QUADCOPTER PRODUCTION PLAN

OUTILLAGE Hex wrench 2.5 mm Open-end spanner 5.5 mm Hex wrench 2 mm

-Set the arm supports without screwing it on the x500mm Big Arm

-Set x500mm Big Arm and his Arm supports on the Uper shell Upper Shell (10) 205 mm 205 mm 80 mm

-Set the arm supports on the upper shell without screwing them. -The screws not screwed will be used to fix the attachment pillar. Arm Support (8)

M3 Nut (1) -Block the 245 little arm in the arm support that have the same centering as the x500mm Big Arm. M3x25 Screw (3)

-Set the attachment pillar on the arm supports. M3 attachment pillar (7) M3 attachment pillar (7)

-Screw the lower shell on the M3 attachment pillar with the M3 screws. M3 Nut (1)

Assembling of the landing gear: Set the 2 landing gears against the M3 Spacer landing gear then fix it with the 2 M3x5 Screw. At the same time place the large partie of each landing gear on the arm support and screw it with the 2 M3x25 screw and the M3 Nut. Landing gear M3 Nut (1) M3x25 Screw (3) Arm Support (8) M3x5 Screw (5) M3 Spacer Landing gear (6) Assembling landing gear

-Fix the 4 landing gears on the 4 arms. They need to be fixed at the extremity of the arms. Arm Landing gear

Frame of the drone assembled: