Injection mold specification Client FUJIXEROX Model Name FUJIXEROX(KAMUY) Part Name COVER_SIDE_L Part No. 802B86470 DFM Feitai Zhong

Integral Corrective Action List ICAL Page OPEN POINTS SOLUTIONS/ACTION WHO 1 2 3 4 Plastic flow analysis Please confirm? Gas Assist Point 5 Parting _ line 6 7 Lifter 8 Slide 9 Thin plastic (only 0.1mm) Cancel the thin plastic? 10 Having no draft Put draft for mould release? I C A L Integral Corrective Action List 1-Date of opening (all dates in2005) 2-Date of beginning of action 3-Date foreseen for validation 4-Date of validation (closing) DFME Follow-up issue

Plastic Flow Analysis Sub E.P Gates Weld lines

Gas Assist Point Gas Assist Point

Parting _ line cavity core

Parting _ line cavity core

Chang this lifter move direction

Slide Slide Slide Slide

Modify 01 Cancel these surfaces, Ok? (2 sides) It’s just only 0.1mm. Undercut

Modify 02 All of the green surfaces are no draft, Please update the 3D data, otherwise, We will be reduce plastics reference by mould release demand, OK?