Table 5. Maximum stress, strain and deformation values

Slides:

Advertisements

Similar presentations

and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1

Advertisements

© The Author(s) Published by Science and Education Publishing.

Table 4. Mechanical properties of repair and substrate concrete

Percentage of Polyethylene

Properties Test results

© The Author(s) Published by Science and Education Publishing.

Modulus of elasticity (GPa) Shear modulus elasticity (GPa)

Research, 2015, Vol. 3, No. 6, doi: /education

Table 4. Filter Sand Sieve Analysis

Tensile strength (MPa) Length (m) of fibers/kg

Table 2. Physical properties of Portland cement

Tensile Strength (MPa)

Areas of Specialization

Table 1. Sample Size No Category Sample Size (F) Percentage (%) 1

SON Nurse Practitioner Blackboard Community

Tensile Test after Firing

Table 1. Operating Conditions

© The Author(s) Published by Science and Education Publishing.

Marshall characteristics

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Year range Rainfall (mm) ∆s in rainfall Temp (°C) ∆s in temp RH (mm)

Total CO2 Emissions (Electricity + Fossil Fuel)

Table 4. INVESTMENTS COST

Rating of Water Quality

XW9048(Xantrex inverters)

© The Author(s) Published by Science and Education Publishing.

© The Author(s) Published by Science and Education Publishing.

Number of categories that are mentioned (0% < categories < 5%)

Table 1. Geometric properties of steel tubes used

Table 2. Modal parameters estimated by Pulse Reflex®

© The Author(s) Published by Science and Education Publishing.

No. Of units of single building Rated power (W) of unit load

Table 5. Pvalues of ttests for direction a

Transformer Annual MVA Loadings (%) Average MVA Loading (%)

Entrapment Efficiency (%) ± S.D.

Interpass temperature

Table 2. Air-water flow cases

Table 1. Population by University

Table 3. Main properties of the thin brass electrode

Insulation, kWh/m²/day

Table 1. Characterization Result of Leaded Petrol and Blends

Simulation Frequency(Hz)

Injection Substations No. of Transformer Units Installed

Financial Development

Number of questionnaires sent out

Table 6. Pvalues of ttests for direction b

Table 1. Descriptive Statistics

Table 2. Regression statistics for direction a

Table 3. Regression statistics for direction b

Control Valve Tag Number

Table 3. List of PT specimens

Table 4. Surface roughness (outer faces)

Table 2. Control Valves & Bypass Valves Process Data

95% Confidence Interval for Mean

Control Valve Tag Number

Table 5. Water quality A3 well during pumping test

Table 1. K-T Diagram for Bicycle Seat

Category Quantity Secondary school 3 Student participant

Table 4. Value creation (Y2)

Table 3. Surface roughness (inner faces)

Table 7. The Result of T Test After Treatment

Table 3. Simulation results

Compressive Strength difference at 1 week (MPa)

Table 6. Twisting moment of counter shaft at different torques

© The Author(s) Published by Science and Education Publishing.

FDM (Fused Deposition Modeling)

Power per unit land or water area

Education, 2016, Vol. 4, No. 1, doi: /wjce-4-1-4

Presentation transcript:

Table 5. Maximum stress, strain and deformation values Maximum equivalent von Mises stress [MPa] V1 72 81 160 184 V2 128 145 270 316 V3 76 86 144 168 V4 49 54 112 129 Maximum equivalent strain [-] 0.0004 0.0008 0.0009 0.0006 0.0007 0.0013 0.0016 0.0005 0.0012 0.0002 Maximum deformation [mm] 7.9 8.5 13.3 14.6 4.4 5 9.4 10 5.6 9.5 10.8 1.2 1.3 1.9 2.1 Load L1 L2 L3 L4 Cosmin Roszkos et al. Fatigue Analysis of a Fire Truck Drop Tow Hitch for an O1 Category Water Pump Trailer. American Journal of Mechanical Engineering, 2016, Vol. 4, No. 7, 312-319. doi:10.12691/ajme-4-7-15 © The Author(s) 2015. Published by Science and Education Publishing.