2008 Progress Seminar 유방암 자가 진단기 Subtitle 1 Subtitle 2 (발표자이름) (날짜)

Slides:

Advertisements

Similar presentations

Flex Circuit Design for CCD Application ECEN 5004 Jon Mah.

Advertisements

Pressure Methods Manometer Elastic Transducers Measuring Vacuum

Layer 0 Grounding Requirement in terms of noise performance Grounding/Shielding studies with L0 prototype Summary Kazu Hanagaki / Fermilab.

Eelectric Energy Harvesting Through Piezoelectric Polymers Progress Report - April 29 Don Jenket, II Kathy Li Peter Stone.

In Order of Presentation: Ishaan Sandhu DannY Kang Arslan Qaiser Eric Otte Anuar Tazabekov Capacitive Rain Sensor for Automatic Wiper Control.

Molly, Gwyn, Sam, and Eric.  We ordered everything we need to make a first prototype (1 or 2 extras of all components)  Spent $775 on Digikey (includes.

AWG 36, 0.2 A 0.3 mm Heat Shrink Tubing t = 0.38 mm Silicone Coating t = 0.2 mm D = 3 mm Shielding: Copper Tape AWG 26, 2.2A 0.6 mm AWG 26, 2.2A 0.6 mm.

November Vertex 2002 Kazu Hanagaki1 Layer 0 in D0 Silicon Tracker for run2b Kazu Hanagaki / Fermilab for D0 run2b Silicon Tracker group Motivation.

Lecture 221 Series and Parallel Resistors/Impedances.

Instrumentation System  A Measuring system is required to compare a quantity with a standard or to provide an output that can be related to the quantity.

In Order of Presentation: Ishaan Sandhu Danny Kang Anuar Tazabekov Arslan Qaiser Eric Otte How to Choose/Use Capacitive Sensors for Various Applications.

Wireless Digital Audio Transmission Senior Design Project Summer 2002 E. Donnelly, K. Khan, S. Owen D. Choy Dr. H. Lam.

Performance of the DZero Layer 0 Detector Marvin Johnson For the DZero Silicon Group.

Automatic Test Equipment HIOKI E.E. CORPORATION / PCB PACKAGE BOARD ASSEMBLY X-Y HiTESTER.

Analog Cable Status Basic design fixed --- the latest cable has good quality. (report by Frank) Capacitance for single cable ~0.35pF/cm --- both new and.

Biomedical Electrodes Presented by- Md. Bashir Uddin Roll: Dept. of BME KUET, Khulna-9203.

Read-out boards Rui de Oliveira 16/02/2009 RD51 WG1 workshop Geneva.

Designing a Circularly Polarized Antenna for EagleSat Dadija Bliudzius Embry-Riddle Aeronautical University NASA Space Grant.

Microwave Amplifier Design Blog by Ben (Uram) Han and Nemuel Magno Group 14 ENEL 434 – Electronics 2 Assignment

Low Cost DAQ Implementation

CVD PCB, first steps. 15 mm 25 mm Chip area. No ground plane underneath the chip. Bulk isolated => only one ground line Power lines Connector: 11,1mm*2,1mm:

ELECTRONICS WHAT DOES ‘ELECTRONICS’ MEAN TO YOU ?.

3M Bonding Systems Division Adhesives for Electronics Reliability Study of Sub 100 Micron Pitch, Flex-to-ITO/glass Interconnection, Bonded with an Anisotropic.

Lecture 17 Problems & Solution(1). [1] What is the magnitude of the current flowing in the circuit shown in Fig. 2? [2] A copper wire has resistance 5.

WIRELESS MICROMACHINED CERAMIC PRESSURE SENSORS

Your Hospital What are sensing circuits ?

ALBA Synchrotron – 17 June 2010 Centro Nacional de MicroelectrónicaInstituto de Microelectrónica de Barcelona First Measurements on 3D Strips Detectors.

Conductive Textiles Where Electronics Meet Textiles Workshop with Lynne Bruning and Troy Robert Nachtigall Sponsored by Spark Fun and PlugandWear Versione.

Medipix sensors included in MP wafers 2 To achieve good spatial resolution through efficient charge collection: Produced by Micron Semiconductor on n-in-p.

Marc De Vos, Dr Russel Torah, Prof Steve Beeby and Dr John Tudor

CMS ECAL End Cap Meeting CERN 19 June to 23 June 2000 A.B.Lodge - RAL 1 ECAL End Cap High Voltage Cards and 2000 Electrical/Thermal Model. Progress on.

Course Introduction Purpose

EST-DEM R. De Oliveira 20 Dec., ‘04 Production of Gaseous Detector Elements  History of Gas Detectors in Workshop  Fabrication of GEM Detectors  Fabrication.

29-Jun-09H. Henschel DESY (Zeuthen) 1 Frontend Interface Summarize.

