© FLIR Systems 2009. All Rights Reserved. Leveraging the Power of Thermal Imaging 1/4/2014 Presented by: Mark Boccella.

Slides:

Advertisements

Similar presentations

ENERGY STAR ® SALES ASSOCIATE TRAINING Programmable Thermostats.

Advertisements

1 Copyright 2006 Yamatake Corporation All Rights Reserved. Body PressingPaintingWelding Engine Casting / Heat treatment Unit assembly Machining Final assembly.

Energy Conservation Mike Klun Cargill. Getting Started (Planning) Why do I want to do this? – Cost reduction or environmental impact Will I be successful?

Affordable Green Basics and Selected Lessons Learned Christine Bruncati, R.A. New Jersey Institute of Technology Center for Architecture and Building Science.

IAQ Problem Prevention NH Health Officers Association Spring Conference May 25, 2011 Phil Alexakos, MPH, REHS Chief of Environmental Health and Emergency.

Sustainable School Design Creating Healthy, High Performance School Facilities Presented by Stephen M. Koontz, Energy Services Leader, Tampa Bay Trane.

Building a Better Future Stretch Building Code October 15, 2009.

Energy Audit Kaylin Fitzgerald Environmental Science Mr. Fitzgerald.

Retrofitting: Lessons from the Residential Market

J.B. Speed School of Engineering University of Louisville KEEPS Energy Management Toolkit Step 2: Assess Performance & Opportunities Toolkit 2J: Building.

Energy Efficient Heating Ventilating and Air Conditioning.

John Merison Building & Maintenance Contractors Ltd Welcome from.

Antero Punttila Analyzing most typical energy saving measures Energy Efficiency of Steam and Condensate Systems Antero Punttila, Motiva Oy.

Energy Savings Impacts of the Advanced Energy Design Guide: Small Office Buildings Bing Liu, P.E. Research Engineer Pacific Northwest National Laboratory.

Energy Efficiencies Opportunities for SMEs … An effective tool to sustain bottom line Tuesday, April 2, 2013.

Home Energy Efficiency US-China Greener Consumption Forum March 22, 2013.

Thermography Adam Adgar School of Computing and Technology.

CK Doolittle Enterprises, Inc.

How to lower the energy use of your home David Parker Building Analyst/ Energy Auditor Parker Energy Solutions David Parker Building Analyst/ Energy Auditor.

Why blower door testing? Measure leakage Detect sources Verify fixes Click your mouse to continue to next slide.

1 | WEATHERIZATION ASSISTANCE PROGRAM STANDARDIZED CURRICULUM – July 2012eere.energy.gov Building Science Basics WEATHERIZATION INSTALLER/TECHNICAN FUNDAMENTALS.

Department of Energy Energy Savers PowerPoint: Your Home’s Energy Use 2 of 12.

Key HVAC Design Concepts. Agenda Discuss relevance of thermal enclosure system to HVAC system. Present the three major steps to design an HVAC system.

Thermal Imaging & Trace & Access Nick Jeffery Training Manager.

1 | WEATHERIZATION ASSISTANCE PROGRAM STANDARDIZED CURRICULUM – August 2010eere.energy.gov Energy Movement WEATHERIZATION ENERGY AUDITOR SINGLE FAMILY.

A Home Energy Workshop. Developed by Central Vermont Community Action Council In partnership with Efficiency Vermont.

1 Thermography of Buildings Stacey Ward - BSRIA Instrument Solutions - - Sales Manager -

Maintenance At Your WWTP August 2010

West Virginia's residential building code is mandatory statewide; however, adoption by jurisdictions is voluntary. The 2013 West Virginia Legislature.

WHO WE ARE: Motive 7 Inspections brings together years of industrial repairs, gasketing and sealing understanding.

This 12 part PowerPoint series is taken directly from Energy Savers Booklet, Tips on Saving Energy & Money at Home, U.S. Department of Energy.

Heat Transmission HVAC CNST 305 Environmental Systems 1 Dr. Berryman.

Thermographic Testing Vibrotech Reliability Services Limited.

 On average, home heating uses more energy than any other system in a home  About 45% of total energy use  More than half of homes use natural gas.

Infrared Thermography

Thermal Imaging & Leak Detection Nigel Hewitt Technical Manager.

This project has been assisted by the New South Wales Government through its Energy Efficiency Training Program Prepared by Energy Efficiency through Product.

ARCH-432 Vapor Retarders and Air Barriers Attendance In what modern day country was the first cavity wall developed and used? For what purpose? A. Spain.

1 | WEATHERIZATION ASSISTANCE PROGRAM STANDARDIZED CURRICULUM – December 2012eere.energy.gov Energy Movement WEATHERIZATION ENERGY AUDITOR SINGLE FAMILY.

Part 2: Buildings as a System Lee F. Ball Jr., PhD

Status of the Data Collection Completed – State and Agency Surveys – Indoor Air Quality Study – Bulk Fuels Study – Large Multi-family Buildings Study In.

How Do Homes Perform In [Your Town]? [Your Name ] [Company Name] [ , phone, website] [Insert your company logo here]

New Mexico State University EFFICIENT RESIDENTIAL ENERYGY Fahzy Cooperative Extension Service ______ County.

Rio Grande Valley Sustainability Council 7 th Annual Energy Efficiency and Conservation Conference July 18, 2013.

Weatherization 201: Weatherization Works! Updated September 23, 2008.

© 2008 Data Power Services, LLC By: Tom Taranto 2010 Energy Expo Hosted by National Grid NYSERDA Reducing Compressed Air Energy Cost Using a Systems Approach.

