Ventilation protocol. Ventilation protocol. The PEEP group raised peak inspiratory pressure (PIP) through 5-cm H2O PEEP increments every 2 min while keeping.

Slides:



Advertisements
Similar presentations
Effect of nasal positive expiratory pressure (PEP) on 6-min walk test (6MWT) distance and pre- to post-exercise increase in lung volumes in each individual.
Advertisements

The patient is being ventilated with 2 types of breaths.
The changes in peak flow and inspiratory time between a minimum rise time (first 2 breaths) and a maximum rise time (last 2 breaths), with the Servo-i.
Airway pressure and flow waveforms during constant flow volume control ventilation, illustrating the effect of an end-inspiratory breath-hold. Airway pressure.
Trigger pressure-time product (PTP) with zero pressure support, with no leak, medium leak, and large leak. Trigger pressure-time product (PTP) with zero.
Relationship between the recruited volume and the arithmetic mean of the ratios of lung density at PEEP 15 cm H2O to lung density at PEEP 5 cm H2O (μP15/P5)
Matrix used to calculate the kappa statistic.
Lung simulator diagram of airway pressure release ventilation (APRV): volume (yellow), lung pressure (white), and flow (orange)/time curve. Lung simulator.
Trigger delays and leaks.
Picture of bubble PEP devices.
Flow chart of pressure support test and spontaneous breathing trial (SBT). Flow chart of pressure support test and spontaneous breathing trial (SBT). The.
Even though this patient is undergoing positive-pressure mechanical ventilation, the first 4 breaths have a relatively negative pressure (ie, pressure.
A: Pressure (green) and volume (black)/time curve in airway pressure release ventilation (APRV). A: Pressure (green) and volume (black)/time curve in airway.
An example of delayed cycling during pressure-support ventilation of a patient with COPD, on a Puritan Bennett 7200 ventilator, which has a flow-termination.
Box plots comparing peak inspiratory pressures (PIP) causing the 4 main experimental outcomes: bradycardia, hypotension, asystole, and pneumothorax. Box.
At time zero, a water column of 10 cm H2O was poured above the tested endotracheal tube (ETT) cuffs. At time zero, a water column of 10 cm H2O was poured.
The third breath has a negative deflection (ie, below PEEP) at the end of the mechanical breath (arrow A) associated with a flow increase (arrow B), indicating.
Asynchrony index at baseline and following optimization of pressure support (PS) level (A), and following optimization of mechanical inspiratory time (mechanical.
Likert-scale agreement ratings regarding the use of extubation readiness parameters by pediatric critical care physicians. Likert-scale agreement ratings.
Simulated screenshot of flow starvation in volume control continuous mandatory ventilation. Simulated screenshot of flow starvation in volume control continuous.
Characteristics of a pressure-supported breath.
The peak flows (60 L/min) and flow patterns are the same for all the breaths. The peak flows (60 L/min) and flow patterns are the same for all the breaths.
Sensitivity, Specificity, Positive Predictive Value, Negative Predictive Value, Area Under the Curve, and 95% CIs for the 0, 10, 25, 50, and 100 SatSeconds.
Representative tracings of transcutaneous CO2 (PtcCO2), Spo2, and heart rate during an apnea test designed to raise Paco2 to 100 mm Hg. At baseline, PtcCO2.
During this tracing of 30 seconds, the ventilator displays that the patient rate is 16 breaths/min. During this tracing of 30 seconds, the ventilator displays.
Comparison of airway pressure release ventilation (APRV) (blue curve) and biphasic positive airway pressure (BIPAP) (black curve). Comparison of airway.
Trigger and synchronization windows.
Whisker plot of expiratory pressure-time product: Direct comparison of expiratory pressure-time product (PTPEXP) in face mask versus helmet in all tested.
Top: Stress index (SI) in a patient early in the course of ARDS
A 2-min recording showing periodic breathing, stable delivered pressure, and fluctuating oxygen saturation in a premature neonate supported by nasal intermittent.
This tracing depicts 30 seconds of information.
Graphic representation of a dynamic airway pressure scalar during volume control ventilation with a constant inspiratory flow. Graphic representation of.
Work rate as a function of pressurization rate and cycling-off threshold, during pressure-support ventilation of (A) patients with acute lung injury (ALI),
In supine obese people, the weight of the abdomen pushes against the diaphragm, causing a cranial displacement of the muscle. In supine obese people, the.
Flow, esophageal pressure, airway pressure, and transpulmonary pressure can be used to calculate respiratory system compliance, chest-wall compliance,
Esophageal pressure, airway pressure, and transpulmonary pressure (PL) with PEEP set at 26 cm H2O (same patient as Fig. 24). Esophageal pressure, airway.
Negative pressures calculated with the Rosen and Hillard formula
