Table 2. Control Valves & Bypass Valves Process Data

Slides:



Advertisements
Similar presentations
and Statistics, 2016, Vol. 4, No. 1, 1-8. doi: /ajams-4-1-1
Advertisements

© The Author(s) Published by Science and Education Publishing.
Table 4. Mechanical properties of repair and substrate concrete
© The Author(s) Published by Science and Education Publishing.
© The Author(s) Published by Science and Education Publishing.
Modulus of elasticity (GPa) Shear modulus elasticity (GPa)
Research, 2015, Vol. 3, No. 6, doi: /education
Table 2. Type designation of sensors in the security robot
SON Nurse Practitioner Blackboard Community
Total Energy Consumed (%)
Tensile Test after Firing
© The Author(s) Published by Science and Education Publishing.
© The Author(s) Published by Science and Education Publishing.
Table 1. Operating Conditions
© The Author(s) Published by Science and Education Publishing.
Marshall characteristics
© The Author(s) Published by Science and Education Publishing.
© The Author(s) Published by Science and Education Publishing.
Table 6. Control sample industry distribution
Year range Rainfall (mm) ∆s in rainfall Temp (°C) ∆s in temp RH (mm)
Total CO2 Emissions (Electricity + Fossil Fuel)
© The Author(s) Published by Science and Education Publishing.
© The Author(s) Published by Science and Education Publishing.
Table 2. Waste characterization in Port Harcourt, Source [1]
© The Author(s) Published by Science and Education Publishing.
Table 4. INVESTMENTS COST
Rating of Water Quality
XW9048(Xantrex inverters)
© The Author(s) Published by Science and Education Publishing.
© The Author(s) Published by Science and Education Publishing.
Table 1. Rice yield in MT (Source-USDA, Foreign Agricultural Service)
Number of categories that are mentioned (0% < categories < 5%)
Table 1. Diagnostic methods for systemic fungal infection (n=70)
Table 2. Modal parameters estimated by Pulse Reflex®
© The Author(s) Published by Science and Education Publishing.
No. Of units of single building Rated power (W) of unit load
Table 7. Status of CF in Nepal as of 2009
Table 5. Pvalues of ttests for direction a
Entrapment Efficiency (%) ± S.D.
Interpass temperature
Table 2. Air-water flow cases
Table 1. Population by University
Table 3. Main properties of the thin brass electrode
Table 5. Maximum stress, strain and deformation values
Insulation, kWh/m²/day
Table 1. Characterization Result of Leaded Petrol and Blends
Simulation Frequency(Hz)
Group Male Female Total Astrocytoma Grade 2 (%65)13 (%35)7 (%100)20
Number of questionnaires sent out
Table 6. Pvalues of ttests for direction b
Table 1. Descriptive Statistics
Table 2. Regression statistics for direction a
Table 3. Regression statistics for direction b
Table 2. Demographic characteristics of the study subjects
Control Valve Tag Number
© The Author(s) Published by Science and Education Publishing.
Table 2. SUMMARIZED OBSERVATIONS FROM MODEL ANALYSIS
Table 4. Surface roughness (outer faces)
Control Valve Tag Number
Table 1. K-T Diagram for Bicycle Seat
Category Quantity Secondary school 3 Student participant
Table 3. Surface roughness (inner faces)
Compressive Strength difference at 1 week (MPa)
Table 6. Twisting moment of counter shaft at different torques
© The Author(s) Published by Science and Education Publishing.
Average Execution Time in seconds
© The Author(s) Published by Science and Education Publishing.
FDM (Fused Deposition Modeling)
Table 6. Range Comparisons amongst Subgroups and grade levels
Power per unit land or water area
Presentation transcript:

Table 2. Control Valves & Bypass Valves Process Data Control Valve Tag Number Operating Inlet Pressure Range of Operation Differential Pressure Process Comment 41FV0536 11 40-100% 1-3 - 41TV0275 50FV6040 8 50-100% Min.Flow & Low accuracy 50TV0061 7,5 10-100% 1 50PV0060 5 4,5 50FV6190 2-4 23TV0802 14 High Flow 23TV1392 23TV1372 40TV0190 24TV0132 3 29TV0632 Karan Sotoodeh et al. Selecting a Butterfly Valve Instead of a Globe Valve for Fluid Control in a Utility Service in the Offshore Industry (Based on an Industrial Experience). American Journal of Mechanical Engineering, 2018, Vol. 6, No. 1, 27-31. doi:10.12691/ajme-6-1-4 © The Author(s) 2018. Published by Science and Education Publishing.