Charging a Battery SC2 By Vance Bloom.

Slides:

Advertisements

Similar presentations

Charging System Tests & Voltage information Checking the charging system with just a volt meter.

Advertisements

Cooling System Service CS6 NATEF Task A.1 D.7 By Vance Bloom.

REMOVE AND INSTALL THERMOSTAT AND TEST OPERATION CS4 A.1 D.6 P-5/6.

ELECTRICAL I LESSON 2 BATTERY SERVICE

CHARGING & JUMPING BATTERIES BATTERIES n A BATTERY IS FILLED WITH SULFURIC ACID WHICH WILL EAT MOST ANYTHING. n A BATTERY HAS LEAD PLATES WHICH MAKE.

Technician’s Version “How To Test” The Vehicle Base System of Shared Current Paths for Voltage Drop Left click the mouse to advance. Demo.

Q1 Engine turns over normally Q7 cranking problem? NO Not at all or slowly Q2 The headlights Come on and stay on while turning the key Q8 battery problem?

Battery Testing & Service

Register Digital Multimeter Usage Click Register to begin the course.

USING A DIGITAL VOLT- OHM - METER Automotive Technology Learning How Electricity Works.

PHSAUTOMOTIVESALSPHSAUTOMOTIVESALS Charging System tests & Voltage information Checking the charging system with just a volt meter.

Load Testing a Battery SC4B Objective Student will determine the state of charge of a battery and load test a battery in or out of the vehicle. Do you.

BATTERY State of Charge SC1 Objective Student will determine the “State of Charge” of a battery using the “Voltage Method” and document results. Student.

Battery Principles.

Forging new generations of engineers. Digital Multimeter.

Available at: – maintain VEX rechargeable power pack Maintain VEX Rechargeable Power Packs.

1 Battery Safety, Servicing & Testing R. Bortignon.

Batteries The purpose of the battery is to act as a reservoir for storing electricity.

BATTERY DRAW TEST SC10 By Vance Bloom Objective Student will determine if an abnormal “Key OFF Battery Drain” is present.

Battery Service Chapter 31 Page 413.

USING A DIGITAL VOLT- OHM - METER Automotive Technology Learning How Electricity Works.

Check Spark Plug Wires. Objectives Student will visually inspect and test with ohmmeter, spark plug wires, evaluate, then recommend if replacement is.

TUNE UP SKILL T-1 AIR FILTER Removal, Installation and Evaluation.

Testing Alternator Output By Vance Bloom & Florante Boac SC6.

Charging a Battery SC2 Objective Student will determine the state of charge of a battery and charge a battery in or out of the vehicle.

Starting and Charging Systems 23 Introduction to Automotive Service James Halderman Darrell Deeter © 2013 Pearson Higher Education, Inc. Pearson Prentice.

BATTERY State of Charge SC1 By Vance Bloom Objective Student will determine the “State of Charge” of a battery using the “Voltage Method” and document.

CBC Automotive n Operation n Service n Diagnosis Battery.

© Goodheart-Willcox Co., Inc. Permission granted to reproduce for educational use only Battery Testing and Maintenance.

Cooling System CS 1B Evaluating Coolant Checking For Dissolved Metals.

TUNE UP SKILL T-2 PCV VALVE Removal, Installation and Testing Operation By Vance Bloom CTE Automotive Technology Hemet High School.

COOLING SYSTEM: CHECK CONDITION AND CONCENTRATION OF COOLANT CS1 A.1 D. 7 P-1.

Write down three safety rules we talked about in the past few days. Talk with someone near you and see how many ways are out there to lift a car for service.

COOLING SYSTEM: CHECK CONDITION AND CONCENTRATION OF COOLANT CS1 A.1 D. 7 P-1.

Boost/Jump Starting SC3B Jump Starting a Vehicle With Jumper Cables By Vance Bloom.

BATTERY BOOSTING A battery may go ‘DEAD’ from many different causes. A ‘BOOST’ may be used to start a vehicle with a dead battery. Proper equipment and.

