How to output NW camera picture to external monitor. Step 1 Setting to connect NW camera. Access to the center module via network. Access to the center module from Web browser. Input “http://XXX” (XXX means IP address of the center module) in address bar. Default settings of center module is below. IP Address : 192.168.0.50 Subnet Mask : 255.255.255.0 Default Gateway : 192.168.0.1 # You can check IP address of the center module on LCD　(Push 　　　　　 and push “System Info” tab). Login to the center module. When accessed to the center module, login window shows up. Then Input User ID and Password, and push OK button. Default account is below. User ID : admin Password : 12345 Move to NW Camera setting screen. After login, top screen shows up. To move to NW camera setting screen, push “Installation” button, and “Camera” tab. User ID Password Push “Camera” tab Push “Installation” Button

How to output NW camera picture to external monitor. Input NW camera settings to connect. Input IP address and port number of NW camera. If there is authentication settings on NW camera, need to set “Authentication” to ON, and input “User name” and “User password” After input, push “Set” button. Settings to connect NW Camera (default settings) is below. IP address : 192.168.0.10 Port number : 80 Authentication : OFF If you want to connect more NW cameras, repeat No.4 operation to “Camera *”(* : 2 - 4). Show picture of NW camera on LCD. Push button on the center module. If setting of No.4 operation is correct, picture of NW camera is displayed on LCD. Input IP address of NW camera Input port number of NW camera Input authentication information regarding as NW camera After input settings, push “Set” button. Push button.

How to output NW camera picture to external monitor. Step 2 Setting to output NW camera picture to external monitor. Necessities PC with Terminal software Interface cable for DWCS2 External monitor NTSC cable Connect the center module to PC and external monitor. Connect the center module to PC and external monitor as below. And power on the Center module. PC External Monitor RS-232C Interface cable for DWCS2 NTSC cable

How to output NW camera picture to external monitor. Set terminal software on PC. Start terminal soft and set as below. Speed : 19200bps Data bit : 8bit Parity bit : none Stop bit : 1bit Operation on terminal software. After setting, push “ESC” key on terminal software. Then shows prompt “A:>” on terminal software. Enter the command to enable output to external monitor. Enter the command “$PSV1;1” and push “Enter” key on terminal soft. If the command is succeeded, the center module returns “$CKV1;OK”. Restart the center module. NW camera picture has been displayed on external monitor.