Chapter 4 Field-Effect Transistors

Slides:



Advertisements
Similar presentations
Lecture Metal-Oxide-Semiconductor (MOS) Field-Effect Transistors (FET) MOSFET Introduction 1.
Advertisements

MICROWAVE FET Microwave FET : operates in the microwave frequencies
Transistors (MOSFETs)
The metal-oxide field-effect transistor (MOSFET)
Week 8b OUTLINE Using pn-diodes to isolate transistors in an IC
Chap. 5 Field-effect transistors (FET) Importance for LSI/VLSI –Low fabrication cost –Small size –Low power consumption Applications –Microprocessors –Memories.
Qualitative Discussion of MOS Transistors. Big Picture ES220 (Electric Circuits) – R, L, C, transformer, op-amp ES230 (Electronics I) – Diodes – BJT –
ECE 342 Electronic Circuits 2. MOS Transistors
EE213 VLSI Design S Daniels Channel Current = Rate of Flow of Charge I ds = Q/τ sd Derive transit time τ sd τ sd = channel length (L) / carrier velocity.
Chapter 5: Field Effect Transistor
1 Metal-Oxide-Semicondutor FET (MOSFET) Copyright  2004 by Oxford University Press, Inc. 2 Figure 4.1 Physical structure of the enhancement-type NMOS.
Chapter 4 Field-Effect Transistors
1 Fundamentals of Microelectronics  CH1 Why Microelectronics?  CH2 Basic Physics of Semiconductors  CH3 Diode Circuits  CH4 Physics of Bipolar Transistors.
Metal-oxide-semiconductor field-effect transistors (MOSFETs) allow high density and low power dissipation. To reduce system cost and increase portability,
Field Effect Transistor (FET)
MOS Capacitor Lecture #5. Transistor Voltage controlled switch or amplifier : control the output by the input to achieve switch or amplifier Two types.
Chapter 13 Small-Signal Modeling and Linear Amplification
Microelectronic Circuit Design McGraw-Hill Chapter 4 Field-Effect Transistors Microelectronic Circuit Design Richard C. Jaeger Travis N. Blalock.
EE314 IBM/Motorola Power PC620 IBM Power PC 601 Motorola MC68020 Field Effect Transistors.
The Devices: MOS Transistor
UNIT II : BASIC ELECTRICAL PROPERTIES
Chapter 6 The Field Effect Transistor
MAHATMA PHULE A.S.C. COLLEGE, PANVEL Field Effect Transistor
Government Engineering College,
Electronics The Sixteenth and Seventh Lectures
MOS Capacitance Unit IV : GATE LEVEL DESIGN VLSI DESIGN 17/02/2009
Field Effect Transistors
Chapter 2 MOS Transistors.
MOSFET The MOSFET (Metal Oxide Semiconductor Field Effect Transistor) transistor is a semiconductor device which is widely used for switching and amplifying.
MOS Field-Effect Transistors (MOSFETs)
FIELD EFFECT TRANSISTOR
EMT 112 / 4 ANALOGUE ELECTRONICS
Recall Last Lecture Common collector Voltage gain and Current gain
Chapter 2 Field-Effect Transistors (FETs) SJTU Zhou Lingling.
DMT 241 – Introduction to IC Layout
Revision CHAPTER 6.
Lecture 20 OUTLINE The MOSFET (cont’d) Qualitative theory
Introduction to Metal-Oxide-Semiconductor Field Effect Transistors (MOSFETs) Chapter 7, Anderson and Anderson.
Intro to Semiconductors and p-n junction devices
Semiconductor Transistors
3: CMOS Transistor Theory
6.3.3 Short Channel Effects When the channel length is small (less than 1m), high field effect must be considered. For Si, a better approximation of field-dependent.
MOS Field-Effect Transistors (MOSFETs)
ترانزیستور MOSFET دکتر سعید شیری فصل چهارم از:
Lecture 16 ANNOUNCEMENTS OUTLINE MOS capacitor (cont’d)
Lecture 19 OUTLINE The MOSFET: Structure and operation
Notes on Diodes 1. Diode saturation current:  
Week 9a OUTLINE MOSFET ID vs. VGS characteristic
منبع: & کتابMICROELECTRONIC CIRCUITS 5/e Sedra/Smith
Reading: Finish Chapter 17,
Transistors (MOSFETs)
Qualitative Discussion of MOS Transistors
MOSFET POWERPOINT PRESENTATION BY:- POONAM SHARMA LECTURER ELECTRICAL
FIELD EFFECT TRANSISTOR
Week 9a OUTLINE MOSFET ID vs. VGS characteristic
EMT 182 Analog Electronics I
LECTURE # 8 FIELD EFFECT TRANSISTOR (FET)
Lecture #17 (cont’d from #16)
Lecture 3: CMOS Transistor Theory
Lecture 20 OUTLINE The MOSFET (cont’d) Qualitative theory
Lecture #15 OUTLINE Diode analysis and applications continued
Lecture 3: CMOS Transistor Theory
Lecture 20 OUTLINE The MOSFET (cont’d)
Lecture 20 OUTLINE The MOSFET (cont’d)
Lecture 3: CMOS Transistor Theory
ELECTRONICS AND SOLID STATE DEVICES-II
Microelectronics, BSc course
Solid State Electronics ECE-1109
Chapter 4 Field-Effect Transistors
Chapter 15 Differential Amplifiers and Operational Amplifier Design
Presentation transcript:

