Fig. 5 Zn-air battery performance of pfSAC-Fe.

Slides:

Advertisements

Similar presentations

Fig. 5 MicroLED array with 3D liquid metal interconnects.

Advertisements

Fig. 4 Ballistic simulation of BP FETs.

Fig. 3 The electrical contact of direct-printed and reconfigured liquid metals. The electrical contact of direct-printed and reconfigured liquid metals.

Fig. 2 Global production, use, and fate of polymer resins, synthetic fibers, and additives (1950 to 2015; in million metric tons). Global production, use,

Fig. 4 INS spectra of different human bones from the Roman period [humerus, ulna, femur, and fibula from the same skeleton, Guidonia-Montecelio, Italy.

Fig. 3 Vibrational spectra of human bones from the Copper Age (Scoglietto cave, Italy). Vibrational spectra of human bones from the Copper Age (Scoglietto.

Vibrational spectra of medieval human bones (Leopoli-Cencelle, Italy)

Fig. 2 EL performance of tBCzHxPO- and tBCzMxPO-based TADF diodes.

Fig. 5 Thermal conductivity of n-type ZrCoBi-based half-Heuslers.

Fig. 6 Thermoelectric figure of merit of ZrCoBi-based half-Heuslers and measured heat-to-electricity conversion efficiency. Thermoelectric figure of merit.

Fig. 1 Map of water stress and shale plays.

Fig. 1 Examples of experimental stimuli and behavioral performance.

Fig. 1 Wireless, battery-free neural cuff for programmable pharmacology and optogenetics. Wireless, battery-free neural cuff for programmable pharmacology.

Fig. 4 Complete separation of water and solute after stable and efficient solar evaporation. Complete separation of water and solute after stable and efficient.

Fig. 4 Resynthesized complex boronic acid derivatives based on different scaffolds on a millimole scale and corresponding yields. Resynthesized complex.

HT synthesis of boronic acids using the building block approach

Fig. 6 Comparison of properties of water models.

Fig. 1 Mean and median RCR (Relative Citation Ratio) of Roadmap Epigenomics Program research articles for each year. Mean and median RCR (Relative Citation.

Fig. 2 Influence of the Roadmap Epigenomics Program on the field of epigenomics research. Influence of the Roadmap Epigenomics Program on the field of.

Fig. 3 Glucose- and structure-dependent insulin release.

Fig. 3 Scan rate effects on the layer edge current.

Fig. 3 Rotation experiment, setup.

Fig. 1 Product lifetime distributions for the eight industrial use sectors plotted as log-normal probability distribution functions (PDF). Product lifetime.

Fig. 5 Structural photocycle for DmCry.

FTIR-ATR spectra of Neolithic faunal bones (Mora Cavorso cave, Italy)

Fig. 5 Electrochemical performance of stretchable aqueous rechargeable lithium-ion battery using a GAP multilayer conductor as a current collector. Electrochemical.

Fig. 1 Distribution of total and fake news shares.

Fig. 2 2D QWs of different propagation lengths.

Electrochemical characterization of pV4D4-coated silicon electrodes

Fig. 3 ET dynamics on the control and treatment watersheds during the pretreatment and treatment periods. ET dynamics on the control and treatment watersheds.

Fig. 2 OER performance of ACoO3 (A = Ca, Sr), RuO2, LaCoO3, and Co3O4.

Fig. 1 Histograms of the number of first messages received by men and women in each of our four cities. Histograms of the number of first messages received.

Fig. 5 Schematic phase diagrams of Ising spin systems and Mott transition systems. Schematic phase diagrams of Ising spin systems and Mott transition systems.

Fig. 4 OER performance of ACoO3 (A = Ca, Sr) in alkaline solutions with different pH. OER performance of ACoO3 (A = Ca, Sr) in alkaline solutions with.

Fig. 1 Average contribution (million metric tons) of seafood-producing sectors, 2009–2014. Average contribution (million metric tons) of seafood-producing.

Fig. 4 The mechanical performances of thermally stable click-ionogels.

Fig. 4 Praying Prophet by Lorenzo Monaco: Mapping lake pigments and associated substrate. Praying Prophet by Lorenzo Monaco: Mapping lake pigments and.

Nanoparticle-enabled grain refinement in other materials systems

Fig. 2 Magnetic properties of FGT/Pt bilayer.

Fig. 3 Characterization of the current-induced effective fields.

Fig. 3 Production of protein and Fe(II) at the end of growth correlated with increasing concentrations of ferrihydrite in the media that contained 0.2.

Fig. 2 Schematic drawings of Göbekli Tepe skulls.

