N u c o r h i g h w a y.com Nucor Steel Marion, Inc. TL 3 System 4400 lb Pickup Truck 1800 lb Small Car Impacting at 62 mph 25 degrees.

Slides:



Advertisements
Similar presentations
HAND AND POWER TOOLS.
Advertisements

Fundamentals of Engineering
As a stand-alone overview of test tools.
Selling Inoculants Module One – How are your Cows?
AUTOMOTIVE FASTENERS.
Getting there in comfort
Multiplication Facts Review. 6 x 4 = 24 5 x 5 = 25.
Roadside Barriers RDG Chapter 5.
Frigid Fridays On each Friday last January, the temperature was a record low temperature for the date. On Friday, January 30, the mercury dropped to 5°F,
27  9 =.
The Year 5/6 Science Quiz Part Two.
Aerospace Fastener Applications
The 5S numbers game..
Rule 3 The Network Marketing Mantra. You must do it And you will succeed 2.
High Cube Freight Car with Plug Doors Latching mechanism in place.
GOAL Access and Address Visibility. Trimming Around Driveway Grinding stumps after trees were cut down.
Ceramic Tile Installation Step 5 – Install Tile TNC EDUCATION SERVICES, INC Instructional Design and Learning Management.
Mechanical Division Standard Hand Tools. Topics Design T-Square Drafting Triangle Fabrication Hacksaw Cordless Drill File Sandpaper & Steel Wool Assembly.
Nucorhighway.com Nucor Steel Marion, Inc. What makes us special? Simple System Line Posts Cable Hook Bolts Turnbuckles End treatment.
Orientation of Load Cells
Guitar Intonation & Setup. Introduction Guitar setup on your new guitar is an iterative process that will take you approximately an hour. Additional time.
CLOVERLEAF CORPORATION QWICK KURB NUCOR Cable Barrier BarrierGuard800 Safe-T-Grip High Friction Surface TAU-II Crash Cushion QMB.
Automotive Chassis Systems, 5/e By James D. Halderman Copyright © 2010, 2008, 2004, 2000, 1995 Pearson Education, Inc., Upper Saddle River, NJ All.
Chapter 4 Estimating and Reducing Labor Costs
KYMV060C4 2 BY 2 MPDP INSTALLATION GUIDE KINGYOO Electronics., LTD.
Replacing Handbrake cables Using axle stands This show changes pages itself,
1 10 pt 15 pt 20 pt 25 pt 5 pt 10 pt 15 pt 20 pt 25 pt 5 pt 10 pt 15 pt 20 pt 25 pt 5 pt 10 pt 15 pt 20 pt 25 pt 5 pt 10 pt 15 pt 20 pt 25 pt 5 pt Vocabulary.
1 Stripe 400/600 Removing and Installing Printhead Printhead Resistance Calibration Toggle Position Adjustment.
Instructions for making plunger fork tool. Drawing for the trigger assembly.
Colchester Student 1800 Basic Operation Manual
Male haircuts - Parallel layers
1 Copyright  2004 Lincoln Global Inc. Oxyfuel Gas Welding & Cutting Equipment.
Copyright Tim Morris/St Stephen's School
Step 1: What you'll need: 1. A threaded needle (ribbon, raffia, yarn, embroidery thread, you can use just about anything) 2. An awl or large needle 3.
How to create Magic Squares
REMOVE AND INSTALL THERMOSTAT AND TEST OPERATION CS4 A.1 D.6 P-5/6.
Changing the Oil in a 2006 Mitsubishi Eclipse. Introduction Changing the oil in your 2006 Mitsubishi Eclipse is easier than you may think. With a few.
Gate Latch The hook is inserted into the eye screw to latch.
Optical Manufacturing Solutions 1 Probe Assembly.
Here is the broken line. Step 5: Break loose encasing seal. With bar in vice as show, hit with hammer to break loose. Usually 2 or 3 hits will break loose.
RL brake caliper Installation instructions Included parts: Solid billet aluminum caliper brackets (qty 2) 9/16 grade 8 bolts (qty 2) 9/16 grade 8 washers.
M.A.S.H.: The New Safety Hardware Crash Testing Criteria
Trinity Highway Products Properly Installed SRT Post HBA System-Slotted Rail Terminal
Introducing…. Zafety Lug Lock™.  Revolutionary new safety product  Setting new standards in wheel management  Helps prevent lug nut loosening  Reduces.
Blackwood Fire Company Stihl Chainsaw Maintenance.
Extended top hats installation instructions Included parts: Extended top hats (qty 2) Spring isolator bushing (qty 2) Energy Suspension top hat bushings.
General idea of a couple of check rod system and adjustments
Copyright © 2008 Emergency Training Solutions, LLC. All rights reserved. Firefighter I - Firefighting Basic Tools.
WRENCHES.
Chapter 1 Basic Car Control.
Installation. Indoor Unit Installation Typical Installation.
Automotive Brake Systems, 5/e By James D. Halderman Copyright © 2010, 2008, 2004, 2000, 1995 Pearson Education, Inc., Upper Saddle River, NJ All.
Sling Load Capacity and Sling Angles
© Goodheart-Willcox Co., Inc. Permission granted to reproduce for educational use only Battery Testing and Maintenance.
Band Saw Information Andy Lyman. Uses of the band saw The band saw is used to make straight or curved cuts Wide blades are for straight cuts Narrow blades.
XR621 Drive Hose Update Kit. Removal Turn off Battery dis Drain hydraulic tank Remove both rubber lines under chassis and discard. Remove and discard.
HOW TO CHANGE A TIRE. Take out the following items for you vehicle: - Spare Tire - Jack - Tire Iron - Lug Nut Key(if applicable) Spare Tire Jack Tire.
Chapter 4 Quick Check Problems
Shaft Replacement Standard Operating Procedure
9 HAND TOOLS.
Quality Ownership Engagement Program (Manual Checking Approach)
Woodworking Hardware Ag Mech I Standard 6:4-5.
Eliminating Bike Tires
Most Effective Procedures to Repair a Brake Booster.
Assembly instructions for M-K all bolt together hoppercone kit.
SUPPORT.
Where to Use Warning Lines
Bicycle Brakes.
Presentation transcript:

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. TL 3 System 4400 lb Pickup Truck 1800 lb Small Car Impacting at 62 mph 25 degrees

n u c o r h i g h w a y.com Nucor Steel Marion, Inc.

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. 18 wheelers? NOT TESTED

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. System Components Simple System Line Posts Cable Hook Bolts Turnbuckles End treatment

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Line Posts

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Turnbuckles Standard Cable = 1 x 750 (229m)

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Turnbuckles Like This! NOT like this! When turnbuckle interferes with post, leave off bolt Best practice is NOT to install all three turnbuckles in same space

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. End Treatment = = – 3 3 CRP End Terminal 6-6 Line posts (refer to plans)

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. CRP Posts

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Delineation 3M #94 Primer 3M High Intensity Prismatic #3931 Reflective Sheeting

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Maintenance of System

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Common Impacts – SIMPLE REPAIR

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. CRP Posts Line Post Repair

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Line Post Repair Make SURE: Cable on correct side Hook bolt nuts hand tightened Cable Heights TOP = 29.5 ±1 MIDDLE = 25.5 ±1 BOTTOM = /-2 Check and record tension

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Uncommon Impacts

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Releasing Tension 1.Loosen turnbuckle(s) 2.Cable grip and winch – pull towards accident 3.Ratchet come-along and 2 cable grips 4.Knock over CRPs 5.LAST CASE – CUT THE CABLE

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Quick De-tensioning

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. CRP Repair

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Re-tensioning – STANDARD CABLE Check Temperature Chart 15% higher 0 to 1.5 years After first major freeze After impact Tension tolerance is % or up to 2500 lbs. Check within first month after installation Periodically over the first year

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Checking Tension

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Additional information, photos, videos, and manuals available at nucorhighway.com U.S. High-Tension Cable System

n u c o r h i g h w a y.com Nucor Steel Marion, Inc. Questions ? U.S. High-Tension Cable System