Fig. 4 Energy balance analysis in STD systems.

Slides:

Advertisements

Similar presentations

Fig. 2 Transport properties of a BP transistor at low temperature.

Advertisements

Fig. 2 Global production, use, and fate of polymer resins, synthetic fibers, and additives (1950 to 2015; in million metric tons). Global production, use,

Fig. 3 Oil, gas, and FP water variations with time.

Fig. 5 Thermal conductivity of n-type ZrCoBi-based half-Heuslers.

Fig. 1 Map of water stress and shale plays.

Fig. 1 Examples of experimental stimuli and behavioral performance.

Fig. 4 Complete separation of water and solute after stable and efficient solar evaporation. Complete separation of water and solute after stable and efficient.

Fig. 1 Comparison of experimental and simulated NMR relaxation rates at 278 to 298 K. Comparison of experimental and simulated NMR relaxation rates at.

Fig. 4 Resynthesized complex boronic acid derivatives based on different scaffolds on a millimole scale and corresponding yields. Resynthesized complex.

Fig. 6 Comparison of properties of water models.

Fig. 2 Ferroelectric domains resolved in WTe2 single crystals.

Fig. 3 Glucose- and structure-dependent insulin release.

Fig. 3 Scan rate effects on the layer edge current.

Fig. 3 Rotation experiment, setup.

Fig. 1 Product lifetime distributions for the eight industrial use sectors plotted as log-normal probability distribution functions (PDF). Product lifetime.

Fig. 5 Structural photocycle for DmCry.

Fig. 6 External drivers and model response.

Fig. 6 Solar utilization efficiency and SEC in thermal and nonthermal desalination systems. Solar utilization efficiency and SEC in thermal and nonthermal.

Fig. 1 Distribution of total and fake news shares.

Fig. 3 Characteristics of UV and temperature sensors.

Fig. 2 2D QWs of different propagation lengths.

Fig. 1 Key factors in efficient STD systems.

Fig. 4 EUV TG signal from Si.

Fig. 3 Thermal management strategies in STD systems.

Fig. 3 Equatorial vertical structures of the four types of MJO.

Fig. 4 Horizontal structures of the four types of MJO.

Fig. 1 Histograms of the number of first messages received by men and women in each of our four cities. Histograms of the number of first messages received.

Fig. 5 Schematic phase diagrams of Ising spin systems and Mott transition systems. Schematic phase diagrams of Ising spin systems and Mott transition systems.

Fig. 4 OER performance of ACoO3 (A = Ca, Sr) in alkaline solutions with different pH. OER performance of ACoO3 (A = Ca, Sr) in alkaline solutions with.

Fig. 1 Average contribution (million metric tons) of seafood-producing sectors, 2009–2014. Average contribution (million metric tons) of seafood-producing.

Fig. 4 The mechanical performances of thermally stable click-ionogels.

Fig. 4 Evolution of fraction of sickled RBCs under hypoxia.

Fig. 2 Magnetic properties of FGT/Pt bilayer.

Fig. 2 Results of the learning and testing phases.

Fig. 2 Schematic drawings of Göbekli Tepe skulls.

Fig. 4 SPICE simulation of stochasticity.

Fig. 6 Global sensitivity analysis illustrates the key model parameters that determine the sickling of RBCs. Global sensitivity analysis illustrates the.

Fig. 2 NH3, NOx, SO2, and NMVOC emission changes triggered by the JJJ clean air policy. NH3, NOx, SO2, and NMVOC emission changes triggered by the JJJ.

Fig. 1 Size fractions of MPPs in different fertilizers.

Fig. 3 Evolution of the temperature difference between a cooling body and a thermal bath or another finite body, which are connected in an experiment using.

Fig. 5 Methods for recovering the latent heat of vaporization in solar-thermal distillation systems. Methods for recovering the latent heat of vaporization.

Fig. 4 Relationships between light and economic parameters.

