Injection mold specification Client Fuji Model Name Xerox Part Name Cover fuser Part No. 802b089810_k001 DFM Ming L.

Integral Corrective Action List ICAL Page OPEN POINTS SOLUTIONS/ACTION WHO 1 2 3 4 Plastic Flow Analysis Pls confirm? Slide parting_line Pls confirm Slide parting_line? 5 Parting_line Pls confirm parting_line? 6 7 8 9 10 Sharp steel Changed the part,Pls confirm 11 Thin steel Reduce plastic,pls confirm? 12 No draft Reduce plastic? 13 Gas assistant location I C A L Integral Corrective Action List 1-Date of opening (all dates in2005) 2-Date of beginning of action 3-Date foreseen for validation 4-Date of validation (closing) DFME Follow-up issue

Plastic Flow Analysis side gate Weld line

Slide _ line Slide-B Slide-A Slide_line Slide_line Slide-A Slide-B

parting _ line Slide-A

parting _ line Slide-B

parting _ line

parting _ line Keep dim 17.7mm Keep dim 17.7mm Add plastic Add plastic

parting _ line This rib change like that.(2X) Suggest to move this rib 2mm?(2X) The core steel too thin. 2mm

Question-1 Cancel R. This rib will be move.. Sharp steel. Suggest to cancel R. Cancel R. This rib will be move.. Sharp steel. Cancel C.

Question-2 Reduce plastic 1mm Reduce plastic 1mm each side. Thin steel.

Question-3 All of the surfaces have no draft, draft from parting line, Pls update the 3D data, otherwise, We will reduce plastics for mould release.OK? Cancel R This location possibility for add material, when the mold design avoid the water line.

Gas assistant location

Gate location suggestion Gate width:10~14mm gate located at one end to try to reduce the chance for deformation gate thickness = 1.3 - 1.8mm