noiseblock™ enclosure

Slides:

Advertisements

Similar presentations

1 1 BASICS OF ENERGY MANAGEMENT Section A - Energy Basics.

Advertisements

07/08/2002 PP.AFD.02.MotorBasics 1 of 55 Yaskawa Electric America Motor Basics.

Controlling the amount of ventilation to a space based on demand Reset based on occupancy: Use carbon dioxide sensors to track space CO2 levels and raise.

Chapter 7: Work (Ewen et al. 2005) Objectives: Define power and solve power problems Define power and solve power problems.

ENG 1102 Design Project - Energy Budgets Where is the energy going? What resources am I using?

Chapter 5 Work and Machines.

DRYING SYSTEM Concentrate from Evaporation section At 40% - 60% Concentration Rotary Dryer Mixed 15% Moisture Boiler System Hot Air Spray Dryer.

Industrial Ventilation - A major control measure Dr. AA, UTM.

Tech in the Workplace Setting up the Spreadsheet for the Stocks Section Registering on VirtualStockExchange.com If you don’t have an account, Let.

Phase Difference = Phase Difference = 0.05.

Welcome to Industrial Electronics Division. Products Loco Products Signaling Products Motor Controllers Industrial Electronics Division.

WISA Meeting Help Arrange a Speaker, Write Bio, Introduce

Northeast Agriculture Technology Corporation Dairy Energy Calculators Calculating Energy use and Energy Conservation Measure Savings.

ENERGY CONSERVATION BUILDING CODE – 2006 PRESENTATION BY VP GUPTA PRINCIPAL CHIEF ENGINEER (ELECTRICAL), BSNL CHENNAI.

Felipe Calizaya Miles Stephens 2010 UTILIZATION OF BOOSTER FANS IN UNDERGROUND COAL MINES Stewart Gillies Univ. of Utah, Salt Lake City, UT Missouri Univ.

Ductless Heat Pumps Sizing Example

Marketing Plan Mechatronics identified target markets and focus products as part of a marketing strategy initiated in 2006 An overview of these.

Amp air conditioning limited tel: fax: AMP – MHI SAF Heater Kits DescriptionPart NumberList Price SAF Heater.

Electrical Appliances and Power. Learning Objectives To be able to calculate power, and cost of electricity To be able to apply these calculations to.

1. Bucket capacity42m 3 Operating weight720,000 kg PC8000 Bucket capacity0.008m 3 Operating weight300 kg PC01 Product Range (Hydraulic Excavators) 2.

EXAMPLE ELECTRICAL DESIGN OF A SMALL OFFICE

Electrical Stuff From Questions Friday. Delta 3 Phase Motor.

Electricity & Magnetism at Work Electricity, Magnetism, & Motion Chapter 3 Section 1.

4-1 Using Graphs to Relate Two Quantities

P H Y S I C S Chapter 4: Work and Energy Section 4F: Power.

SYSTEM SELLING BINDER. WHY NOT HEAT PUMPS COST TOO MUCH TO BUY COST TOO MUCH TO OPERATE COST TOO MUCH TO MAINTAIN TOO COMPLICATED TOO NOISY.

Lesson 5.4 Power Essential Question: How do you calculate power?

Section 5–4: Power Physics Coach Kelsoe Pages 179 – 181.

Commissioning the System. Use Service form 1A Proof of performance Speeds up Tech support Reduces recalls Commissioning.

Section 1: Theory of Heat Unit 2: Matter and Energy

KIRKLAND LAKE GOLD VENTILATION UPGRADE 2011 PONSG October 27, 2011 By: Gregg Evans, Sr. Vent. Tech.

Year Production

Problem # 5-7 A 3-phase, 8-pole, induction motor, rated at 874rpm, 30hp, 60Hz, 460V, operating at reduced load, has a shaft speed of 880 rpm. The combined.

POWER The rate at which work is done The rate at which work is done The amount of work done in a unit of time The amount of work done in a unit of time.

Conceptional Design Review Group 9 – Department of Health William Allred.

Section 1: Theory of Heat Unit 2: Matter and Energy.

 Strategies that help improve performance (Breathing)

Power Chapter 5, Section 4. Power Power is the rate at which energy is transferred. Ex. The rate at which a light bulb transfers energy depends on its.

Chapter 5 Power 1. Power is the rate at which work is done. More generally, power is the rate of energy transferred by any method. 2.

April Motors 1011 of 55 Dykman Electrical 5 April 2013.

Planning The Electrical System  Safe means for the entrance of electrical supply into a building  Means of disconnecting all electrical power in a building.

1 AIR COMPRESSORS Auto Collision Repair/Refinishing Year One.

14.0 Math Review 14.2 Inches to Feet & Areas. Division 80 ÷ 5 = 16 Also written as:

Chapter 13 Energy and Work Section 4 Power. Power Power is the rate at which work is done or the amount of work done in a unit of time. Power is the rate.

 2008 Kaeser Compressors, Inc., USA (V4.1) SFC Product Introduction “Specifications are subject to change without notice” 1 SFC Sigma Frequency Controlled.

ENERGY CONSERVATION IN MOTOR SYSTEMS. Introduction 2.

15.0 Math Review 14.5 Using Basic Formulas. Converting Units Converting 6 inches of Mercury into Inches of Water Inches of Mercury are multiplied by 13.6.

Minimum Price $100. Minimum Price $45 Minimum Price $40.

Minimum Price $100. Minimum Price $45 Minimum Price $40.

Work and Energy Objectives: Work done by Forces Power

Work , Power and Efficiency

Types of heaters: Electric

Heat loss and heat gain in buildings: Outside air (OA) (Additional information) Required to be brought inside a building envelope to continuously replace.

Section 1.0 — Fundamentals and General

What Is Work? Chapter 12 Section 1.

HP Printer Number Call Now :

HP printer support number.

Basic Energy Units, Terms and Calculations

High-rise Hotel Lobby Air Handling System

Photo Gallery Central Location

Creating an Invoice from an Interactive Purchase Order

For a 15 kW household range, ___ W is the demand load.

Energy and Power Energy (E) is measured in joules (J)

Factors Affecting Demand:

Competitive Industry Report and Calculations

Work Work is done when a force is exerted on an object and the object moves a distance x. Work = force ·distance W = F · d units: N·m = Joule Work is.

HP PrinHP Printer Support Phone Number Dial HP is one of the most reliable brand names, which is known for offering some of the best electronic products, including photocopier, scanner, camcorders and printers. The lines are open 24/7 and

Presentation transcript:

noiseblock™ enclosure Required ventilation How to get it using Multiwall Spreadsheet

On multiwall ventilation section

Enter # of motors in enclosure & pick hp from dropdown list

If you have KW or BTU use converter to get horsepower (hp)

Find out Air cfm required, on next line down pick the closest cfm to required amount

Enter quantity of fans required to get cfm of air Enter quantity of fans required to get cfm of air. You could use (1) 3000 cfm fan or you could use (3) 1000 cfm fans in this example you can pick power phase if you want a price