Factory Installed Accu-Guide Ready

Slides:

Advertisements

Similar presentations

Levolors New Size-In-Store Blind Cutting Machine.

Advertisements

PREPOSITIONS OF PLACE WHERE? IN BEHIND ON BETWEEN UNDER NEXT TO

Lokotrack ST352 Presentation

Engineer Training XL1200 Electronics. Engineer Training XL1200 Electronics Confidential 2 XL1200 Electronics The XL Jet Electronic System consists of.

Frame Assembly Produced by Ed Latimer, Team 476 Ken York, Team 476 Ron Markum, Team

Cobwebs and ladybugs. Pulling the gas tank and other parts.

Robot Quick Build Session Frame Assembly Instructions Produced by Ed Latimer, Team 476 Ken York, Team 476 Ron Markum, Team 1750 Special Thanks to Oklahoma.

Trimble GCSFlex for Excavators

13.th July 2006 Pasi Rantanen Log Stacker RTD3026.

DAILY PRE-TRIP.

Hydraulic Anti-Lock Braking System For Trucks, Buses and Motor Homes.

Figure 1: The GT-1000 Solar PV Technology Panel

Showing Demonstrations on the TV How to connect the camera to our TV set.

Outside the body shop. Ready for the ride home Finished doors.

Engineer Training Electronic System Overview. Engineer Training XL1500 Electronics Confidential 2 XLjet Electronics The XL1500 Electronic System consists.

MC11000 Kit Replacement 1 1. Open the face plate and remove the 2 screws. Remove and discard the original face plate. 3. Remove the 2 white caps on the.

HETS 4-1 M1070 HET LEFT FRONT VIEW RIGHT REAR VIEW.

13th July 2006 Pasi Rantanen Log Stacker RTD1623.

Setting up the Ricoh C305 Press F5 to start the Presentation

Printed 10/7/2011 SCOUT, REV5, WIRING KIT, GUIDE SONAR Connector: JST Length: 6.5 inches 28AWG Start: BreakFly End: Sonar 0, 1 FEMALE Connector: JST.

GCS 300 System Operation Application – Level 1.

Installation of Gil’s Fuel Box By Albert “ARAMP1” Rampone.

2D Machine Control Systems

14.52 in Attach the Axle to the chassis using the four (4) bolts, washers, and nylon lock nuts. Mount the tires. Note: The wheel recess outside on the.

REAR ANTI-LOCK BRAKES. COMPONENTS n RABS Module n RABS Valve n RABS Speed Sensor n RABS ABS Warning Light n RABS Diagnostic Connector n RABS Diode/Resistor.

STATE ELECTION COMMISSION, KERALA General Election 2015 STATE ELECTION COMMISSION, KERALA General Election 2015.

BRAKE UNIT Mr. Masters Tech Ed 12th. Caliper brake design Most cars from the 1990 and up are equipped with caliper brakes.

Spare Parts Catalog 2013 Published February 7 th 2013 Crosspoint Solutions, 5511 W. 79 th St. Indianapolis, IN

Mechanical Components and Programming Ken Youssefi Introduction to Engineering – E10 1.

Hold the thread on the spool with your right hand. With your left hand, pull the thread to your left past the spindle. Keep the thread towards the front.

LAUNCH X improvements. LAUNCH ©Auto Testing Division Content Sensor headProgrammeTarget dataClampsCabinetTurn table, Side slip.

Beginning Chassis Build Season. Parts List Structure 2x20 Beam (2) 2x16 Beam (4) 2x10 Beam (2) Large Chassis Connector (20) 1x1 Connector Pin.

RoverBot Assembly The following pages show assembly plans for the RoverBot using the Consumer MindStorms or School Team Challenge Lego kit. Assemble the.

1/20/2016Minimizer Confidential1. 21/20/2016Minimizer Confidential.

RockOn! RockOn! Structure Build RockOn! 2009.

To install the four wires from the back of the coil machine, loosen the four knobs. Keep each wire in center under each knob, off to the side will allow.

Maintenance of, or to Change a faulty MCB (motor control board) 2010 models onwards.

