The International Plant Protection Convention

Slides:



Advertisements
Similar presentations
The International Plant Protection Convention (IPPC)
Advertisements

MODULE THREE The IPPC Standard Setting Process. What this Module Covers The 4 stages of the IPPC Standard Setting Process:
International Framework and the IPPC MODULE ONE IPPC Participation.
The International Plant Protection Convention (IPPC) IPPC Secretariat July 2011 Kuala Lumpur, Malyasia.
The IPPC Online Comment System CPM-6 18 March 2011 Rome, Italy.
Online System for Compiling Member Comments July 2010 Near East Regional Workshop.
Flow-chart explaining information exchange and document dissemination under the IPPC IPP Training WS – Handout no. 4a.
The International Plant Protection Convention (IPPC) IPPC Secretariat 25 June 2013 Libreville, Gabon.
Draft ISPM: INTERNATIONAL MOVEMENT OF USED VEHICLES, MACHINERY AND EQUIPMENT (Steward Ngatoko Ta Ngatoko) IPPC Member Consultation 1 July to 30 November.
Promoting Competitive and Sustainable Agriculture in the Americas Handbook of Good Practices for Participation in Meetings of the IPPC and Guide for participation.
DEPARTMENT: AGRICULTURE International Plant Protection Convention: New Revised Text Briefing to Parliamentary Select Committee – Land & Environmental Affairs.
The IPPC and its standard setting process Workshop on SPS coordination to national and regional levels. Geneva, Switzerland. IPPC Secretariat.
© ETSI All rights reserved ETSI EN APPROVAL PROCESS (ENAP) Production time for ENs is being reduced by shortening the duration of the Approval Process.
PPPO Report to RPPO on the 27 th TC Meeting Memphis Tennessee, USA Josua Wainiqolo Executive Secretariat Pacific Plant Protection Organisation 2 nd – 6.
The International Plant Protection Convention (IPPC) Technical Panel on Diagnostic Protocols July 2010 Washington DC, USA International Plant Protection.
IPPC International Plant Protection Convention Roman Vágner European Commission, DG SANCO Plant health / Harmful organisms Bruxelles, 23 November 2011.
Regional IPPC Workshops 2014 Phytosanitary Resources page.
21st Session of the Technical Consultation among Regional Plant Protection Organizations Uganda, 30 Nov.-3 Dec APPPC Update Yongfan Piao Executive.
An introduction to the IPPC Dispute Avoidance and Settlement System IPPC Secretariat Regional IPPC Workshop 2015.
The International Plant Protection Convention (IPPC)
The International Plant Protection Convention (IPPC)
Food and Agriculture Organization of the United NationsInternational Atomic Energy Agency The Role of Codex and the International Plant Protection Convention.
Stage 3. Consultation and Review Standard Setting Training Course 2016.
Standard Setting Training Course 2016
IPPC Member Consultation 1 July to 1 December 2013
General introduction and welcome to the IPPC Standard Setting Course
IEEE TGa Project Timeline
The International Plant Protection Convention
Presenter organization.
The International Plant Protection Convention
The International Plant Protection Convention
May 21-25th, 2012 Cairns, Australia
Understanding the International Plant Protection Convention (IPPC)
IPPC second consultation 1 July to 30 September 2018
IPPC first consultation 1 July to 30 September 2018
IPPC Standard Setting Process
IPPC first consultation 1 July to 30 September 2018
Stage 4. Adoption and Publication
The International Plant Protection Convention
IPPC first consultation 1 July to 30 September 2018
Online System for Compiling Member Comments
The International Plant Protection Convention
IPPC Contact Points & Meeting National Reporting Obligations (NROs)
Stage 1. Developing the List of topics for IPPC standards
IPPC Member Consultation 1 July to 1 December 2013
Standard Setting Process – Information Flow
Standard Setting Process – Information Flow
IPP Training WS – Handout no. 4a
The International Plant Protection Convention
Basic information on NROs 7-8 September 2018, Moscow, Russia
IPPC Standard Setting Process
IPP Training, IICA & IPPC/FAO, Trinidad & Tobago
ePhyto DRAFT APPENDIX 1 TO ISPM 12:2011
my job today .. specificities of NAPPO The state of NAPPO –
IEEE SGa Project Timeline
Review of the 1958 Agreement
International Plant Protection Convention: New Revised Text
The International Plant Protection Convention (IPPC)
Module 7 Technical Assistance and Capacity Development
IPP Training, IAPSC & IPPC/FAO/FAORAF
DCUSA PARTY PANEL SECRETARIAT OFGEM CHANGE PROPOSAL SUBMITTED
IPP Training, EPPO & IPPC/FAO, York, U.K.
The International Plant Protection Convention
The International Plant Protection Convention
IPPC Member Consultation 1 July to 1 December 2013
IPP Training, IAPSC & IPPC/FAO/FAORAF
The International Plant Protection Convention
IPPC Consultation Period 1 July to 30 September 2016
IPP Training, IICA & IPPC/FAO, Trinidad & Tobago
Item 6 of the Agenda Balance of Payments Working Group 2-3 April 2012
Presentation transcript:

The International Plant Protection Convention IPPC Regional Workshop 2016 Changes to the Standard Setting Process xx xxxx 2016

Topics The IPPC Secretariat makes a call for topics every two years. Who can submit topics? IPPC Official Contact Points Regional plant protection organizations (RPPOs)

Consultation Periods Draft Specifications (60 days) First Consultation (90 days) Second Consultation (90 days) All starting 1st July For 2016 Specifications were not sent for consultation. The draft specifications will go for an e-decision as SC May did not have time to discuss them

Objection Second Consultation (90 days) On draft ISPMs SC approves for adoption Objection! must be accompanied by technical justification and suggestions for improvement No Objection If all Contracting Parties support the adoption of the draft ISPM, the CPM should adopt the ISPM without discussion If a CP does not support the adoption of the draft ISPM, the CP may submit an objection. An objection must be accompanied by technical justification and suggestions for improvement of the draft ISPM which are likely to be acceptable to other CPs and be submitted to the IPPC Secretariat no later than 3 weeks before the CPM session An objection should be a technically supported objection to the adoption of the draft standard in its current form and sent through the official IPPC contact point (Refer to the Criteria to help determine whether a formal objection is technically justified as approved by CPM-8 (2013), recorded in the IPPC Procedure manual for standard setting).