We connected the supplemental oxygen supply at 3 places: near the ventilator, near the exhalation valve, and on the nasal mask port. We connected the supplemental.
Control circuit for an adaptive pressure targeting scheme (eg, Pressure Regulated Volume Control). Control circuit for an adaptive pressure targeting scheme.
Changes in PaO2/FIO2 (A) and PaCO2 (B).
Carbon monoxide (CO) delivery system used in animal models and Phase 1 clinical trials. Carbon monoxide (CO) delivery system used in animal models and.
Change in mean pulmonary arterial pressure after a 5-min inhalation of the Rho kinase inhibitor Y in rats with hypoxic pulmonary hypertension, with.
The Boussignac continuous positive airway pressure (CPAP) is a small plastic cylinder that attaches to a face mask. The Boussignac continuous positive.
Control circuit for set-point or dual targeting schemes.
Study protocol. Study protocol. Subjects with hemodynamic, respiratory, and neurologic stability and positive predictive index were randomized to 3 groups.
Control circuit for a servo targeting scheme (eg, Proportional Assist Ventilation). Control circuit for a servo targeting scheme (eg, Proportional Assist.
Inspiratory time in excess (TIex) with the 10 ventilators tested under 3 conditions: in the absence of leaks and with the NIV algorithm deactivated (L0NIV0),
A: Pressure ulcer on the left cheek of a patient after 1 week of prone positioning using a commercially available endotracheal tube (ETT) holder. A: Pressure.
Kaplan-Meier curve for the probability of noninvasive ventilation (NIV) failure relative to continuous use of NIV and stratified for Acute Physiology and.
The cause of asynchrony during volume-targeted ventilation and total asynchrony index. The cause of asynchrony during volume-targeted ventilation and total.
SpO2 at baseline, pre- and post-intubation.
Calculated negative pressure developed in the lung plotted against the outside diameter of the suction catheter to the inside diameter of the airway. Calculated.
Flow, airway pressure, and transversus abdominis electromyogram (EMG) waveforms from a mechanically ventilated patient with COPD receiving pressure-support.
Components of a patient-triggered mechanical breath.
FEV1 and FVC for the control group (without noninvasive ventilation [NIV]), NIV with an inspiratory pressure (IPAP) of 15 cm H2O and expiratory pressure.
Determinants of patient-ventilator interaction.
Correlation between maximum inspiratory pressure and inspiratory load compensation (ILC) ventilatory variables in the 16 difficult-to-wean subjects, prior.
Airway pressure and flow graphics illustrate delayed cycling.
Sequence plot visualizing the development of symptom frequency for the cohort at the individual level between 2006 and Sequence plot visualizing.
Inspiratory load compensation responses before and after inspiratory muscle strength training (IMST) in the unweaned versus weaned subjects, with a 10.
The changes in peak flow and inspiratory time between a minimum rise time (first 2 breaths) and a maximum rise time (last 2 breaths), with the Servo-i.
Representative tidal volume (VT) and breathing frequency (f) patterns of subjects with COPD and normal subjects during cardiopulmonary exercise testing.
Experimental setup. Experimental setup. Each tested ventilator was connected to the TTL test lung via a ventilator circuit. An oxygen analyzer, a pressure.
Progression of spontaneous breathing trials administered during inspiratory muscle strength training study interventions. Progression of spontaneous breathing.
For inspiratory load compensation testing, this threshold positive expiratory pressure (PEP) training device was inverted and connected to a respiratory.
Difference between mid-frequency ventilation (MFV), volume control continuous mandatory ventilation (VC-CMV), and pressure control CMV (PC-CMV) when frequency.
Percent of extremely-low-birth-weight (ELBW) babies alive and off mechanical ventilation at 7 days, and median days on mechanical ventilation for ELBW.
Minute-by-minute means of breathing variables during the spontaneous breathing trial for the groups of subjects with trial success (n = 32) and failure.
Representative waveforms for each of the devices tested from which the oscillatory f was counted. Representative waveforms for each of the devices tested.
Setup of the BiPAP Synchrony with an inspiratory filter and single-limb passive circuit, with the filter placed over the fixed leak to collect aerosol.
Presentation transcript:

Ventilation protocol. Ventilation protocol. The PEEP group raised peak inspiratory pressure (PIP) through 5-cm H2O PEEP increments every 2 min while keeping a fixed inspiratory driving pressure of 15 cm H2O. There is no current anesthesia workstation available supporting PEEP levels >50 cm H2O; therefore, breaking the fixed inspiratory driving pressure was necessary in those animals that already had reached PEEP of 50 cm H2O without signs of pneumothorax. In those cases, PIP was increased directly while keeping PEEP constant at 50 cm H2O. Patricio González-Pizarro et al. Respir Care 2016;61:142-148 (c) 2012 by Daedalus Enterprises, Inc.