QUADCOPTER PRODUCTION PLAN

SET OF TOOLS 2.5mm Hex wrench Open-end 5,5mm spanner 2mm Hex wrench

-Set the arm supports on the x500mm Big Arm, but don’t screw them until they are not in the right position. Arm Support (8) X500 MM Big Arm (12)

-Set the x500mm big arm and its Arm supports on the upper shell, when the parts are correctly positioned you can scew it all. Upper Shell (10) 205 mm 205 mm 80 mm

-The remaining screws will be used to fix the attachment pillar. -Set the arm supports on the upper shell without screwing them too much until the whole parts aren’t correctly adjusted. -The remaining screws will be used to fix the attachment pillar. Arm Support (8)

M3 Nut (1) -Block the 245 little arm in the arms support in order to have the same centering as the x500mm Big Arm. M3x25 Screw (3)

-Set the attachment pillar on the arm supports. M3 attachment pillar (7) M3 attachment pillar (7)

-Screw the lower shell on the M3 attachment pillar with the M3 screws. M3 Nut (1)

Assembling of the landing gear: Set the 2 landing gears against the M3 Spacer landing gear then fix them with the 2 M3x5 Screw. At the same time place the large part of each landing gear on the arm support and screw it with the 2 M3x25 bolt and the M3 Nut. Landing gear M3 Nut (1) M3x25 Screw (3) Arm Support (8) M3x5 Screw (5) M3 Spacer Landing gear (6) Assembling landing gear

-Fix the 4 landing gears on the 4 arms. They need to be fixed at the extremity of the arms. Arm Landing gear

Frame of the drone assembled: