Tuesday 24/5 Fill # :00 Stable beam fill # bunches

Slides:



Advertisements
Similar presentations
8:16 SB 25ns dumped by RF; integrated lumi 0.6 nb-1. 9:14 BIC problem in TI8 and CMS recovering their tracker 10:09 Abort gap cleaning commissioning. 16:29.
Advertisements

Monday h00: End of fill #1640: 3.7 pb h14: RB S12 and S23 tripped before loading rampdown table, active filter. MPE piquet. Fip_Com_Lost.
08h15: Injection.  Correction injection oscillations.  Transfer line steering.  Losses at 30% of dump threshold, limited by SPS scraping. 12h35: Start.
Thursday 27 th October 00:57 fill 2257 dumped during squeeze (RQTF.A67B1) 03:52 stable beams fill #2258 4:33 Dumped, problem of LBDS dilution kicker power.
Tue 23/8 – Wed 24/8 09:00 Start 90 m optics run – Preparation and verification of the collimation functions – Re-generation of functions for Transverse.
LHC Status Fri Morning 3-June
Wednesday :06 Dump fill 3533: interlock BPMS in IP6
Machine Coordinators: G. Arduini, J. Wenninger
Friday 15th June 01:11 Injection.
Saturday 21st April 00:33 Interlock during ramp on BLM HV
Monday fill with 1092 bunches (6 h stable beams)
LHC Morning Meeting - G. Arduini
Saturday 09:40 Stable beams #1369 (56 bunch scheme)
Week 46 Week 46: Machine coordinators: Roger Bailey – Gianluigi Arduini Main aims of the week: Stable beams with ions Scheduled stop for ion source refill.
Tue :25 Beams dumped due to RF vacuum interlock
Saturday 12:00 Fill 1992 in stable beams.
LHC Morning Meeting - G. Arduini
Monday 6th August & night
Summary of Week 11: 14 – 21 March
Fri 29/7 – Sat 30/7 09:00 End of fill 1990, PC trip RCBXV3.R1 (likely SEU on QPS). Integrated Luminosity: 41 pb-1. Access for MKI2 main switch replacement.
Summary of week 44 Aims of week 44 J. Wenninger & J. Uythoven
Monday – recovery from MKI flashover
Summary of Week 16 G. Arduini, J. Wenninger
Mon 22/8 – Tue 23/8 00:07 stable beams #2040. Initial luminosities: 2.1x1033 cm-2s-1 18:00 Programmed dump. End of physics #2040. ~83 pb-1 in ~18 hours.
Mike Lamont, Jorg Wenninger
Thursday 10th May - morning
Friday Morning 3:44 – 15:04 stable beams Fill (dumped by operator)
Summary of Week 26 Main aims: G. Arduini, B. Holzer, M. Lamont
Tuesday 28th September Fill 1375 ongoing 09:00 Move in Roman Pots
Friday :00 machine setup for luminosity run. Better b-to-b stability from injectors. 01:58 stable run with 228 bunches 11:00 luminosity leveling.
Wire almost entirely through beam before BLM triggers dump
Tuesday 9th November 10:02 Fill beams dumped
Yesterday’s morning’s controls issues
Finally.... We had to wait a long time.... We had many problems....
Friday AM Some oscillations of the cryo conditions in MSR8 perturbed the setup for injection. RF frequency interlock fixed – required a reset of RF controls.
Wednesday 03/11 – The Plan Finish electron-cloud program:
Summary Thursday h21: Stable beams fill #1303.
Sunday/Monday & :30 Stable beams. Fill #1851.
Wednesday Ramp single nominal bunches for loss maps
Aims for the week Recover from technical stop and precycle at 10A/s
Monday 24 October hours of 25ns MD
Monday 14:00 beam dump Access:
Rocky last 24 hours Losses Q6.R5 Orbit SIS TCDQ OK! Power converters
Thursday Fill 1364 (24 bunch) dumped at 07h
Thursday 04/11 - Morning Access until ~13:00 Pre-cycle Proton checks:
Monday 6th 07:39 Dump fill #1854, RQ6.L2 tripped, followed by access
Wednesday h10: Programmed dump. 07h54: Injection. 200b.
Monday Fill 1803 into stable beams at 9:30. Dump at 19:45.
Thu 04:00 Fill #2729 Stable Beams. Initial lumi 6.5e33 cm-2 s-1.
Tuesday In the morning test cycle with probe for Q’ measurement.
Tuesday 20 September 2011.
Fri :52 Stable beams fill #2536
Thursday
Saturday 24 September 2011.
Coordination: Eva Barbara Holzer, Mike Lamont
Wednesday h18: 228b fill lost just before start of ramp.
Monday 26th September 7:30 Beam dump, QSP on RQX.R1, lost cryo in ITR1, 91 pb-1. Cryo recovery, needed about 1.5 h. Setting of TI2 collimators to 5 sigma.
Friday h55 Stable beams. Fill #1841. Lumi ~1.2e33.
Another Immortal Fill….
Monday 27th August & night
Wednesday 26 October 2011.
Wednesday 14:30 Fill 2011 dumped.
Monday 14th May 00:03UFO at BLMQI.06R8.B2E10_MQML. Beam dump Re-steering required for TI2 03:28 STABLE BEAMS # e11 ppb, 4.11e33 cm-2s-1 13:36.
Saturday 28th 08:17 Fill #1812: Stable beams, peak luminosity ~1.1x1033 cm-2s-1 19:00 Go to adjust for RF-checks; Record fill lumi of 31.7 pb-1 for CMS.
Tuesday End of fill 1393 Movement of suspicious Roman pots OK
Friday During the night from Thursday to Friday: by mistake, SPS longitudinal blow-up was not active  Smaller transverse emittance from the.
Thursday 10:00 Fill 1986 in stable beams.
Monday 152 bunch operation summary
Tuesday
Presentation transcript:

Tuesday 24/5 Fill # 1806 02:00 Stable beam fill #1804 912 bunches Initial lumi 1x1033 cm-2s-1 12:20 beam dumped fill #1804 RF interlock beam 1, initiated by UFO point 4 Integrated luminosity 29 pb-1 Access – “planned for one hour” Transverse damper amplifier, increase RF arc detection threshold and quench resistors cooling 17:30 Loss maps with injection protection in Fill #1805 18:30 Start injection Some problems with BPM calibration, injection losses & blow-up 23:25 Stable Beams 02:43 Beam dump, RF cfv-sr4-allfo1 power supply down Fill # 1806 08:20 Stable beams, Initial lumi 1x1033 cm-2s-1 25/5/2011 LHC 8:30 meeting

Dumped by RF arc detection – following a UFO in point 4 UFO point 4 Dumped by RF arc detection – following a UFO in point 4 XPOC TCT.4L5.B1 PM TCTV.4L5.B1 25/05/2011 LHC 8:30 meeting

Loss Maps at injection With injection protection in, to check ratio TDI / TCP B1 – V: TCP TDI B2 – V: TCP Looks OK TDI 25/05/2011 LHC 8:30 meeting

Injection Injection oscillations and losses for B1 OK after trajectory correction First, Beams blown up at injection as well OK for final injection 25/05/2011 LHC 8:30 meeting

Fill # 1805: 23:25 Stable Beams Going into physics now 02:43 cfv-sr4-allfo1 power supply down -> RF clock down Missing RF-frequency for beam dump: LBDS triggers as it should RF LL piquet changed the crate – no CO-FE first line 25/05/2011 LHC 8:30 meeting

Injection kickers MKI Point 8 vacuum Vacuum increase during end of filling stopping injection for a few minutes Most likely e-cloud of interconnects between the injection kickers Vac reading MKI-C stopping injection 25/05/2011 LHC 8:30 meeting

Injection kicker MKI warming up by the beam Injection interlock set to 55 C measured magnet temperature After checks this interlock level can most likely be increased until Curie temperature of magnet ferrite has been found Above Tcurie (around 120 C) kicker magnet will loose strength rapidly Difficult to perform reliable temperature measurement of ferrite which is under HV. Measured temperature ≠ Ferrite temperature. 25 C 45 C 25/05/2011 LHC 8:30 meeting

Plan Wednesday Thursday Fri – Sun Fill #1806 going into physics right now End of fill: RF tests switching off one cavity Test of RF power interlock TCLIB alignment Thursday Physics End of fill: TCL adjustment Asynch dump test @ 3.5 TeV for Roman Pots Measure chromaticity for FIDEL over the ramp Fri – Sun 25/05/2011 LHC 8:30 meeting