Table 1. Geometric properties of steel tubes used

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

© The Author(s) Published by Science and Education Publishing.

Table 4. Mechanical properties of repair and substrate concrete

Percentage of Polyethylene

Properties Test results

© The Author(s) Published by Science and Education Publishing.

Research, 2015, Vol. 3, No. 6, doi: /education

Table 4. Filter Sand Sieve Analysis

© The Author(s) Published by Science and Education Publishing.

Table 5. Properties of The Tested Soil

Tensile strength (MPa) Length (m) of fibers/kg

Table 2. Physical properties of Portland cement

Table 1. Configurations of the building

SON Nurse Practitioner Blackboard Community

Table 3. Comparison of NS1 Antigen Assay and Platelet Counts

Tensile Test after Firing

© The Author(s) Published by Science and Education Publishing.

Marshall characteristics

Table 1. Chemical composition of materials

© The Author(s) Published by Science and Education Publishing.

Table 11. Chi-Square Analysis Based on Grade Shift for Study Group

Reservoir Capacity (m3)

in the last evaluation of the software

Year range Rainfall (mm) ∆s in rainfall Temp (°C) ∆s in temp RH (mm)

Total CO2 Emissions (Electricity + Fossil Fuel)

© The Author(s) Published by Science and Education Publishing.

Table 2. Waste characterization in Port Harcourt, Source [1]

© The Author(s) Published by Science and Education Publishing.

Table 4. INVESTMENTS COST

Rating of Water Quality

Inscribed circle diameter

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Number of categories that are mentioned (0% < categories < 5%)

Table 1. Diagnostic methods for systemic fungal infection (n=70)

Table 2. Modal parameters estimated by Pulse Reflex®

Table 1. The most important aspect applied in MIVES

Table 5. Pvalues of ttests for direction a

Entrapment Efficiency (%) ± S.D.

Interpass temperature

Table 3. Main properties of the thin brass electrode

Table 5. Maximum stress, strain and deformation values

© The Author(s) Published by Science and Education Publishing.

Simulation Frequency(Hz)

Number of questionnaires sent out

Table 6. Pvalues of ttests for direction b

Table 1. Descriptive Statistics

Table 2. Regression statistics for direction a

Table 3. Regression statistics for direction b

Average Hardness value (HRC)

Table 3. List of PT specimens

Table 2. SUMMARIZED OBSERVATIONS FROM MODEL ANALYSIS

Table 6. Percentages of Indicators

Table 4. Surface roughness (outer faces)

Source of variation Degrees of freedom Sum of squares Mean square

Electrode ν (mm/s) I (A) V (V) HI (J/mm) HI average AWS E309L

Control Valve Tag Number

© The Author(s) Published by Science and Education Publishing.

Table 1. Project Control Factors and their hierarchy

Category Quantity Secondary school 3 Student participant

Table 3. Surface roughness (inner faces)

Table 7. The Result of T Test After Treatment

Compressive Strength difference at 1 week (MPa)

Table 6. Twisting moment of counter shaft at different torques

© The Author(s) Published by Science and Education Publishing.

Average Execution Time in seconds

Sum of Square df Mean Square F Sig Health Between Groups

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Presentation transcript:

Table 1. Geometric properties of steel tubes used Ser # Group Column Type Outer Dia mm Inner Dia Thickness mm D/t or b/t L/D or L/b λ 1 A Circular 160 155 2.5 64 4.69 19 2 B 111.25 106.25 44.5 6.74 27 3 C Square 125.66 120.66 50.26 5.97 21 4 D 87.38 82.38 34.95 8.58 30 T. Kibriya et al. Performance of Concrete Filled Steel Tubular Columns. American Journal of Civil Engineering and Architecture, 2017, Vol. 5, No. 2, 35-39. doi:10.12691/ajcea-5-2-1 © The Author(s) 2015. Published by Science and Education Publishing.