Fig. 5 Comparison of the liquid products generated from photocatalytic CO2 reduction reactions (CO2RR) and CO reduction reactions (CORR) on two catalysts.

Schematic of the proposed brain-controlled assistive hearing device

Fig. 5 Thermal insulation performance of nanowood in comparison with a silica aerogel, a Styrofoam, and a natural wood. Thermal insulation performance.

Fig. 1 Location of the Jirzankal Cemetery.

Fig. 4 CO2 emission changes triggered by the JJJ clean air policy.

Multiplexed four- and eight-channel devices for rapid processing

Fig. 2 Mean field results. Mean field results. (A) Solutions P(x) to Eq. 4 for a range of T and wc = (B) Modulus ∣pk∣ of order parameters versus.

Fig. 3 Comparisons of NDVI trends over the globally vegetated areas from 1982 to Comparisons of NDVI trends over the globally vegetated areas from.

Fig. 1 Schematic depiction of a paradigm for rapid and guided discovery of materials through iterative combination of ML with HiTp experimentation. Schematic.

Fig. 4 Spatial mapping of the distribution and intensity of industrial fishing catch. Spatial mapping of the distribution and intensity of industrial fishing.

Fig. 4 Single-particle contact angle measurements.

Fig. 1 Example of diversified propagation patterns of the MJO.

Fig. 6 MD simulations of assembled binary supraballs.

Fig. 6 Energetics of the CaL methane reforming process.

Fig. 3 Supraballs and films assembled from binary 219/217nm SPs/SMPs.

Fig. 2 Supraballs and films from binary SPs.

Fig. 3 Performance of the generative model G, with and without stack-augmented memory. Performance of the generative model G, with and without stack-augmented.

Fig. 2 Growth kinetics of borophene on silver.

Fig. 4 Behavior of resistance peak near density nm = 5.

Fig. 2 Comparison between the different reflective metasurface proposals when θi = 0° and θr = 70°. Comparison between the different reflective metasurface.

The combined signal spectra of PSD for protons and helium nuclei

Fig. 3 Rubbery strain, pressure, and temperature sensors.

Fig. 1 Conceptual diagram of warming effects on ecosystem C fluxes above and below the SWC optimum. Conceptual diagram of warming effects on ecosystem.

Fig. 3 Calculated electronic structure of ZrCoBi.

Fig. 6 Schematic illustration of the decreased conformational stability in the N92I mutant and its activation mechanism. Schematic illustration of the.

Fig. 4 Electrochemical mechanism studies.

Fig. 4 Orthosteric ligand-binding pocket in CysLT1R.

Fig. 1 Completely derived from natural wood, nanowood with hierarchically aligned cellulose nanofibrils can be used as an anisotropic super thermal insulator.

Presentation transcript:

Fig. 4 Energy balance analysis in STD systems. Energy balance analysis in STD systems. Energy balance analysis is performed in four different steady-state STD configurations: (A) a nonselective absorber with a finite bulk solution volume with perfect thermal insulation, (B) a selective absorber with a finite bulk solution volume with perfect thermal insulation, (C) a selective absorber with an infinite bulk solution volume and no wick, and (D) a selective absorber with an infinite bulk solution volume and wick. For each scenario, the energy flux and temperature of the absorber as a function of the solar absorptivity (α) of the absorber are also plotted next to the schematic of each STD configuration. In each plot, the total incoming solar flux is 1000 W m−2, and it is equal to the sum of the unabsorbed solar flux (orange region), the radiative heat loss (red region), the convective heat loss (purple region), the heat loss to water (brown region), and the energy consumption for evaporation (blue region). The dashed black curve represents the average temperature of the absorber. Zhangxin Wang et al. Sci Adv 2019;5:eaax0763 Copyright © 2019 The Authors, some rights reserved; exclusive licensee American Association for the Advancement of Science. No claim to original U.S. Government Works. Distributed under a Creative Commons Attribution NonCommercial License 4.0 (CC BY-NC).