Sustainable Homesteads Project Woodleigh school Year 7 – bringing science, maths and design together.

Minimizing Structural Energy Loss Andrew Layman Lisa Phillips.

Andrew Layman Lisa Phillips. What is the primary source of energy loss in a house and what are some solutions to minimize this loss?

 On average, home heating uses more energy than any other system in a home  About 45% of total energy use  More than half of homes use natural gas.

Kansas Housing Resources Corporation Kansas Energy Efficiency Program.

THE BENEFITS OF SPRAYFOAM SPRAYFOAM. Virginia Foam's polyurethane foam creates an air-tight seal that offers the highest degree of insulation possible.

Healthy Homes Home Energy & Weatherization. Energy Management for Home goals … save energy provide comfort assure safety and health.

1 | WEATHERIZATION ASSISTANCE PROGRAM STANDARDIZED CURRICULUM – September 2012eere.energy.gov QUALITY CONTROL INSPECTOR Interpreting Infrared.

1 | WEATHERIZATION ASSISTANCE PROGRAM STANDARDIZED CURRICULUM – December 2012eere.energy.gov WEATHERIZATION ENERGY AUDITOR SINGLE FAMILY Interpreting Infrared.

SEPTEMBER 2002 Pixel Support Tube A. Smith LBNL 1 ATLAS Pixel Detector Heater Panel Testing Alexis Smith September 17, 2002.

THERMOGRAPHY Presented By: Nagaraj S Patil. Contents Introduction What it is? Where it is used? What makes it useful? Principle Application Advantages.

 A Thermal Imaging Camera makes an image from thousands of surface temperature measurements  The Camera detects ‘thermal’ radiation in the infrared.

9. Sample Infrared Images

INFRARED THERMOGRAPHY

Draught Finder 4. Air Tightness Inspections The Air Test Trevor Clark

Draught Finder Trevor Clark Qualified Thermographer

Greening Your Home You deserve a Comfortable and Healthy Home!

Draught Finder Trevor Clark 8. Thermal Infrared Inspections

Infrared Inspection Services in UAE

MIKE BUTLER PRESIDENT & OWNER.

3 BENEFITS TO CHOOSING TIME RISK VALUE

Portable Temperature Measurement Instruments by Testo Testo is a world market leader in the field of portable and stationary measurement solutions

Independently owned and operated

Presentation transcript:

© FLIR Systems All Rights Reserved. Leveraging the Power of Thermal Imaging 1/4/2014 Presented by: Mark Boccella

© FLIR Systems All Rights Reserved. Welcome! Thermal Imaging & Thermography Utility Applications – Reliability is Key New Technologies – Optical Gas imaging Building Diagnostics – Energy Analysis Q&A Today we will learn about:

© FLIR Systems All Rights Reserved. What is Infrared? LWLW MW SWSW 0.9 to 1.7µm 1.0 to 5.0µm 8.0 to 13.0µm

© FLIR Systems All Rights Reserved. –Significantly reduce unscheduled power outages –Detects problems quickly, without interrupting service –Assess priorities for corrective action –Minimize preventive maintenance and troubleshooting time –Improving Equipment Reliability & Life –Check for defective equipment while still under manufacturer warranty. Why Infrared for Utilities? Reliability is Key - The Benefits of a Proactive IR Program:

© FLIR Systems All Rights Reserved. 1/4/20145 Infrared Camera Types Small Handheld Solutions for every department Optical Gas Imaging for Natural Gas (Methane) & SF6 Detection Automated Cameras for 24/7 Condition Monitoring High Resolution – Long Distances

© FLIR Systems All Rights Reserved. 1/4/20146 Better Resolution is going to provide a clearer image with more accurate temperature measurements, and have larger FOVs.

© FLIR Systems All Rights Reserved. High Definition Infrared Higher resolution means sharper images Higher resolution means better measurement accuracy at a distance 640x480 = 307,000 detectors CameraLens FOVSingle Pixel Spot Size Ratio 3x3 Cell Spot Size Ratio Distance to 1" spot 320x24024°x18° (std)750:1263:122.5 feet 640x48024°x18° (std)1528:1513: feet 80x80320x240

© FLIR Systems All Rights Reserved. New Technology – Optical Gas Imaging Petro Refinery Industry SF6 GAS Detection Methane / Natural Gas Detection

© FLIR Systems All Rights Reserved. 1/4/20149 Missing Insulation Wet Insulation Air Infiltration Structural Deficiencies Duct Leaks Degraded seals around windows and doors How about Energy Efficiency in Residential Buildings?

© FLIR Systems All Rights Reserved. ITC © 2008 Missing Insulation How about Energy Efficiency in Residential Buildings?

© FLIR Systems All Rights Reserved. Air Leaks The camera does not see air, but it does see the cooling effect of the cold air on the surface of nearby materials ©2008 Infrared Training Center. All rights reserved.

© FLIR Systems All Rights Reserved. Improperly Blown Cellulose

© FLIR Systems All Rights Reserved. Important Notes –Infrared inspection requires a sufficient difference in temperature from inside to outside (ΔT of 10°C) for a sufficiently long period of time, to produce discernible differences between areas with studs and areas that may contain insulation. –Wet materials retain heat and change slower than dry areas of the same type building material. –Knowledge of building construction is necessary to properly diagnose the problem. Use IR thermography in conjunction with: –R-Value calculator and energy savings estimator –Dew point and wet spot location –Blower door testing –Duct leak testing ©2008 Infrared Training Center. All rights reserved.

© FLIR Systems All Rights Reserved. 1/4/ $5k-$8K$8.5K-$15K $25K-$40K $2k-$3K