Auto turn off battery charger Auto turn off battery charger.

Electrical Testers Basic test equipment used in today’s shops may include an analog type meter, a VAT (Volt-Amp-Tester), DMM (Digital Multimeter),

This will serve as the guide to use at any destination that holds all Toyota product for no starts. Please follow our guidelines at all times. Rail Strategy.

Automotive Engines Theory and Servicing

START YOUR ENGINES!!! (PROPER JUMP STARTING PROCEDURES)

Service Procedure For Changing Engine Oil And An Oil Filter

Electrical Equipment CSP uses conventional electrical equipment in the majority of areas All installations follow the mandatory electrical codes The.

Automotive Service Modern Auto Tech Study Guide Chapter 28 & 29

The D.C. Scout Battery Distribution System Ground Locator

Chapter 31 Battery Systems.

Essential Tips to Perform Ignition System Checks.

USING A DIGITAL VOLT- OHM - METER

Electrical Equipment CSP uses conventional electrical equipment in the majority of areas All installations follow the mandatory electrical codes The.

FIGURE 17-1 A visual inspection of this battery showed that the electrolyte level was below the plates in all cells.

Click anywhere to get started…

MINNY 16 TROUBLESHOOTING Doc THE MACHINE DOES NOT START

Testing Alternator Output Vance Bloom & Florante Boac

STARTER DRAW TEST SC8 By Vance Bloom.

BATTERY State of Charge SC1 By Vance Bloom.

Removal, Installation and Testing Operation CTE Automotive Technology

PROPER USE OF FLOOR JACK AND SAFETY STANDS

Battery Testing & Service

The thin wire By:Steven Douglas.

USING A DIGITAL VOLT- OHM - METER

Dynamic Electricity.

Automotive Technology Principles, Diagnosis, and Service

FIGURE 18–1 A visual inspection on this battery shows the electrolyte level was below the plates in all cells.

THROTTLE POSITION (TP) SENSORS

Presentation transcript:

Charging a Battery SC2 By Vance Bloom

Student will determine the state of charge of a battery Objective Student will determine the state of charge of a battery and charge a battery in or out of the vehicle.

MATERIALS REQUIRED 1. EYE PROTECTION 2. VOLT-OHM-METER 3. BATTERY CHARGER 4. BATTERY

Procedure

Explosive! CAUTION! Never Make Sparks or Flame by Battery The Hydrogen Gas Given Off by the Battery is Explosive!

STEP 1 WEAR EYE PROTECTION!

Determine battery voltage STEP 2 Determine battery voltage (Use 20 Volt DC Scale) Write It Down!

Determine State of Charge STEP 3 Determine State of Charge Document Battery Voltage Record Battery Voltage & Estimate Percentage of Charge & Record 11.7 or Lower…………………0% Charge 12.0 ………………………………….25% Charge 12.2 ………………………………….50% Charge 12.4 ………………………………….75% Charge 12.6 or Higher …………….100% Charge

STEP 4 Hook Up Battery Charger (+) Hook up Positive (+) Clamp to Positive Post on Battery

Hook Up Battery Charger (-) Hook up Negative (-) Clamp STEP 5 Hook Up Battery Charger (-) Hook up Negative (-) Clamp to Engine Block Ground

Set Battery Charger Settings STEP 6 Set Battery Charger Settings For most batteries 12Volt Hi for 60 Minutes

Plug In Battery Charger STEP 7 Plug In Battery Charger When time is up Unplug Charger FIRST!

WHEN FINISHED CHARGING REVERSE PROCEDURE TO DISCONNECT CHARGER WHEN FINISHED CHARGING

SKILL SHEET COMPLETELY NOW, CLEAN UP! CLEAN, SHUT OFF & PUT AWAY VOLT-OHM-METER AND BATTERY CHARGER FILL OUT YOUR SKILL SHEET COMPLETELY & GET IT SIGNED!

QUESTIONS? VANCE BLOOM CONTACT @ 1-909-696-1081 vbloom@murrieta.k12.ca.us

THE END