Job Performance Requirement 20-5

Slides:

Advertisements

Similar presentations

Salvage and Overhaul Skill Drills.

Advertisements

Geometry Origami - Penguin What shape do we begin with?

One-Dimensional Motion in the Vertical Direction (y – axis) or Freely Falling Bodies Montwood High School Physics R. Casao.

EXAMPLE 5 Solve a vertical motion problem Juggling

Pulling working lines. Step up onto the tailboard. Step up onto the tailboard.

Flag Raising, Lowering, and Folding

3.4 Newton’s Third Law of Motion

Projectiles The red ball is given a velocity U at an angle  to the horizontal U  The time taken for the ball to move up and down is the same time as.

How to make a paper bag book cover

Salvage Operations Henderson Truck Company Manual.

Name_______________________________________________ Date __________ Per _______ Quadratic Applications pt 1 1. The length of a rectangle is x ft and the.

9.6 Use Trig Ratios to Solve Word Problems

Job Performance Requirement Tying a Figure Eight on a Bight.

Projectiles A “projectile” is an object which is projected (thrown, dropped, fired) into the air or space. e.g. marble pushed off the edge of a bench.

Job Performance Requirement Modified Gasner Bar Pack.

18 Salvage and Overhaul Skill Drills. 2 Objectives Perform the one- and two- fire fighter salvage cover folds. Fold and roll a salvage cover. Perform.

Helicopters Movement in Air. Ask: How can you change the motion of a helicopter? Make a helicopter using the pattern. Explore the motion of the helicopter.

Gas Pressure L/O :- To understand what causes gas pressure.

Job Performance Requirement 14-2 Shoulder Carry. JPR 14-2A A The shoulder carry is useful for operations when firefighters will carry a ladder a good.

Job Performance Requirement Removing the Windshield and Roof.

States of Matter Second grade GLE Recognize that air takes up space.

HOSE ROLLS Straight roll ◦Lay the hose out straight and flat on a clean surface ◦Roll the male coupling over onto the hose to start the roll ◦Form a coil.

UNIT 152 MAINTAIN AND HANDLE KNIVES NLN Introduction to knives. NLN Knife database.

 A “Lab Safety Guide” is being passed out to you  Fold it in half on the long side like a book  Place glue on the back side of the right half and glue.

Job Performance Requirement 14-7 Three-Person Raise.

Job Performance Requirement Tying a Rescue Knot.

Objective: Students will find the area of parallelograms (10-1).

Circle Folding.  1. Cut out circle  2. Fold the circle in half  3. Fold the circle in fourths  4. Unfold and mark the center with a dot  5. Write.

SIZE - Top SERVER ROOM Designed by – openbox |

How to make a doodle plane. By: Katie Waters. The Doodle plane steps step 1 Get a piece of paper and fold in half, (long ways) then unfold to a full piece.

Building Boxes What is the largest volume open top box that you can build from an 8 ½ by 11 inch sheet of paper?

EXAMPLE 5 Solve a vertical motion problem A juggler tosses a ball into the air. The ball leaves the juggler’s hand 4 feet above the ground and has an initial.

1 Dimensional Motion. What you learned from you lab… Objects moving at constant velocityObjects accelerating.

Special Relativity: Einstein )The laws of physics don’t depend on your state of motion 2)Everyone who measures the speed of light gets the same answer.

Go Back > Question 1 8x 3 ? A cube has side length 2x. What is its volume? 2a.

Area of Squares, Rectangles, & Parallelograms. What is Area? Area is the space a shape covers, or takes up Area is the number of square units equal in.

Newton’s Third Law of Motion

Sizing Grade Rules Measuring Guide Photo Construction

Job Performance Requirement 7-8

Hot-Air Balloons.

Done by: Sally Zaatiti.

Aseptic Techniques.

FVCC Fire Rescue LADDERS PART B.

Job Performance Requirement 16-11

Job Performance Requirement 10-16

What is Work? Chapter 4.

Job Performance Requirement 15-10

Job Performance Requirement 16-5

BELL RINGER 11/5/14 -GRAB YOU IPAD!

Job Performance Requirement 20-2

Job Performance Requirement 10-19

18 Salvage and Overhaul.

18 Salvage and Overhaul.

18 Salvage and Overhaul.

Job Performance Requirement 15-11

Job Performance Requirement 20-1

Job Performance Requirement 20-3

Kinematics Problems Day #3

Job Performance Requirement 10-15

UNIT 152 MAINTAIN AND HANDLE KNIVES

Unit 4 Motion & Forces.

You are standing at your 2

Job Performance Requirement 10-14

Job Performance Requirement 16-3

Job Performance Requirement 16-8

Uniform Acceleration Review

Job Performance Requirement 16-8

Job Performance Requirement 10-32

Solving Quadratic Equations by

Presentation transcript:

Job Performance Requirement 20-5 Balloon Toss

A Two firefighters place the cover on the ground next to the item needing protection. The salvage cover is unfolded out of the accordion fold so that the cover is across the base of the item at its full length.

B The firefighters grab the top inside edge of the cover and pick it up to about waist height. Both firefighters simultaneously move the cover’s edge in an upward motion so that it catches air, and they then move to the other side of the item while the cover is still in the air. JPR 20-5B

C The firefighters guide the cover to the floor on the opposite side C The firefighters guide the cover to the floor on the opposite side. Once the items are covered, the firefighters dress the cover by folding the edges under to keep water from pooling and to lessen the chance for the edges of the cover to be disturbed by accident. JPR 20-5C