MVB-II Assembly Instructions ©  All Rights Reserved to Mifram Ltd. 2018

About the MVB-II The MVB 2 is an advanced and improved version of the original Mifram MVB The overall principle remains the same When assembled units vertical element is impacted diverting the horizontal momentum into the ground The placement of the MVB is crucial. The Pictures demonstrate the correct orientation of the units The open side of the L shaped unit is the side to face the threat and receive the impact Tested & Approved:

Deployment Recommendations If Possible, deploy the MVB-II where the ramming car will be situated in the lower speed by using natural obstacles like curves etc. Block road sides and side walks. Use warning lights and signs.

Orientation of Elements in direction of potential threat (Open L shape) in direction of potential threat Direction of Potential Threat MVB – II Deployment

Safety Warning Be aware that several parts are heavy (26 kg) and sharp, pay attention during unloading, assembling and packing Elements Placed upright prior to being joined can fall on their side and create a hazard

The complete MVB-II

MVB-II Parts

R Pin

Handle

Rod & End Unit

Pull out the safety R pin

Pull out the safety R pin

Pull out the locking yellow pin

Pull out the locking yellow pin

Lift the upper part

Lift the upper part and Insert the locking yellow pin

Insert the locking yellow pin into the right hole The wrong hole The right hole

Insert the locking yellow pin into the right hole The wrong hole

Insert the safety R pin

Insert the safety R pin

Safety pin placed in the locking pin

Assembling of the units one after the other Repeat the above steps as needed in order to get required barrier width

Start on left side, insert rod

Insert the Rod B’H

Insert the Rod to the next unit

Add the second rod

Commence second section Insert second wheel section

Insert large safety pin

Insert large safety pin and lock it with the spring

Assembled and secured rods

Assembled 2 units with rods Repeat the above steps as needed in order to get required barrier width

MVB-II Assembling First Meter Exercise Care Units when opened and in standing position can tip and fall sideways. In order to prevent this, keep all units laying on their side on the ground surface until you are ready to join them.

Repeat the above steps

Assembling of the last right side unit

Assembling of the last right side unit

The End Unit

Insert the End Unit

Insert large safety pin and lock it with the spring

Assembled units without handle Place of handle

Attach the handle

Secure the handle with safety pin and lock it

MVB-II with rods & handle

Next step Assembling of the upper and lower cross section bars

Pull out the safety R pin from the upper cross section bar

Pull out the yellow pin and lift the upper cross section bar

Insert the yellow pin, Always from the front side

Secure with the R pin from the back side

Pull out the safety pins from the lower cross section bar

Move it to the right position

Secure the lower cross section bar with the safety and the R pin

Insert the R pin

MVB-II is ready for operation

Please contact us Thank you for purchasing Mifram MVB-II. with any question or information you may have. Our customer support will be happy to help you. +972.4.880.8800 sales@mifram.com www.MiframSecurity.com ©  All Rights Reserved to Mifram Ltd. 2018