Grounding Studies Metal box sensor SVX4/hybrid Analog cable GND(20W)

5. 4 Resolution The impulse can be separated is given by the resolution. The number of impulse can be distinguished in one quadrant of a 50c/s sine wave.

Simulations of various aspects of the PPS Various members of the collaboration, to be enumerated later.

3M Touch Systems © 3M All Rights Reserved 3M CONFIDENTIAL ClearTek II Touch Screen.

Displacement and Motion Measurement

Getting faster bandwidth HervéGrabas Getting faster bandwidth - Hervé Grabas1.

Resistance of a wire. The circuit A V Zero Calibration Zero error calibration. Turn on the meter with nothing connected to it. Note the reading on the.

Investigation of crosstalk in the readout structure of the Beamcal K.Afanaciev.

R&D ON RESISTIVE TECHNOLOGY FOR MICROMEGAS BUKL STEPHAN AUNE 03/06/2015. S.Aune.

Report on dummy detector Equipped with Heater & sensors NA62 GigaTracker Working Group Meeting May 24 th 2011.

Module Radiation Length. Goals Estimate the expected radiation length of a module, based on the design and measurements on as-built modules Determine.

EKT 451 CHAPTER 6 Sensor & Transducers.

G. S. Campbell, C. S. Campbell, D. R. Cobos and M. G. Buehler

전자파 연구실 1. Fundamentals. 전자파 연구실 1.1 Frequency and time Passive circuit elements is emphasized in high speed digital design : Wires, PCB, IC- package.

Marc Anduze first drawings of Ecal eudet module COPIED FROM : Marc Anduze PICTURES FROM : CALICE/EUDET electronic meeting – CERN – 12 July 07.

10 mm is the same as... 1 cm. 20 mm is the same as... 2 cm.

FINAL YEAR PROJECT.

SAR ADC Power Scaling TIPL 4601 TI Precision Labs – ADCs

Designing a Circularly Polarized Antenna for EagleSat

Instrumented Walker Status Update 2

CAPACITANCE SENSOR.

FEE Electronics progress

Calibration On pixel calibration capacitor; 20fF

Date of download: 1/3/2018 Copyright © ASME. All rights reserved.

ClearTek II Touch Screen

INSTRUMENTASI INDUSTRI

Surface Capacitive Technology (SCT)

Electric Current.

Technic Conductivity Test Apparatus

Mimosa18 on PCB (from the chip side)

LPKF Laser Direct Structuring System

NPS mechanical design 11/13/2018 Jlab meeting

Thin Film Applications

ClearTek II Touch Screen

Measuring Permittivity

Chapter 28 Problems 2,6,8,9,15,20,21,36,40.

Presentation transcript:

2008 Progress Seminar 유방암 자가 진단기 Subtitle 1 Subtitle 2 (발표자이름) (날짜)

Abstract 유방암 자가진단 (not only at clinics) magnified pressure LCD Probe x9 Conventional Pressure sensor (Force Sensor Resistor) LCD 4.5cm 4.5cm Flexible PCB (copper) Breast Capacitive Pressure Sensor Fabric Sensor (Silver Paste) 유방암 자가진단 (not only at clinics) magnified pressure

Conventional Sensor LCD 저항으로 이루어진 센서 문제점 Debugging 완료. Probe x9 Conventional Pressure sensor (FSR) LCD 4.5cm 4.5cm Breast 저항으로 이루어진 센서 문제점 Debugging 완료. 2x8 array sensors Progress ADC, calibration 중 Pressure mapping needed after.

Fabric Sensor LCD Capacitive Pressure Sensor Progress Probe LCD Capacitive Pressure Sensor Progress Circuit design 중. Consider Fabric Unstable  Reproduce/ use FPCB 4.5cm 4.5cm Breast Fabric Sensor (silver paste) Line pitch

Fabric Sensor Reduce crosstalk and wiring error from 20% to 1% 6mm Capacitance measured: 3.5pF (uncompressed) to 5.8pF(5N/cm^2)

Fabric Sensor Capacitance measured: 3.5pF (uncompressed) to 5.8pF(5N/cm^2) Electrode array – silver coated yarn Compressible Spacer – 6mm thickness, 50% compressibility at 1.8N/cm^2 <<Muller Textil>> Shielding – EMI – conductive grounding pads Electrode array – silver paste on the fibre Metalized nylon fibres Compressible Spacer – 3mm thickness, 50% compressibility at 1.8N/cm^2 <<Muller Textil>>

Fabric Sensor Circuit Bandpass Filter? AD7745 Capacitance to digital converter Sine(Triangle) wave oscillator

Flexible PCB LCD Capacitive Pressure Sensor Probe Flexible PCB (copper) LCD 4.5cm 4.5cm Breast Capacitive Pressure Sensor 10x10 copper line – ADC MUX 연결 dielectric 제질: 폴리 이미드 사용 Progress 2pF difference Fabric circuit 완성되면 apply to the FPCB as well.