Measuring the Temperature and Voltage of a Lithium Ion Battery

Slides:



Advertisements
Similar presentations
AS Level Electricity - Circuits
Advertisements

+ V (Volt) = W (work done, J) Q (charge, C)
S2 Science Our Physical World Part 3 Knox Academy Science Department 1. Introduction to static electricity By the end of lesson 1, pupils should be able.
Supercapacitor Energy Storage System for PV Power Generation
Team: – Brad Jensen – Will Klema – Nate Schares Client: – PowerFilm, Inc. Advisor: – Dr. Ayman Fayed Solar-Powered Mobile Power Station (MPS)
Current-Voltage Characteristics of a bulb In this experiment you are going to investigate how the current through a bulb changes according to the.
ESE Lab Computer based Temperature Control Sid Deliwala, ESE Labs.
Circuits Series and Parallel. Series Circuits Example: A 6.00 Ω resistor and a 3.00 Ω resistor are connected in series with a 12.0 V battery. Determine.
Electricity refers to the presence of electric current in wires, motors, light bulbs, and other devices. Electricity carries power. Power (P)
Lecture 28 October 30, Stand Alone PV San Luis Valley Solar Data (09/11/2010) Good Day [1] 3.
LDRs & Thermistors Noadswood Science, 2012.
Experiment 1 :- Determining the capacitance of a capacitor / connecting capacitors in series and in parallel: Goal: 1- Learning how to determine the capacitance.
Title : Intelligent battery charger Supervisor : Maeve Duffy Student : Noel Walsh.
Thermistors You are to investigate a factor that may affect the resistance of a thermistor.
Electric Currents Topic 5.2 Electric Circuits. Electromotive Force Defining potential difference Defining potential difference The coulombs entering a.
LI-PO BATTERIES. Why Li-po battery is used? Li-Po batteries (short for Lithium Polymer)- light weight have large capacities, meaning they hold lots of.
Electricity & Chemistry Our Nervous System only works thanks to electricity!
Product Engineering Processes Battery Primer A short battery primer Handbook of batteries, Linden and Reddy.
Your Hospital What are sensing circuits ?
x 10,000 5, M Time (min) y t.
RESISTORS Always remember…… V = IR (V= voltage in volts; I = current in amps; R = resistance in ohms)
The energy change in a thermocouple is : 1.E E to E H 2.E S to E E 3.E L to E E 4.E H to E E :20.
Circuits with more than one resistor, then Watt happens? Series and Parallel are the 2 ways of connecting multiple resistors.
EE330 Final Project Lithium Battery Monitor Evan Adkins and Brandon Umscheid.
Lemon and Potato Wet Cell Batteries
Chapter 8. Ohm’s Law  George Ohm experimented with circuits and came up with a mathematical relationship relating voltage, current and resistance in.
Temperature Sensing Temperature Bar Graph Project National Electronics Museum November 12, 2011 National Electronics Museum.
Transitors.
18240 Element two - Components INPUTS OUTPUTS PURPOSE TYPICAL USE.
Final Presentation April 13, Team Members Chapman, Jonathan Duties: Recharging Major: Electrical Engineering Dang, Quoc Duties: Cell Monitoring.
CELLS IN SERIES AND PARALLEL Lesson 9. Cells in Series  The electric potential given to a single electron by a dry cell has an average voltage of around.
For Electric Vehicle Team Members Pramit Tamrakar- Electrical Engineering Jimmy Skadal- Electrical Engineering Hao Wang- Electrical Engineering Matthew.
Ammeter voltmeter cell Indicator / light source diode Light emitting diode resistor Variable resistor thermistor Light dependent resistor heater Electric.
Electric Current and Electrical Energy Current Electric current is the rate at which charges pass a given point An electric current can be made.
Circuit Electricity. Electric Circuits The continuous flow of electrons in a circuit is called current electricity. Circuits involve… –Energy source,
The (IAT) sensor is mounted in the intake system so the tip will be exposed to the air entering the engine.
Current and Power Calculations Practice Math once again!!!
Dell Inspiron 6400 Battery Offers Huge Capacity for Your Laptop The life of Dell Inspiron 6400 battery is one of the most respectable attributes.
Ohm’s Law Aim: How does voltage and resistance affect current flow?
Start + end ???? 1.2 Electric circuits Lesson starter
AUTOMATIC TEMPERATURE CONTROLLED FAN USING 8051
Technology that lets you Trust your batteries!
Ohm’s Law Power Electric Energy Electric Cost
Stand-Alone Solar PV Energy System
Cells & Batteries.
LX2202 2A Li-Ion Charger and Power Control
Series Circuit – 1 bulb Series Circuit – 1 bulb.
Brendan Flood, Gerard deBlasi, John Fedak IV Lafayette College
7-2: Electric Current.
Lithium Operating Issues in a Stationary Environment
Lithium-Ion Battery For Low Temperature Application Presentation
Electric Potential Energy and Voltage
Voltage.
Bellwork What is required for electric current to flow?
Electric Current.
The resistance of a thermistor changes from 30k to 12k when the temperature changes from 20C to 70 C Calculate the sensitivity if resistance is taken.
Lead acid batteries 12 V 24 V 48 V
Topic H: Electrical circuits
Electricity Electric Current.
Series and Parallel Circuits
A graphing calculator is required for some problems or parts of problems 2000.
Lithium Ion Battery Safety
Electric Current 6.2.
Series Circuit.
Electric Current and Ohm’s Law
P2 - Physics Circuits.
Resistance.
FIGURE 17–2 A grid from a battery used in both positive and negative plates.
Fig. 2 Stabilizing the lithium-electrolyte interface.
Presentation transcript:

Measuring the Temperature and Voltage of a Lithium Ion Battery Ian Buck

Outline Purpose The Battery Procedure Materials Results

Purpose The Purpose of the project is to test for battery life through charging and discharging. While charging and discharging, temperature must be monitored for safety.

The Battery: Specifications Li-ion Battery 55 cells 175 Volts

Materials: NTC Thermistor NTC Thermistor’s were used to read voltage and from the voltage, and temperature was calculated. As the Temperature changed, so did the resistance.

Materials: Board Sensors attached to each battery cell Thermistor’s attached to two cells in each row Board then connects to Laptop

Materials: Software LTC6804/LTC6811 Multicell Monitor Logs Data from board into an excel

Results: General input/output Temperature

Results: General input/output Voltage

Labview Program The purpose of the Matlab program is to graph the data after the test, whereas the Labview Program is to show the temperature and voltage during the Test

Voltage The program reads the voltage data from the data-log. The program displays the average voltage of each row. The graph is the voltage of the whole battery.

Temperature For Temperature, the program displays the general temperature for each thermistor. The graph displays average temperature of all thermistors