Chapter 4 Field-Effect Transistors Microelectronic Circuit Design Richard C. Jaeger Travis N. Blalock Microelectronic Circuit Design McGraw-Hill

MOS Capacitor Structure First electrode- Gate: Consists of low-resistivity material such as metal or polycrystalline silicon Second electrode- Substrate or Body: n- or p-type semiconductor Dielectric-Silicon dioxide:stable high-quality electrical insulator between gate and substrate. Microelectronic Circuit Design McGraw-Hill

Substrate Conditions for Different Biases Accumulation Depletion Accumulation VG<<VTN Depletion VG<VTN Inversion VG>VTN Inversion Microelectronic Circuit Design McGraw-Hill

Microelectronic Circuit Design Low-frequency C-V Characteristics for MOS Capacitor on P-type Substrate MOS capacitance is non-linear function of voltage. Total capacitance in any region dictated by the separation between capacitor plates. Total capacitance modeled as series combination of fixed oxide capacitance and voltage-dependent depletion layer capacitance. Microelectronic Circuit Design McGraw-Hill

NMOS Transistor: Structure 4 device terminals: Gate(G), Drain(D), Source(S) and Body(B). Source and drain regions form pn junctions with substrate. vSB, vDS and vGS always positive during normal operation. vSB always < vDS and vGS to reverse bias pn junctions Microelectronic Circuit Design McGraw-Hill

NMOS Transistor: Qualitative I-V Behavior VGS<<VTN : Only small leakage current flows. VGS<VTN: Depletion region formed under gate merges with source and drain depletion regions. No current flows between source and drain. VGS>VTN: Channel formed between source and drain. If vDS>0,, finite iD flows from drain to source. iB=0 and iG=0. Microelectronic Circuit Design McGraw-Hill

NMOS Transistor: Triode Region Characteristics for where, Kn= Kn’W/L Kn’=mnCox’’ (A/V2) Cox’’=ox/Tox  ox=oxide permittivity (F/cm) Tox=oxide thickness (cm) Microelectronic Circuit Design McGraw-Hill

NMOS Transistor: Triode Region Characteristics (contd.) Output characteristics appear to be linear. FET behaves like a gate-source voltage-controlled resistor between source and drain with Microelectronic Circuit Design McGraw-Hill

MOSFET as Voltage-Controlled Resistor Example 1: Voltage-Controlled Attenuator If Kn=500mA/V2, VTN=1V, R=2k and VGG=1.5V, then, To maintain triode region operation, or or Microelectronic Circuit Design McGraw-Hill

MOSFET as Voltage-Controlled Resistor (contd.) Example 2: Voltage-Controlled High-Pass Filter Voltage Transfer function, where, cut-off frequency If Kn=500mA/V2, VTN=1V, C=0.02mF and VGG=1.5V, then, To maintain triode region operation, Microelectronic Circuit Design McGraw-Hill

NMOS Transistor: Saturation Region If vDS increases above triode region limit, channel region disappears, also said to be pinched-off. Current saturates at constant value, independent of vDS. Saturation region operation mostly used for analog amplification. Microelectronic Circuit Design McGraw-Hill

NMOS Transistor: Saturation Region (contd.) for is also called saturation or pinch-off voltage Microelectronic Circuit Design McGraw-Hill

Transconductance of a MOS Device Transconductance relates the change in drain current to a change in gate-source voltage Taking the derivative of the expression for the drain current in saturation region, Microelectronic Circuit Design McGraw-Hill

Channel-Length Modulation As vDS increases above vDSAT, length of depleted channel beyond pinch-off point, DL, increases and actual L decreases. iD increases slightly with vDS instead of being constant. l= channel length modulation parameter Microelectronic Circuit Design McGraw-Hill

Depletion-Mode MOSFETS NMOS transistors with Ion implantation process used to form a built-in n-type channel in device to connect source and drain by a resistive channel Non-zero drain current for vGS=0, negative vGS required to turn device off. Microelectronic Circuit Design McGraw-Hill

Transfer Characteristics of MOSFETS Plots drain current versus gate-source voltage for a fixed drain-source voltage Microelectronic Circuit Design McGraw-Hill