Unity Application Generator How to develop the Physical Model

Steps After performing step mentioned in document “2-Start developing a project.ppt”, right click on SITE This window will appear:

Steps Write proper name along with description and click OK: An AREA will be available in Physical Model: Right click on AREA1 and click on New Process Cell: This screen will appear, give proper name /description and then click on OK.

Steps A process cell will be available in the Physical Model: Right click on PROCESS1 and click on New Unit: This screen will appear, give proper name /description and then click on OK.

Steps A process cell will be available in the Physical Model: Right click on PROCESS1 and click on New Unit: This screen will appear, give proper name /description and then click on OK.

Steps A unit will be available in the Physical Model: Right click on Unit1 and click on New Equipment Module:

Steps This screen will appear: Key in proper NAME, description but leave PLC NAME and HMIControl Domain blank. NOTE: PLC section name will be given by UAG as default Like this: Click OK

Steps At the end of this step, there should be a Physical Model available in UAG like this: