The following model requirements are based on a basic slab door finish kitchen similar to the one shown in the image

Base unit 1 x 600mm 1 x 800mm 1 x 1000mm Sub mesh 3 Sub mesh 1 = Draws: draw depth is 20mm 15mm 15mm 600/800/1000mm 600mm 40mm 720mm Sub mesh 3 150mm Sub mesh 1 Sub mesh 2

Use depth of existing door 20mm Sub mesh 1 Sub mesh 2 Corner base unit 1 x LH 1 x RH 1127mm 610mm 627mm Worktop 1127mm 15mm 40mm 870mm Sub mesh 3 1000mm Cabinet 150mm 570mm Use depth of existing door 20mm 57mm 500mm Sub mesh 1 Sub mesh 2 57mm

1000mm wall unit 1000 bridging unit Sub mesh 2 Sub mesh 1 Sub mesh 1 Sub mesh 2

Depth should equal depth of base unit inc door Infill panel End panel Depth should equal depth of base unit inc door Height should equal 910mm Depth should equal depth of base unit Height = 870 50mm Sub mesh 3 40mm 870mm 15mm Sub mesh 1 Sub mesh 1 Sub mesh 2