No. Of units of single building Rated power (W) of unit load

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

© The Author(s) Published by Science and Education Publishing.

Table 4. Mechanical properties of repair and substrate concrete

© The Author(s) Published by Science and Education Publishing.

Modulus of elasticity (GPa) Shear modulus elasticity (GPa)

Research, 2015, Vol. 3, No. 6, doi: /education

Table 3. Quran memorization students survey responses about App

Table 2. Type designation of sensors in the security robot

Table 2. Physical properties of Portland cement

Tensile Strength (MPa)

SON Nurse Practitioner Blackboard Community

Tensile Test after Firing

Table 1. Operating Conditions

Teachers Response (N= 11)

Instructional materials

© The Author(s) Published by Science and Education Publishing.

Total CO2 Emissions (Electricity + Fossil Fuel)

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Table 2. Waste characterization in Port Harcourt, Source [1]

© The Author(s) Published by Science and Education Publishing.

Table 4. INVESTMENTS COST

Rating of Water Quality

XW9048(Xantrex inverters)

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Table 1. Rice yield in MT (Source-USDA, Foreign Agricultural Service)

Number of categories that are mentioned (0% < categories < 5%)

Table 1. Diagnostic methods for systemic fungal infection (n=70)

Table 2. Modal parameters estimated by Pulse Reflex®

© The Author(s) Published by Science and Education Publishing.

Table 7. Status of CF in Nepal as of 2009

Table 5. Pvalues of ttests for direction a

Transformer Annual MVA Loadings (%) Average MVA Loading (%)

Entrapment Efficiency (%) ± S.D.

Interpass temperature

Table 2. Air-water flow cases

Table 1. Population by University

Table 3. Main properties of the thin brass electrode

Table 5. Maximum stress, strain and deformation values

Table 1. LLC Academics Outcome Report ( )

Insulation, kWh/m²/day

© The Author(s) Published by Science and Education Publishing.

Table 1. Characterization Result of Leaded Petrol and Blends

Simulation Frequency(Hz)

Injection Substations No. of Transformer Units Installed

Number of questionnaires sent out

Table 6. Pvalues of ttests for direction b

Table 1. Descriptive Statistics

Table 2. Regression statistics for direction a

Table 3. Regression statistics for direction b

Control Valve Tag Number

© The Author(s) Published by Science and Education Publishing.

Table 2. SUMMARIZED OBSERVATIONS FROM MODEL ANALYSIS

Table 4. Surface roughness (outer faces)

Table 2. Control Valves & Bypass Valves Process Data

95% Confidence Interval for Mean

Control Valve Tag Number

Table 1. K-T Diagram for Bicycle Seat

Category Quantity Secondary school 3 Student participant

Cashew juice stored for 30 days

Table 4. Value creation (Y2)

Table 3. Surface roughness (inner faces)

Compressive Strength difference at 1 week (MPa)

Table 6. Twisting moment of counter shaft at different torques

© The Author(s) Published by Science and Education Publishing.

Average Execution Time in seconds

© The Author(s) Published by Science and Education Publishing.

FDM (Fused Deposition Modeling)

Power per unit land or water area

Presentation transcript:

No. Of units of single building Rated power (W) of unit load Table 2. LOADS TYPES OF A SINGLE BUILDING Loads types No. Of units of single building Rated power (W) of unit load Rated power output(W) Hours used / day KWh / day Room bulbs 10*3*4=120 36 4320 12 51.84 Outdoor bulbs 6*3=18 648 7.76 Toilet bulbs Presentation projector and student mobile charge 4*3=12 60 720 10 7.2 Steps bulbs 2*3=6 216 2.55 fans 3*4*3=36 35 1980 24 47.52 Total 198 --------- 8,532 ---------- 124.63 Mulugeta Tadesse et al. Design and Feasibility Analysis of Building Integrated PV (BIPV) System: Case Study in Bahir Dar University Lecture Halls Building. American Journal of Mechanical Engineering, 2017, Vol. 5, No. 1, 24-32. doi:10.12691/ajme-5-1-5 © The Author(s) 2015. Published by Science and Education Publishing.