Basic setup for high-flow nasal cannula oxygen delivery.

Slides:

Advertisements

Similar presentations

Nitric Oxide Set-up for Patients on Ventilator

Advertisements

Oxygen Therapy Linda Winn, RN, MSN Ed., BA Ed.. Oxygen Medication Requires MD order Side Effects Highly combustible gas Clear Odorless Set-up is part.

Oxygen Therapy Equipment.

Humidification systems for high-flow cannulas.

The patient is being ventilated with 2 types of breaths.

The changes in peak flow and inspiratory time between a minimum rise time (first 2 breaths) and a maximum rise time (last 2 breaths), with the Servo-i.

Airway pressure and flow waveforms during constant flow volume control ventilation, illustrating the effect of an end-inspiratory breath-hold. Airway pressure.

Example ventilator screen during nasal neurally adjusted ventilatory assist in a premature neonate (23 weeks gestational age, 560 g) with respiratory distress.

Spearman rank correlation between absolute humidity and the patient's core temperature with the Humid-Heat device. Spearman rank correlation between absolute.

Schematic illustration of upper airway anatomical dead space volume (VD) during unidirectional breathing. Schematic illustration of upper airway anatomical.

HomeLOX liquid oxygen system, which creates oxygen from a concentrator and refrigerates the concentrator gas to a liquid state, which is stored in a small.

The Spectrum mask incorporates the leak port into the circuit, whereas the Mirage mask incorporates the leak port into the mask. The Spectrum mask incorporates.

High-flow nasal oxygen therapy in intensive care and anaesthesia

Flow chart of pressure support test and spontaneous breathing trial (SBT). Flow chart of pressure support test and spontaneous breathing trial (SBT). The.

Shape-signal method of triggering combines shape signal (A) and volume (B) methods of triggering. Shape-signal method of triggering combines shape signal.

A ventilator and TTL test lung were used to simulate spontaneous breathing. A ventilator and TTL test lung were used to simulate spontaneous breathing.

The high flow nasal cannula (HFNC) system incorporated an air/O2 blender with a flow meter and a heated humidifier. The high flow nasal cannula (HFNC)

Even though this patient is undergoing positive-pressure mechanical ventilation, the first 4 breaths have a relatively negative pressure (ie, pressure.

Noninvasive ventilation-neurally adjusted ventilatory assist (NIV-NAVA) where each patient effort is captured but support is insufficient (maximum electrical.

An example of delayed cycling during pressure-support ventilation of a patient with COPD, on a Puritan Bennett 7200 ventilator, which has a flow-termination.

Use of continuous nasal ventilation in a young man with Duchenne muscular dystrophy and excessively weak buccal musculature. Use of continuous nasal ventilation.

The third breath has a negative deflection (ie, below PEEP) at the end of the mechanical breath (arrow A) associated with a flow increase (arrow B), indicating.

Likert-scale agreement ratings regarding the use of extubation readiness parameters by pediatric critical care physicians. Likert-scale agreement ratings.

Example airway pressure and rib-cage impedance in a premature infant supported with the biphasic mode of SiPAP (“sigh” positive airway pressure) from the.

Simulated screenshot of flow starvation in volume control continuous mandatory ventilation. Simulated screenshot of flow starvation in volume control continuous.

Characteristics of a pressure-supported breath.

The peak flows (60 L/min) and flow patterns are the same for all the breaths. The peak flows (60 L/min) and flow patterns are the same for all the breaths.

A: Machine-triggered intermittent mandatory ventilation (IMV) with inadequate patient triggering of mandatory breaths. A: Machine-triggered intermittent.

Trigger and synchronization windows.

Recommendations from the Pre-hospital Trauma Life Support (PHTLS) manual for FIO2 delivery, based on breathing frequency and FIO2 capabilities of devices.

In this tracing of 30 seconds, 4 breaths are ineffectively triggered (arrows IT) and 7 are effectively triggered. In this tracing of 30 seconds, 4 breaths.

Methods for measurement of total lung capacity (TLC) and residual volume (RV) via body plethysmography. Methods for measurement of total lung capacity.

A 2-min recording showing periodic breathing, stable delivered pressure, and fluctuating oxygen saturation in a premature neonate supported by nasal intermittent.

This tracing depicts 30 seconds of information.

Effect of respiratory mechanics on cycling of pressure support from inhalation to exhalation. Effect of respiratory mechanics on cycling of pressure support.

Flow, esophageal pressure, airway pressure, and transpulmonary pressure can be used to calculate respiratory system compliance, chest-wall compliance,

We connected the supplemental oxygen supply at 3 places: near the ventilator, near the exhalation valve, and on the nasal mask port. We connected the supplemental.

