Table 2. Modal parameters estimated by Pulse Reflex®

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

© The Author(s) Published by Science and Education Publishing.

Intermediate-level learner

Table 1. Empirical MSE to estimate the CP distribution parameter λ

© The Author(s) Published by Science and Education Publishing.

Modulus of elasticity (GPa) Shear modulus elasticity (GPa)

Hospital live Deliveries

Research, 2015, Vol. 3, No. 6, doi: /education

Table 2. Parameters of the transmission line

Tensile strength (MPa) Length (m) of fibers/kg

SON Nurse Practitioner Blackboard Community

Tensile Test after Firing

© The Author(s) Published by Science and Education Publishing.

Table 1. Operating Conditions

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Table 2. Showing mean and SD along with t- critical ratio

© The Author(s) Published by Science and Education Publishing.

Table 6. Control sample industry distribution

Total CO2 Emissions (Electricity + Fossil Fuel)

© The Author(s) Published by Science and Education Publishing.

Table 2. Waste characterization in Port Harcourt, Source [1]

Table 4. INVESTMENTS COST

Rating of Water Quality

XW9048(Xantrex inverters)

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Table 2. Showing mean and SD along with t- critical ratio

Number of categories that are mentioned (0% < categories < 5%)

Table 1. Diagnostic methods for systemic fungal infection (n=70)

© The Author(s) Published by Science and Education Publishing.

No. Of units of single building Rated power (W) of unit load

Table 5. Pvalues of ttests for direction a

Entrapment Efficiency (%) ± S.D.

Interpass temperature

Table 2. Air-water flow cases

Table 1. Population by University

Table 3. Main properties of the thin brass electrode

Table 5. Maximum stress, strain and deformation values

Insulation, kWh/m²/day

Table 1. Characterization Result of Leaded Petrol and Blends

Simulation Frequency(Hz)

Injection Substations No. of Transformer Units Installed

Number of questionnaires sent out

© The Author(s) Published by Science and Education Publishing.

Table 6. Pvalues of ttests for direction b

Table 1. Descriptive Statistics

Table 2. Regression statistics for direction a

Table 3. Regression statistics for direction b

Control Valve Tag Number

S21 (at center frequency) 19 dB

Table 4. Summary of Multi ways ANOVA results

Table 2. SUMMARIZED OBSERVATIONS FROM MODEL ANALYSIS

Table 4. Surface roughness (outer faces)

Table 2. Control Valves & Bypass Valves Process Data

Cumulative Percentage

Cumulative Percentage

© The Author(s) Published by Science and Education Publishing.

Control Valve Tag Number

© The Author(s) Published by Science and Education Publishing.

Table 3. (d) Summary of two way ANOVA for overall adjustment

Table 1. K-T Diagram for Bicycle Seat

Category Quantity Secondary school 3 Student participant

Table 3. Surface roughness (inner faces)

Table 3. Simulation results

Compressive Strength difference at 1 week (MPa)

Table 6. Twisting moment of counter shaft at different torques

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

FDM (Fused Deposition Modeling)

Presentation transcript:

Table 2. Modal parameters estimated by Pulse Reflex® Mode Frequency [Hz] Damping ratio [%] 1 164.80 1.7536 2 435.91 0.3313 3 845.64 0.1356 4 1388.00 0.1183 5 2055.03 0.1065 6 2849.16 0.1208 7 3749.44 0.0619 8 4753.31 0.0520 9 5859.11 0.0454 10 7054.13 0.0436 11 8333.33 0.0640 12 9685.42 0.0995 Peter Pavelka et al. Modal Analysis Using the Signal Processing Toolbox of Matlab 2017. American Journal of Mechanical Engineering, 2017, Vol. 5, No. 6, 312-315. doi:10.12691/ajme-5-6-16 © The Author(s) 2015. Published by Science and Education Publishing.