A lidded box with a snug fitting lid “Bobbin Box” A lidded box with a snug fitting lid

Simple Steps Eight side the stock Round the stock Apply glue block True glue block Apply second and true. Layout lid. Remove lid.

Simple Steps …… Turn lid and create groove Finish the interior of the lid. Mount the bottom Hollow, create the tenon. (tendon) Finish the interior Allow to cure Fit the lid, using wax.

Simple Steps ….. Bring up the soft touch* Shape the lid and box Sand to finish. Remove from glue block Create jamb chuck Detail the bottom of box.

Mount on glue block

True face and add second block

Part off top third

Lay out center and edges

Hollow Center, add recess

Mount base, layout from top

Hollow Center, Sand Chatter?

Create tenon

Add groove for “O” Ring

Add “O” Ring and fit lid

Install Lid and begin shaping

Bring up a “soft touch” tip

Shape lid to suit

Secure lid for finishing

Create a jamb chuck

Bring up a “Soft Touch”

To reshape, sand, finish.

The Bobbin Box