Injection mold specification Client FUJIXEROX Model Name FUJIXEROX(KAMUY) Part Name COVER_SIDE_R Part No. 802B86480 DFM Feitai Zhong

Integral Corrective Action List ICAL Page OPEN POINTS SOLUTIONS/ACTION WHO 1 2 3 4 Plastics flow analysis Please confirm? Gas Assist Point 5 Parting _ line 6 7 Lifter 8 Slide 9 Cavity insert 10 Thin steel Cancel the R? 11 Thin steel in the lifter Reduce plastic? 12 Undercut & thin steel 13 Undercut Add plastic? 14 Undercut & sharp steel Add plastic & reduce plastic 15 Having no draft Please put the draft? I C A L Integral Corrective Action List 1-Date of opening (all dates in2005) 2-Date of beginning of action 3-Date foreseen for validation 4-Date of validation (closing) DFME Follow-up issue

Plastic Flow Analysis Sub E.P Gates Weld lines

Gas Assist Point Gas Assist Point

Parting _ line Cavity Core

Parting _ line Cavity Core

Lifter A A Detail A-A

Slide Slide Slide Slide

Cavity insert Cavity insert Remark: The cavity insert line will be recess into the part 0~0.05mm

Cancel this R for lifter Modify 01 Lifter Cancel this R for lifter

Modify 02 Lifter 7mm(3X) Reduce plastics The steel in the lifter is only3.3mm, please increase the holes size to 7mm to make lifter stronger.

Modify 03_A A A B B C C D D Please see the details in the next two pages.

Modify 03_B Changed Undercut Add plastic Add plastic reduce plastic Original Changed Add plastic Add plastic Original Undercut reduce plastic

add plastic in the grid area Modify 03_C Original P/L Sharp steel Changed P/L Proposal 1 Proposal 2 Original Changed Reduce plastics in the grid area add plastic in the grid area

Modify 04 All of the green surfaces are no draft, Please update the 3D data, otherwise, We will be reduce plastics reference by mould release demand, OK?