Activity 4.2.8a Satellite Flight Satellite Robot Construction Guide

Automotive Engines Theory and Servicing

Titan Installation Guide

Factory Installed Accu-Guide Ready

HD-SDI DOME CAMERA SDI-DC221 SPECIFICATIONS MEMO USER’S MANUAL

Automatic Transmissions and Transaxles

8/30/2004 RoverBot Assembly The following pages show assembly plans for the RoverBot using the Consumer MindStorms or School Team Challenge Lego kit. Assemble.

Wiring For MAF Conversion on Mitsubishi 3000 GT ‘91-’93 Non OBDII

STOP!! Let the PCs boot up. This might take a minute or two.

Powertap User Guide.

Passenger protection.

음향 시스템 사양서 HYDRAPORT METREAU 6-BUTTON AXLINK KEYPAD RAMP KIT

Easycliner (Motorized Version) Assembly Instruction

Express-Bot 1. Right Side Driving Base Step-by-Step Instructions 11

Auto Guidance Systems. By Adam Wood.

Model 567 Weight Rating: Greater Than 33,000 lbs. 115 & 121” BBC

Affected Options: BR Option; EB Option; PH Option;

Vehicle Configurations

HOOD (1) FIG 701 P1 216.

HOOD (1) FIG 701 P1 216.

Activity 4.2.8a Satellite Flight Satellite Robot Construction Guide

Aristo-Craft FA1 non-PNP

Minimizer Confidential

Which of the following would best describe the situation inside the circle?

Express-Bot 1. Right Side Driving Base Step-by-Step Instructions 11

Can we apply our “3 Basic Steps” process to power a non-Aristo loco?

Camera Techniques.

BUILDING AN AUTONOMOUS QUADCOPTER.

SAVI SCOUT® System Setup

Suspension Systems - 2 Topics covered in this presentation:

Automotive Engines Theory and Servicing

Beginner Stander Presentation

Presentation transcript:

Factory Installed Accu-Guide Ready The following pictorial will help Determine if a Case MX / Magnum has the factory installed AccuGuide components. Identify the difference between factory installed AccuGuide system and a non-AccuGuide system. This information is specific to Case models 215, 245, 275, 305. This is a collection of observations made from several Case machines but should not be considered an all inclusive list. Tractors can be modified for various reasons after shipment. It is a good practice to consult the customer to confirm that their machine was ordered from the factory with the AccuGuide ready option.

Cab Roof White Circle: AccuGuide GPS Receiver Harness Factory Installed AccuGuide Ready: Yes Non-AccuGuide Ready: No Black Circles: Mounting location for GPS Receiver Factory Installed AccuGuide Ready: Yes (bracket included on new Case tractors) Non-AccuGuide Ready: Possible

Rear of Cab (View from behind the Operator’s Station) Factory Installed AccuGuide Ready? No. There is no compartment storing AccuGuide Ready harnesses. (Bracket holds a controller in a non-AccuGuide field installed guidance system.) Yes. The compartment stores Accu-Guide Ready harnesses

Master Guidance On/Off Switch This switch is present on most AccuGuide Ready tractors. These are the same switches with graphic change. MY06 and some MY07 AccuGuide Ready tractors may not have this switch.

Wheel Angle Sensor (View of inside front left wheel hub) Black Circle: Wheel Angle Sensor. Factory Installed AccuGuide Ready : No Non-AccuGuide Ready: No Field Installed Trimble: Yes

Field Installed Valve Kit View of left frame rail between the left front wheel and fuel tank. Factory Installed AccuGuide Ready: No Non-AccuGuide Ready: No Field Installed Trimble: Yes

Isolation Valve (View of tractor left side, hood up, in front of cab) Black Circle: 2 Pin Connector on the Isolation Valve Only Factory Installed AccuGuide Ready will have this connecting point. Factory Installed Accu-Guide Ready: Yes Non-AccuGuide Ready: No

31-Pin Connector (View of rear of tractor) zoomed view Red Circle: 31-Pin Connector connects to the Electronic Control Box Only Factory Installed AccuGuide Ready will have this connector. Factory Installed Accu-Guide Ready: Yes Non-AccuGuide Ready: No