Fall 2013 Lecture 13, Slide 8

Small-Signal Model of the Diode + v  Small-signal conductance: EE130/230A Fall 2013 Lecture 13, Slide 9

Charge Storage in pn Junction Diode Excess minority carriers in the quasi-neutral region: Majority carriers stored at the edges of the depletion regions: Dnp(x) Dpn(x) x -xp xn r(x) -xp x xn EE130/230A Fall 2013 Lecture 13, Slide 10

pn Junction Small-Signal Capacitance 2 types of capacitance associated with a pn junction: depletion capacitance due to variation of depletion charge diffusion capacitance due to variation of stored minority charge in the quasi-neutral regions For a one-sided p+n junction Q = QP + QN  QP so EE130/230A Fall 2013 Lecture 13, Slide 11

Depletion Capacitance C. C. Hu, Modern Semiconductor Devices for ICs, Figure 4-8 What are three ways to reduce CJ? EE130/230A Fall 2013 Lecture 13, Slide 12

Total pn-Junction Capacitance C = CD + CJ CD dominates at moderate to high forward biases CJ dominates at low forward biases, reverse biases EE130/230A Fall 2013 Lecture 13, Slide 13

Using C-V Data to Determine Doping EE130/230A Fall 2013 Lecture 13, Slide 14

Example If the slope of the (1/C)2 vs. VA characteristic is -2x1023 F-2 V-1, the intercept is 0.84V, and A is 1 mm2, find the dopant concentration Nl on the more lightly doped side and the dopant concentration Nh on the more heavily doped side. Solution: EE130/230A Fall 2013 Lecture 13, Slide 15

Small-Signal Model Summary Depletion capacitance Conductance Diffusion capacitance R. F. Pierret, Semiconductor Device Fundamentals, p. 302 EE130/230A Fall 2013 Lecture 13, Slide 16

Transient Response of pn Diode Suppose a pn-diode is forward biased, then suddenly turned off at time t = 0. Because of CD, the voltage across the pn junction depletion region cannot be changed instantaneously. The time delay in switching between the FORWARD-bias and REVERSE-bias states is due to the time required to change the amount of excess minority carriers stored in the quasi-neutral regions. EE130/230A Fall 2013 Lecture 13, Slide 17 R. F. Pierret, Semiconductor Device Fundamentals, Fig. 8.2

Turn-Off Transient In order to turn the diode off, the excess minority carriers must be removed by net carrier flow out of the quasi-neutral regions and/or recombination Carrier flow is limited by the switching circuitry R. F. Pierret, Semiconductor Device Fundamentals, p. 328 EE130/230A Fall 2013 Lecture 13, Slide 18

Decay of Stored Charge Consider a p+n diode (Qp >> Qn): Dpn(x) i(t) ts t vA(t) R. F. Pierret, Semiconductor Device Fundamentals, Fig. 8.3 t For t > 0: ts EE130/230A Fall 2013 Lecture 13, Slide 19

Storage Delay Time, ts ts is the primary “figure of merit” used to characterize the transient response of pn junction diodes By separation of variables and integration from t = 0+ to t = ts, noting that and making the approximation We conclude that EE130/230A Fall 2013 Lecture 13, Slide 20

Qualitative Examples Illustrate how the turn-off transient response would change: Increase IF Increase IR Decrease tp i(t) i(t) i(t) ts ts ts t t t EE130/230A Fall 2013 Lecture 13, Slide 21