Control circuit for an adaptive pressure targeting scheme (eg, Pressure Regulated Volume Control). Control circuit for an adaptive pressure targeting scheme.

Changes in PaO2/FIO2 (A) and PaCO2 (B).

Blom speech cannula. Blom speech cannula. Inspiratory pressure opens the flap valve and closes (expands) the bubble valve, sealing the fenestration so.

Carbon monoxide (CO) delivery system used in animal models and Phase 1 clinical trials. Carbon monoxide (CO) delivery system used in animal models and.

The Boussignac continuous positive airway pressure (CPAP) is a small plastic cylinder that attaches to a face mask. The Boussignac continuous positive.

Control circuit for set-point or dual targeting schemes.

Assembly used to convert a standard ventilator to an intermittent mandatory ventilation circuit. Assembly used to convert a standard ventilator to an intermittent.

Breathing frequency and PaCO2: comparison between high-flow nasal cannula oxygen therapy (HFNC) and comparative therapies in 8 studies. Breathing frequency.

Control circuit for a servo targeting scheme (eg, Proportional Assist Ventilation). Control circuit for a servo targeting scheme (eg, Proportional Assist.

A: ECMO circuit tubing with component pieces in place, configured with a centrifugal pump. A: ECMO circuit tubing with component pieces in place, configured.

A: Evolution of clinically observed signs after 38 patients received high-flow nasal cannula oxygen. A: Evolution of clinically observed signs after 38.

Total drug dose by device and condition while delivering 1 mL of ribavirin (5 min for the small-particle aerosol generator [SPAG] or 2 min for the vibrating.

Experimental setup of particle distribution using the 8-stage Andersen cascade impactor and in vitro module using an absolute filter. Experimental setup.

SpO2 at baseline, pre- and post-intubation.

Mean inspiratory work of breathing during assisted breaths and spontaneous breaths across the spectrum of ventilatory support continuous mandatory ventilation.

Bland-Altman analysis of the end-tidal carbon dioxide concentration (PETCO2) during resting (A), with mouth closed (B), and during deep breathing (C) while.

Components of a patient-triggered mechanical breath.

FEV1 and FVC for the control group (without noninvasive ventilation [NIV]), NIV with an inspiratory pressure (IPAP) of 15 cm H2O and expiratory pressure.

Determinants of patient-ventilator interaction.

Physical variables affecting FIO2 of nasal cannula with increasing breathing frequency (f), at flows from 1–5 L/min. Physical variables affecting FIO2.

The Global Initiative for Chronic Obstructive Lung Disease (GOLD) ABCD scheme for classifying patients with COPD with separate appraisal of air-flow limitation.

A: Work of breathing before and after nebulized terbutaline delivered via standard nebulization method versus delivered during continuous positive airway.

The changes in peak flow and inspiratory time between a minimum rise time (first 2 breaths) and a maximum rise time (last 2 breaths), with the Servo-i.

Representative tidal volume (VT) and breathing frequency (f) patterns of subjects with COPD and normal subjects during cardiopulmonary exercise testing.

Experimental setup. Experimental setup. Each tested ventilator was connected to the TTL test lung via a ventilator circuit. An oxygen analyzer, a pressure.

Progression of spontaneous breathing trials administered during inspiratory muscle strength training study interventions. Progression of spontaneous breathing.

Boundary graph for prescription flow (Qp) and supply flow (Qs).

Efficiency of aerosol bronchodilator delivery during continuous high-flow system at different CPAP and flow levels. Efficiency of aerosol bronchodilator.

Enhancing flow synchrony with a variable flow, pressure-targeted breath. Enhancing flow synchrony with a variable flow, pressure-targeted breath. In the.

Lung model expiratory CO2 (or PETOv2) representing simulated alveolar CO2 at baseline (no high-flow nasal cannula) and effect on expiratory CO2 at different.

Arterial blood gas measurement of oxygen tension.

Minute-by-minute means of breathing variables during the spontaneous breathing trial for the groups of subjects with trial success (n = 32) and failure.

Setup of the BiPAP Synchrony with an inspiratory filter and single-limb passive circuit, with the filter placed over the fixed leak to collect aerosol.

Presentation transcript:

Basic setup for high-flow nasal cannula oxygen delivery. Basic setup for high-flow nasal cannula oxygen delivery. An air-oxygen blender, allowing from 0.21 to 1.0 FIO2, generates up to 60 L/min flow. The gas is heated and humidified through an active heated humidifier and delivered via a single-limb heated inspiratory circuit. The patient breathes adequately heated and humidified medical gas through large-diameter nasal cannulas. (Modified from Reference 9.)‏ Masaji Nishimura Respir Care 2016;61:529-541 (c) 2012 by Daedalus Enterprises, Inc.