Discussion on IMT-2020 mMTC and URLLC

Slides:



Advertisements
Similar presentations
Doc.: IEEE /0272r0 Submission February 2011 Ron Porat, Broadcom Outdoor Path Loss Models for ah Date: Authors: Slide 1.
Advertisements

Submission doc.: IEEE /1452r0 November 2014 Leif Wilhelmsson, EricssonSlide 1 Frequency selective scheduling in OFDMA Date: Authors:
Doc.: IEEE /1081r0 SubmissionSayantan Choudhury HEW Simulation Methodology Date: Sep 16, 2013 Authors: Slide 1.
QUALCOMM PROPRIETARY QUALCOMM Corporate R & D1 Performance of VoIP Services over 3GPP WCDMA Networks Ozcan Ozturk Qualcomm.
Doc.: IEEE /0065r0 Submission January 2014 William Carney, SONYSlide 1 Comments on Draft HEW PAR Date: Authors:
© 2006 Sprint Nextel WP5D Meeting Results
Submission doc.: IEEE /0092r0 Chen Sun, Sony ChinaSlide 1 Adjustment of energy detection threshold over IP-network Date: Authors: November.
Doc.: IEEE / Submission March 2013 Juho Pirskanen, Renesas Mobile CorporationSlide 1 Discussion On Basic Technical Aspects for HEW Date:
Dense apartment building use case for HEW
Channel Model Considerations for P802.11af
Performance Evaluation for 11ac
Month Year doc.: IEEE /0552r1 November 2015
Impact of LTE in Unlicensed Spectrum on Wi-Fi
Proposed basis for PAR discussion
Month Year doc.: IEEE yy/xxxxr0 November 2017
Discussions on 11ac PHY Efficiency
HEW Evaluation Metrics Suggestions
Verifying 11ax’s PAR by UL MU-MIMO
Comparisons of Simultaneous Downlink Transmissions
Evaluation Model for LTE-Advanced
IEEE ah Use Case – Outdoor Wi-Fi for cellular traffic offloading
2111 NE 25th Ave, Hillsboro OR 97124, USA
Proposed response to 3GPP ED request
Overview of CV2X Requirements
802.11ax for IMT-2020 EMBB Indoor Hotspot and Dense Urban
5G Micro Cell Deployment in Coexistence with Fixed Service
doc.: IEEE yy/xxxxr0 Date:
2111 NE 25th Ave, Hillsboro OR 97124, USA
Uplink Broadcast Service
Month Year November 2018 November 2018
Discussions on 11ac PHY Efficiency
TGah STA Analysis for Smart Grid Use Case
TGax Functional Requirement Discussion
The Effect of Preamble Error Model on MAC Simulator
TGax Functional Requirement Discussion
doc.: IEEE yy/xxxxr0 Date:
<month year> doc.: IEEE /453r0-SG3a November 2002
Functional Requirements for EHT Specification Framework
3GPP RAN1 status on NR-Unlicensed
doc.: IEEE yy/xxxxr0 Date:
Dense apartment building use case for HEW
Discussions on 11ac PHY Efficiency
Discussions on 11ac PHY Efficiency
<month year> <doc.: IEEE doc> January 2013
<month year> <doc.: IEEE doc> January 2013
3GPP RAN1 status on NR-Unlicensed
UL MU Random Access Analysis
Link Budget Analysis Date: Authors: November 2015
Performance Gains from CCA Optimization
AP Coordination in EHT Date: Authors: Name Affiliations
doc.: IEEE yy/xxxxr0 Date:
doc.: IEEE yy/xxxxr0 Date:
TX Mask Shoulders vis-à-vis ACI
Reducing Channel Access Delay
OFDMA Performance Analysis
doc.: IEEE yy/xxxxr0 Date:
Month Year doc.: IEEE yy/xxxxr0 May 2019
Effect of Preamble Decoding on HARQ in be
Performance on Multi-Band Operation
Current Status of submission about EUHT
doc.: IEEE yy/xxxxr0 Date:
AP Coordination in EHT Date: Authors: Name Affiliations
Functional Requirements for EHT Specification Framework
Reducing Channel Access Delay
Consideration on System Level Simulation
Month Year doc.: IEEE yy/xxxxr0 May 2019
Multi-Link Architecture and Requirement Discussion
Proposed basis for PAR discussion
Month Year doc.: IEEE yy/xxxxr0 November 2018
doc.: IEEE yy/xxxxr0 Date: September, 2019
Presentation transcript:

Discussion on IMT-2020 mMTC and URLLC Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 Discussion on IMT-2020 mMTC and URLLC Date: 2019-05-14 Authors: Sindhu Verma, Broadcom John Doe, Some Company

Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 Abstract This contribution provides a summary of IMT-2020 mMTC and URLLC requirements and an analytical evaluation of 802.11ax capabilities with respect to them. Sindhu Verma, Broadcom John Doe, Some Company

mMTC: Summary of requirements Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 mMTC: Summary of requirements With a layer 2 PDU (Protocol Data Unit) message size of 32 bytes and 1 message/day/device or 1 message/2 hours/device: Connection density of 1,000,000 devices per km2. 99th percentile delay per user less than or equal to 10s Sindhu Verma, Broadcom John Doe, Some Company

mMTC: Key aspects of the evaluation scenario Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 mMTC: Key aspects of the evaluation scenario Evaluation Configuration: Two configurations A and B, 500m ISD and 1732m ISD respectively Sufficient to meet the requirements for only one Carrier frequency 700 MHz Urban Macro topology: Hexagonal layout, 1 site with 3 TRxPs each UE deployment: 80% indoor, 20% outdoor Building type: 80% low loss, 20% high loss Channel model: UMa_A or UMa_B O-to-I loss: UMa_A: 20dB (for <= 6GHz) UMa_B: variable function of penetration loss due to glass and concrete Indoor loss: 0.5*d, d ~ Uniform (0, 25) TRxP Tx Power 49 dBm (20 MHz bandwidth) UE Tx power 23 dBm, UE speed 3 km/hr Up to 64 Rx/Tx antennas at the TRxP Up to 2 Tx/Rx antennas at the UE Evaluations can be either non-full buffer or full buffer System bandwidth of up to 50 MHz (can be distributed across TRxPs) Up to 10 MHz is also possible, but we are not considering it for 11ax Sindhu Verma, Broadcom John Doe, Some Company

mMTC: Analytical evaluation of 802.11ax Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 mMTC: Analytical evaluation of 802.11ax From the perspective of spectral efficiency, it is easy to support mMTC as each device may require at most O(100) microseconds to transmit the required small packet even with BPSK/QPSK. The limiting factor is the 10s or less delay to be supported even at 1%ile SINR. The mMTC 1%ile SINR can be low, due to the high loss for some of the Indoor UEs. Problem is more acute at the UL, since DL has a much higher transmit power (49 dBm at DL vs 23 dBm UL). 3GPP has simulated the SINRs in the mMTC topology and they get a 1%ile UL SINR of -5dB. 3GPP has assumed a simpler UE configuration of 1 Tx/Rx, in line with typical simple mMTC devices This means that, 11ax has to support non-zero data rates at the following SINRs: -5dB if it assumes 1 Tx/Rx as 3GPP -2dB if it assumes 2 Tx/Rx, as allowed by IMT 2020. While it may be possible today to meet the requirement at -2dB with advanced receivers in current Wi-Fi, it is much better if sensitivity is improved via HARQ. Also, smaller bandwidth allocation will help for coverage limited scenarios (for example 3GPP assumes min allocations of 180 KHz). Note that while HARQ may sometimes improve spectral efficiency, it will always improve sensitivity relative to ARQ. Sindhu Verma, Broadcom John Doe, Some Company

URLLC: Summary of requirements Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 URLLC: Summary of requirements Reliability: (1-10−5) success probability of transmitting a layer 2 PDU of 32 bytes within 1 ms at the coverage edge (5%ile SINR), at either DL and UL User Plane Latency: 1 ms assuming unloaded conditions (i.e. a single user) for small IP packets (e.g. 0 byte payload + IP header), for both downlink and uplink. Control Plane Latency: 20 ms (same as in eMBB) Mobility Interruption time: 0 ms (same as in eMBB and needs to be addressed above IEEE 802.11) Sindhu Verma, Broadcom John Doe, Some Company

URLLC: Key aspects of the evaluation scenario Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 URLLC: Key aspects of the evaluation scenario One of 2 evaluation frequencies: 4 GHz and 700 MHz Urban Macro environment (hexagonal layout, 1 site with 3 TRxPs addressing 3 sectors or hexagons) ISD of 500m UEs: 80% outdoor, 20% indoor, Buildings 100% low loss. TRxP Tx Power 49 dBm (20 MHz bandwidth) UE Tx power 23 dBm 10 UEs per TRxP Antenna configuration: TRxP: 64 Tx/Rx for 700 MHz, 256 Tx/Rx for 4 GHz UE: 4 Tx/Rx for 700 MHz, 8 Tx/Rx for 4 GHz UE speed 3 km/hr Indoor and 30 km/hr Outdoor System bandwidth of up to 100 MHz (can be distributed across TRxPs) The reliability and user plane latency requirements must be met at the 5th percentile downlink or uplink SINR value obtained in the above evaluation scenario. Sindhu Verma, Broadcom John Doe, Some Company

URLLC: Analytical evaluation of 802.11ax Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 URLLC: Analytical evaluation of 802.11ax Similar to mMTC, the limiting factor is achieving (1-10−5) success probability of transmitting the required small packet and with 1 ms latency at the 5%ile SINR This requires non-zero data rate with near zero error probability to be supported at 5%ile SINR (possibly with retransmissions) 5%ile SINR from 3GPP simulations varies between -2dB to 2dB (there is wide variation between results from different companies) 11ax may be able to meet the requirement at this SINRs. However, here too, HARQ may become very crucial to meet the very low error probability (0.001% error) at such low SINRs. Sindhu Verma, Broadcom John Doe, Some Company

References Month Year doc.: IEEE 802.11-yy/xxxxr0 May 2019 [1] IEEE P802.11ax™/D3.0, “Draft Standard for Information technology Tele-communications and information exchange between systems Local and metropolitan area networks— Specific requirements Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications; Amendment 6: Enhancements for High Efficiency WLAN” – June 2018 [2] Report ITU-R M.2412-0 (10/2017), Guidelines for evaluation of radio interface technologies for IMT-2020 [3] Report ITU-R M.2410-0 (11/2017), Minimum requirements related to technical performance for IMT-2020 radio interface(s) Sindhu Verma, Broadcom John Doe, Some Company