ADS54J60 Test.

Slides:

Advertisements

Similar presentations

T h e G a s L a w s. T H E G A S L A W S z B o y l e ‘ s L a w z D a l t o n ‘ s L a w z C h a r l e s ‘ L a w z T h e C o m b i n e d G a s L a w z B.

Advertisements

MB Page1Mihai Banu, July 2002 WCR #7 Nyquist rate ADC Main design motivation: Low Power Features: Pipeline arquitecture. Two interleaved ADCs with shared.

NAND-gate Latch. Summary NAND-gate Latch The time sequence at right shows the conditions under which the set and reset inputs cause a state change, and.

Digital to Analog and Analog to Digital Conversion

Frequency Stability FCC standards for FM Broadcast (p 337) Allocation:88.0 – Mhz Channel Spacing/Width:200 khz Carrier Stabilility:+ 2 khz = 20 ppm.

Initial Stability Measurements of the Mark I IF Downconvertor Glenn Jones June 8, 2006.

Signal Processing for Aperture Arrays. AAVS1 256 antenna elements distributed over –4 stations –64 elements each.

Electronic Amplifiers 1 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त 2015 शनिवार, 29 अगस्त.

Digital Design Strategies and Techniques. Analog Building Blocks for Digital Primitives We implement logical devices with analog devices There is no magic.

“Mini Rotary Alpha” Experimental Setup. Motor Control Electronics Balance Plate Frame Motor Battery Capacitor Batteries Motor Capacitor Encoder Frequency.

Analog to Digital Converters (ADC) Ben Lester, Mike Steele, Quinn Morrison.

AUP2G57 configured as flip flop Dual Configurable Logic Design Contest.

The energy change in a thermocouple is : 1.E E to E H 2.E S to E E 3.E L to E E 4.E H to E E :20.

 Save power  Scale down power rail  Ensure Reliability  Issues with variation  Issues with timing  Identify and Replace  Use custom cell  Use.

Alex Wanamaker.  2 astable 555 timer circuits  Blinking rate: ~1.1 seconds  Q1 and Q2 used to provide additional current for the circuit beyond.

3-Stage Low Noise Amplifier Design at 12Ghz

TOPIC : Test Techniques for some complex circuits UNIT 4 : Design For Testability Module 4.2: DFT Techniques.

E constante 1 control difusional x C C* BA A  BA  BA  BA  B AB E E0E0.

TI Confidential – NDA Restrictions DAC902 Test. TI Confidential – NDA Restrictions Test Setup: TSW1400EVM, Fs = 125MHz, offset binary, 65K samples Spectrum.

BJT transistors.

Renesas Electronics Europe GmbH A © 2010 Renesas Electronics Corporation. All rights reserved. RL78 AD converter.

Presented by Jim Seton Prepared by Jim Seton

Instrumented Walker Skyler Bullington Tommy Frankenberger Larson Stacy

ADS54J66EVM Test with TSW14J10EVM and ZC706

RFPD Noise mitigation R. Abbott 3 September, 2010

Integrated Circuits for the INO

The open loop gain of this op-amp is 105 and the bandwidth is 10 Hz

TSW30SH84 Single Tone.

THS5671EVM Test with TSW1400EVM

ADS54J20EVM Test with TSW14J10EVM and ZC706

DAC37J82 Settings Kang Hsia.

ADC32RF45EVM Test with TSW14J10EVM and ZC706

Front-end for BAMs Samer Bou Habib How to edit the title slide

6-bit 500 MHz flash A/D converter with new design techniques

ADC12J4000, TSW14J10, VC707 Testing.

Device noise Capacitors do not generate noise

ECET 340 Competitive Success/snaptutorial.com

FIN 650Competitive Success/snaptutorial.com

ECET 340 Education for Service-- snaptutorial.com.

ADC32RF45 with KCU105 Internal Clock GHz.

Created by Art Kay, Luis Chioye Presented by Peggy Liska

Aliasing and Anti-aliasing Filters TIPL 4304 TI Precision Labs – ADCs

ADC32RF45EVM Test with TSW14J10EVM and ZC706

Lesson 8: Analog Signal Conversion

Distortion Analysis XIN(t) XOUT(t) Nonlinear System If.

ADC32RF45 Testing.

TSW30SH84EVM Changing Data Rate with GUI

Quiz: Fast Fourier Transforms (FFTs) and Windowing TIPL 4302 TI Precision Labs – ADCs Created by Art Kay.

ADS7841 SAR Input Model (6/1/17)

ADC12J4000 testing with KC705 Oct, 2014.

ADS54J60EVM, TSW14J10EVM and KC705 Test

TSW54J60 and ADS54J60 Test.

DAC38RF82 Test.

ADC12J4000, TSW14J10, VC707 Dec 10x.

ADS54J60 with DMT signal 18th April 2016.

Introduction to Machines Machines Force Work Mechanical Advantage

Counter Integrated Circuits (I.C.s)

ADC12DJ3200 Testing.

Setup for EVM Provide 8MHz 12dBm to CLK_IN SMA.

ADC12DJ3200 Testing with KCU105 (JMODE0)

DAC38RF84 Test.

10k 20k Vin Vout H3 What is the gain?

ADC12J4000, TSW14J10, KC105, Dec 4x.

Hair Removal Methods: What's Effective and What's Not.

HOME AUTOMATION SYSTEM BLUETOOTH BASED.  INTRODUCTION  PROBLEM STATEMENT  OBJECTIVES  BLOCK DIAGRAM  CIRCUIT DIAGRAM  METHODOLOGY  APPLICATIONS.

Removal of brackets Example Work out each of the following

Presentation transcript:

ADS54J60 Test

ADS54J60 Test Setup: Single tone is given as input to the device. Test conditions: Fs = internal 983.04Msps, Fin =600MHz to 750MHz, at -6dBfs at ADC input On ADS54J60EVM replace T1,T3, T4 and T5 with TC1-1-13MA+ from Mini Circuits Remove R14, C9, R9, R20, C17 and R23

600MHz TC1-1-13MA+ -6dbfs

610MHz TC1-1-13MA+ -6dbfs

620MHz TC1-1-13MA+ -6dbfs

630MHz TC1-1-13MA+ -6dbfs

640MHz TC1-1-13MA+ -6dbfs

650MHz TC1-1-13MA+ -6dbfs

660MHz TC1-1-13MA+ -6dbfs

670MHz TC1-1-13MA+ -6dbfs

680MHz TC1-1-13MA+ -6dbfs

690MHz TC1-1-13MA+ -6dbfs

700MHz TC1-1-13MA+ -6dbfs

710MHz TC1-1-13MA+ -6dbfs

720MHz TC1-1-13MA+ -6dbfs

730MHz TC1-1-13MA+ -6dbfs

740MHz TC1-1-13MA+ -6dbfs

750MHz TC1-1-13MA+ -6dbfs