Table 1. Iterative calculation procedure, M is standard at 25°C

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

Table 1. The analytical and physical data for the complexes

Chauveteau 1982 [49], Berry & Russell 1987 [50]

Percentage of Polyethylene

Properties Test results

Intermediate-level learner

Table 1. Empirical MSE to estimate the CP distribution parameter λ

phosphate- buffered saline pH 7.4

Research, 2015, Vol. 3, No. 6, doi: /education

Fusion temperature range Clinical Applications

Table 1. Structural Form Parameter Estimates of inflation rate

NbB2 and TaB2 compounds at room temperature

Tensile Strength (MPa)

SON Nurse Practitioner Blackboard Community

Tensile Test after Firing

© The Author(s) Published by Science and Education Publishing.

Management Philosophy

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Table 6. Control sample industry distribution

Age-sex literacy rates by various surveys.

Table 1. The radial spheroidal functions

Year range Rainfall (mm) ∆s in rainfall Temp (°C) ∆s in temp RH (mm)

Age-sex employments by various surveys.

Test Mean Std. Dev. Mathematics English Language

© The Author(s) Published by Science and Education Publishing.

Table 3. Summary of Intrinsic Viscosity Data

© The Author(s) Published by Science and Education Publishing.

Rating of Water Quality

% of inhibition of hydrolysis (INH)

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Number of categories that are mentioned (0% < categories < 5%)

Table 2. Modal parameters estimated by Pulse Reflex®

Entrapment Efficiency (%) ± S.D.

Interpass temperature

Simulation Frequency(Hz)

Number of questionnaires sent out

© The Author(s) Published by Science and Education Publishing.

Table 1. Descriptive Statistics

Table 6. The effect of porosity on pore velocity

Table 2. SUMMARIZED OBSERVATIONS FROM MODEL ANALYSIS

Table 1. Measurements of LEDs

© The Author(s) Published by Science and Education Publishing.

Source of variation Degrees of freedom Sum of squares Mean square

Electrode ν (mm/s) I (A) V (V) HI (J/mm) HI average AWS E309L

© The Author(s) Published by Science and Education Publishing.

Cumulative Percentage

Cumulative Percentage

Curve No Width of patch (W) Length of patch (L) RL Freq. Range

Control Valve Tag Number

Table 3. Correlation of PC, MC, RC & IC at the Supervisory level

chemistry that are involved in peer group

Table 5. Water quality A3 well during pumping test

Category Quantity Secondary school 3 Student participant

Solid-liquid ratio (B)

Dielectric strength(kV)

Table 1. Classification of plastics

Table 4. Value creation (Y2)

20 %(v/v) Aqueous Methanol Systems

Table 2. Summary of the Solubility Parameters for the Solvents

© The Author(s) Published by Science and Education Publishing.

Table 1. Summary of Physical Properties for the Solvents

Table 6. Twisting moment of counter shaft at different torques

© The Author(s) Published by Science and Education Publishing.

Table 4. Formation of mixes

Average Execution Time in seconds

Equation Tem. (°C) Specific heat Thermal conductivity

© The Author(s) Published by Science and Education Publishing.

Education, 2016, Vol. 4, No. 1, doi: /wjce-4-1-4

Presentation transcript:

Table 1. Iterative calculation procedure, M is standard at 25°C [η]1 k1 a1 M1 M1 RE%<5% M k1i a1i M1i “ k1ii a1ii M1ii k1i… a1i… M1i… M1i… RE%<1% M T2 [η]2 k2 a2 M2 M2 RE%<5% M k2i a2i M2i k2ii a2ii M2ii k2i… a2i… M2i… M2i… RE%<1% M Martin Alberto Masuelli et al. Mark-Houwink Parameters for Aqueous-Soluble Polymers and Biopolymers at Various Temperatures. Journal of Polymer and Biopolymer Physics Chemistry, 2014, Vol. 2, No. 2, 37-43. doi:10.12691/jpbpc-2-2-2 © The Author(s) 2014. Published by Science and Education Publishing.