HOW TO READ A SCALE RULER

Slides:

Advertisements

Similar presentations

PAPER HOUSES Create a 3D House or Cabin.

Advertisements

Benchmark Locate rational numbers on a number line. ~ locate decimal numbers on a number line.

Modern Language Association of America

Using the Scale Ruler What is Scale? What are all these tiny lines anyway?

BCT 102 Printreading Architect Civil Engineer Reading & Scale Use.

MODULE THREE SCALES AND DIMENSIONS

Integers 6.3 So what is an integer? Set of whole numbers (this includes zero) and their opposites {…-3,-2,-1, 0, 1, 2, 3…} An integer and its opposite.

SCIENCE JOURNAL 10/24/ st PAGE MY SCIENCE JOURNAL BY __________________.

Warm Up #7 (Page 28) 10/9/2014 Round the following numbers to 2 significant figures (Write the question) 1) g 2) 124,000 m 3)1.25 cm Perform the.

 Every integer has an opposite integers. A number and its opposite are the same distance from zero.

Golden Rule of Algebra:

Integer Introduction. Warm Up Write each decimal as a fraction. 1.) 1.8 = 2.) = 3.).008 = 4.).85 =

Header (unit) 1) Vertical. Your data table should have columns at the top and the data should be underneath the columns. The data table should not be horizontal.

Multiplying and Dividing Decimals by 10, 100, and 1,000

Rulers or Tape Measures

$100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300 $400 $500 $100 $200 $300.

Interactive Student Notebook “ISN“. Materials Needed Spiral notebook Pen Ruler Markers.

Comparing and Ordering Decimals. Using Models If you are comparing tenths to hundredths, you can use a tenths grid and a hundredths grid. Here, you can.

Measurement. 3 Parts to Measurement: 1. a numeric value 2. a unit 3. an estimation of the amount of error.

Spacing between the Body and the Figures and Tables. There should be 3 blank spaces in between the Figure’s caption and the content of the thesis and dissertation.

Warm Up Compare. Use, or = > < > Course Integers >

How many significant digits? 5700 A.1 B.2 C.3 D.4.

Cornell Notes Language Arts. Forgetting curve In AVID, we often reference the work from the University of Waterloo around the forgetting curve. forgetting.

Meters, Liters, and Grams. Oh, My! T. Trimpe 2008

Course Integers The opposite of a number is the same distance from 0 on a number line as the original number, but on the other side of 0. Zero is.

Modeling Equations Lab Name________________________ Directions: Model each problem on your equation mats with the tiles. Then, record your work on this.

Integers Compare and ordering.

Trail Making The following pages contain the forms used in the trail making test. If your pages are thick and you can’t see through to images on the reverse.

Paper Format How to make your paper legit according to the MLA (Modern Language Association)

Reading a Ruler.

Measurement Imperial System Foot (‘) – Inch (“)

Solving Addition and Subtraction Equations Lesson 6-2 Page 225.

All About Rulers!. Facts: One ruler has 12 inches and about 30 centimeters. 12 inches equals 1 foot…. Not this kind of foot:

Below is an FCAT 2.0 Ruler.. Measure starting from the edge of the ruler rather than at zero. In real life rulers may vary and the measurement may start.

How to read a ruler. 1 inch is split into 16 increments. Usually, you’ll see a 1/16 on a ruler.

Conversion Graphs Learning Objective: Be able to use conversion graphs. 27/01/10.

Learn How To Read a Ruler in Just a Few Steps. ONE FOOT = 12 INCHES As you can see there are 12 inches in one foot ~As a side note, there are 3 feet in.

HHP Writing Standards 7 th Grade Language Arts. USE THESE STANDARDS FOR HANDWRITTEN AND WORD PROCESSED FINAL COPIES OF ALL WRITTEN ASSIGNMENTS USE THESE.

Attend to Precision © 2012 Project Lead The Way, Inc.Introduction to Engineering Design.

US Customary Measurement System

Comparing Rational Numbers

Gateway – Unit 7 – Green Architecture

Applications of technology

The Architect’s Scale.

Metric Measurement Lesson

Our Math Measurement Lesson

US Customary Measurement System

Integers and Opposites on a Number Line Guided Notes

THE CORNELL NOTE TAKING SYSTEM

Graphing Rules: According to DRTAILSS

Replacement Grade for Heating Curve Graph

US Customary Measurement System

US Customary Measurement System

US Customary Measurement System

Objective Describe the drawing equipment needed to produce a scaled drawing of an agricultural engineering project.

Introduction to Significant Figures &

NOTEBOOK SETUP Science

Chapter 4.1 Inequalities.

RATIONAL FUNCTIONS CARD SORT FOR TRANSFORMATIONS

US Customary Measurement System

How to Format Your Paper

Record your QUESTIONS as your read.

Header (unit) 1) Vertical. Your data table should have columns at the top and the data should be underneath the columns. The data table should not be.

The Cycle of Proof: Dealing with Data

SPRING TIME LINE RUBRIC

Intermittent Fillet Welds

Presentation transcript:

HOW TO READ A SCALE RULER

Locate appropriate scale factor at end of scale ruler

Place line or object to be measured at zero

Read measurements from side of scale factor to end of line or object Scale factor on left = Read measurements from left to right

Scale factor on right = Read measurements from right to left

Be careful to read measurements from lowest to greatest (ascending) order

Be careful not to read measurements from scale factor from other end of scale ruler

To measure foot increment, move scale ruler to lowest foot increment and record

To measure inch increment, measure line or object from left of zero (scale factor on left) or right of zero (scale factor on right) Note: Measurements from zero to scale factor are 12 inches or 1 foot

Determine measurements by determining 3”, 6” and 9” increments first

Record measurement in foot and inches Record measurement in foot and inches. Do not forget symbols for foot ( ‘ ) and inches ( “ )

Name: ____________________________

Date: ____________________________

HOW TO READ A SCALE RULER

Complete problems on Pages 1 – 3 below Complete problems on Pages 1 – 3 below. Do not forget correct units (otherwise wrong)

Measure line according to appropriate scale and record in space provided.