Fig. 4 SPICE simulation of stochasticity.

Fig. 2 NH3, NOx, SO2, and NMVOC emission changes triggered by the JJJ clean air policy. NH3, NOx, SO2, and NMVOC emission changes triggered by the JJJ.

Fig. 4 Projected [CO2]-induced deficits in protein and minerals (Fe and Zn) and cumulative changes in vitamin B and cumulative changes in vitamin E derived.

by Yan Feng, Hui Liu, and Jun Yang

Fig. 5 Comparison of the liquid products generated from photocatalytic CO2 reduction reactions (CO2RR) and CO reduction reactions (CORR) on two catalysts.

Schematic of the proposed brain-controlled assistive hearing device

Fig. 1 Catalytic performance of Pd/Al2O3 catalysts with different particle sizes in aerobic oxidation of benzyl alcohol. Catalytic performance of Pd/Al2O3.

Fig. 1 Location of the Jirzankal Cemetery.

Fig. 4 CO2 emission changes triggered by the JJJ clean air policy.

Fig. 1 Structural and electrical properties of Bi2Se3/BaFe12O19.

Multiplexed four- and eight-channel devices for rapid processing

Fig. 3 Comparisons of NDVI trends over the globally vegetated areas from 1982 to Comparisons of NDVI trends over the globally vegetated areas from.

Fig. 3 Electronic conductivity studies.

Fig. 1 Schematic depiction of a paradigm for rapid and guided discovery of materials through iterative combination of ML with HiTp experimentation. Schematic.

Fig. 3 Electrochemical performances of symmetric cells using control Li and composite Li electrodes. Electrochemical performances of symmetric cells using.

Fig. 4 Spatial mapping of the distribution and intensity of industrial fishing catch. Spatial mapping of the distribution and intensity of industrial fishing.

Fig. 3 Device architecture, photovoltaic performance, and operational stability of 3D/2D bilayer PSCs. Device architecture, photovoltaic performance, and.

Fig. 3 Structural variation under various dc voltages applied on the same one single crystal of FJU-23-H2O along the c axis. Structural variation under.

Fig. 4 Single-particle contact angle measurements.

Fig. 5 Density plots showing the relationship between growth responses to extreme events and site-level mean precipitation from all sites (N = 1314). Density.

Fig. 3 Performance of the generative model G, with and without stack-augmented memory. Performance of the generative model G, with and without stack-augmented.

Fig. 4 Behavior of resistance peak near density nm = 5.

Fig. 2 Comparison between the different reflective metasurface proposals when θi = 0° and θr = 70°. Comparison between the different reflective metasurface.

Fig. 4 Effects of individual picosecond and microsecond pulses.

Fig. 3 Calculated electronic structure of ZrCoBi.

Fig. 4 Electrochemical mechanism studies.

Fig. 1 The combination of PCET and an RNR class I reaction enables heteroarene C─H alkylation using ketones and aldehydes as alkyl radical equivalents.

Fig. 3 Temperature-dependent heat capacity of YbTM2Zn20.

Presentation transcript:

Fig. 5 Zn-air battery performance of pfSAC-Fe. Zn-air battery performance of pfSAC-Fe. (A) A schematic configuration of the homemade Zn-air battery. (B) Open circuit plot of the Zn-air battery using pfSAC-Fe-0.2 as catalyst. (C) Comparison of polarization and power density curves using Pt/C and pfSAC-Fe-0.2 as catalysts. (D) Comparison of specific capacities of the Zn-air batteries. (E) Long-term discharge/charge cycling performance of Zn-air batteries with Pt/C and pfSAC-Fe-0.2 as the ORR catalyst and IrO2 as the oxygen evolution reaction catalyst at a current density of 5 mA cm−2. Inset: Voltage efficiency (VE) of Zn-air batteries based on pfSAC-Fe-0.2 during the cycling test. (F) Cycle discharge curves of pfSAC-Fe-0.2–driven Zn-air batteries at periodically changed current densities of 5, 10, 20, and 40 mA cm−2. (G) Discharge curves of Zn-air batteries using Pt/C and pfSAC-Fe-0.2 at current densities of 100 mA cm−2. For each battery, a Zn plate was used as the anode, and 8 M KOH + 0.5 M ZnO was used as the electrolyte. All of the catalytic mass loading is at 0.2 mg cm−2. Peng Peng et al. Sci Adv 2019;5:eaaw2322 Copyright © 2019 The Authors, some rights reserved; exclusive licensee American Association for the Advancement of Science. No claim to original U.S. Government Works. Distributed under a Creative Commons Attribution NonCommercial License 4.0 (CC BY-NC).