Figure Serial versus Parallel Data Transfer

Slides:



Advertisements
Similar presentations
ECT 357 Ch 18 UART. Today’s Quote: Be careful that your marriage doesn’t become a duel instead of a duet. Be careful that your marriage doesn’t become.
Advertisements

Serial I/O - Programmable Communication Interface
Starting with serial Chapter Ten 10.1, 10.2,
1 Chapter Four Making Connections. 2 Introduction Connecting peripheral devices to a computer has, in the past, been a fairly challenging task Newer interfaces.
Two Ways to Think About Connected Systems Architectures and Connections Architectures range from fully centralized to fully distributed. Centralized are.
Eng. Husam Alzaq The Islamic Uni. Of Gaza
COMP3221: Microprocessors and Embedded Systems
Local Asynchronous Communication
ECE 353 Introduction to Microprocessor Systems Michael G. Morrow, P.E. Week 13.
EEE305 Microcontroller Systems Lecture 7: Embedded C using PIC microcontrollers Serial i/o with the XC8 Teaching resources are at
University of Tehran 1 Interface Design Serial Communications Omid Fatemi.
Technology Training that Works Hands of Data Communications, Networking & TCP/IP Troubleshooting.
Serial Communication ETEC 6416.
Serial Communication Lab 12 Module M21.1. Asynchronous Serial I/O ASCII code 54H = (“T”) sent with odd parity.
Modern Electronic Communication 9th edition Jeffrey S. Beasley and Gary M. Miller Copyright ©2008 by Pearson Education, Inc. Upper Saddle River, New Jersey.
ELECTRONIC COMMUNICATIONS A SYSTEMS APPROACH CHAPTER Copyright © 2014 by Pearson Education, Inc. All Rights Reserved Electronic Communications: A Systems.
The 8051 Microcontroller and Embedded Systems
S4525A Peripherals & Enhanced FLASH 1 © 1999 Microchip Technology Incorporated. All Rights Reserved. S4525A Peripherals & Enhanced FLASH 1 Peripherals.
Lecture Set 9 MCS-51 Serial Port.
Universal Synchronous/Asynchronous Receiver/Transmitter (USART)
“Describe the overview of hardware interfacing and the serial communication interface. Describe the PIC18 connections to RS232. Explain the serial port.
Universal Asynchronous Receiver/Transmitter (UART)
ECE 353 Introduction to Microprocessor Systems Michael Schulte Week 13.
Microprocessors 2 lesson Subjects lesson 7 Planning Interrupts Serial communication /USART Questions.
CHAPTER SERIAL PORT PROGRAMMING. Basics of Serial Communication Computers transfer data in two ways: ◦ Parallel  Often 8 or more lines (wire conductors)
Serial Communications
Chapter 5: Local Asynchronous Communication 1. Bit-wise data transmission 2. Asynchronous communication 3. Sending bits with electric current 4. Standard.
Chapter 6 Transmission of Digital Data Interfaces and Modems Digital Data Transmission DTE-DCE Interface Other Interface Standards Modems WCB/McGraw-Hill.
 8251A is a USART (Universal Synchronous Asynchronous Receiver Transmitter) for serial data communication.  Programmable peripheral designed for synchronous.
1 Chap. 3 Interface. 2 Interface  Physical connection between node and transceiver  Network interface card (NIC)  Physical connection between transceivers.
1 Transmission of Digital Data : Interface and Modems.
Digital Interfaces An interface links two devices Interface Standards define: – mechanical specifications - how many wires & connector type –electrical.
Ch. 6 Digital Data Communication Techniques
Aum Amriteswaryai Namah:. PIN DIAGRAM WW hen two processors are to communicate, more often the communication is organized in a bit serial fashion The.
PIC Microcontroller and Embedded Systems 1/e By Muhammad Mazidi, Rolin McKinlay, and Danny Causey © 2008 Pearson Education, Inc. Pearson Prentice Hall.
1 MPC 555: Queued Serial Module. 2 MPC 555 QSM QSPI: Queued Serial Peripheral Interface: full duplex serial, synchronous interface. 160B of queue RAM.
Synchronous vs asynchornous communication. What is a USART A USART (Universal Synchronous/Asynchronous Receiver/Transmitter) is a microchip that facilitates.
Ch. 6 Digital Data Communication Techniques. 6.1Asynchronous & Synchronous Transmission Asynchronous Transmission: transmission in which each information.
8251 USART.
Criteria for choosing a microcontroller A microcontroller must meet the task at hand efficiency and cost effectively. Speed. What is highest speed of.
Lecture # 14. RS – 232C Standard Standard for physical dimensions of the connectors. PC (DTE) Modem RS – 232C Cable Connected via serial port (DCE)
Chapter 4 UART Serial Port Programming 1. Serial vs. Parallel Data Transfer 2.
Serial mode of data transfer
UART Serial Port Programming
RS-232 Communications.
INT. TO EMBEDDED SYSTEMS DEVELOPMENT
EE 107 Fall 2017 Lecture 5 Serial Buses – UART & SPI
EET 2261 Unit 10 Serial Communications Interface
Figure SPI Single-Byte Write Timing (Notice A7 = 1)
Chapter 10 PIC18 Serial Port Programming in Assembly
Modem acronym for modulator-demodulator
Serial I/O and Data Communication.
SERIAL PORT PROGRAMMING
Chapter 6 Transmission of Digital Data Interfaces and Modems
ATMEGA 32 CONNECTIONS TO RS232; UDR AND UCSR REGISTERS
May 2006 Saeid Nooshabadi ELEC2041 Microprocessors and Interfacing Lectures 29: I/O Interfacing Examples
DATA COMMUNICATION Lecture-21.
UART Serial Port Programming
UART Serial Port Programming
Serial Communication Interface: Using 8251
Serial Communication Interface
UART Protocol Chapter 11 Sepehr Naimi
Figure CCP1 Control Register
CHAPTER SERIAL PORT PROGRAMMING. Basics of Serial Communication Computers transfer data in two ways: ◦ Parallel  Often 8 or more lines (wire.
Chapter 6 Transmission of Digital Data Interfaces and Modems
Exercise 1 1. Two signals are given in the following figures. Whose bandwidth is large? Why? s(t) s(t) t t (a) (b) 2. Draw the RS-232 waveform diagrams.
PIC Serial Port Interfacing
8051SERIAL PORT PROGRAMMING
Figure Simplified View of Interrupts (default for power-on reset)
PIC Serial Port Interfacing
Presentation transcript:

Figure 10-1. Serial versus Parallel Data Transfer

Figure 10-2. Simplex, Half-, and Full-Duplex Transfers

Figure 10-3. Framing ASCII ‘A’ (41H)

Figure 10-4. RS232 Connector DB-25

Figure 10-5. DB-9 9-Pin Connector

Figure 10-6. Null Modem Connection

Figure 10-7. (a) Inside MAX232 and (b) its Connection to the PIC18 (Null Modem)

Figure 10-8. (a) Inside MAX233 and (b) Its Connection to the PIC18 (Null Modem)

Figure 10-9. TXSTA: Transmit Status and Control Register

Figure 10-9. TXSTA: Transmit Status and Control Register (cont.)

Figure 10-10. RCSTA: Receive Status and Control Register

Figure 10-11. PIR1 (Peripheral Interrupt Register 1)

Figure 10-12. Simplified USART Transmit Block Diagram