Field Proven Performance – Industrial Grade Support DATA-LINC GROUP Field Proven Performance – Industrial Grade Support DD(AA)1000 & PLR580D(A) W IRELESS I/O E XTENDERS Released: 2012/02/13

2  PLR5000 radio based products  PLR580D – discrete  PLR580DA – discrete & analog  SRM radio based products  DD1000/SRM – discrete  DDAA1000/SRM – discrete & analog P RODUCTS

3 I NDICATOR L IGHTS

4 B LOCK D IAGRAM

5 D ISCRETE I/O  Inputs  Self-sensing, no external power required  G – shared common  Outputs  Open collector transistor, requires 12 or 24VDC power  G – shared common (emitters)  On RF signal loss and by configuration, the outputs will go OFF or hold last vallue

6 D ISCRETES – M ASTER TO R EMOTES

7 D ISCRETES – R EMOTES TO M ASTER

8 A NALOG I/O  Inputs  Do not provide loop power  Single ended, G terminal shared by all inputs  Outputs  Provide power  Single ended, G terminal shared by all outputs  On RF signal loss and by configuration, outputs will set to 4ma or hold last value

9 A NALOG – M ASTER TO R EMOTES

10 A NALOG – R EMOTES TO M ASTER

11 PLC I NTERFACE

12 I/O E XTENDER C ONFIGURATION  Configuration is performed using the IO_Config utility  For each modem the utility is used to configure both the RF and I/O modules  RF module configuration  Can use all radio features (P2P, P2MP, repeaters...)  Alternatively could be configured using HyperTerminal  I/O module (PIC) configuration  Defines number of remotes in master  Assigns the remote number (address)  Sets I/O module baud rate (must match to radio baud rate)  Maps (assigns) analog points for each remote  Alternatively could be configured using HyperTerminal  NOTE: On older products with internal jumpers, remove the I/O terminal blocks or I/O power before configuring

13 C ONFIGURATION C OMPONENTS

14 M ODULE C ONFIGURATION To configure set switches to PIC To configure set switches to RF

15 C ONFIGURATION – I/O (PIC) M ODULE

16 C ONFIGURATION – RF M ODULE

17 ERRATA  Cycle power after configuration to reset the modem. This is not required for new version products with configuration switches but is good practice.  In the event of power brownout the I/O module may get “lost”. Cycling power (remove I/O power too) will reset the modem. New version products with configuration switches are designed to prevent this.  Very early model I/O extenders cannot be field configured.

Field Proven Performance – Industrial Grade Support DATA-LINC GROUP Field Proven Performance – Industrial Grade Support T HANK Y OU !