Spectroscopy Energy of a molecule can be written (to a reasonable approximation) E = E kinetic +E rotational +E virbational +E electronic +E nuclear Molecules,

Slides:



Advertisements
Similar presentations
SPECTROSCOPY.
Advertisements

Uv spectroscopy.
Infrared Spectroscopy A.Why are we doing this experiment? 1)Infrared spectra tell us only a limited amount about a transition metal complex 2)In very simple.
Infrared Spectroscopy
Raman Spectroscopy A) Introduction IR Raman
SPECTROSCOPY.
Lecture 8. The energy is sufficient to promote or excite a molecular electron to a higher energy orbital. Consequently, sometimes called "electronic spectroscopy".
Visible and IR Absorption Spectroscopy Andrew Rouff and Kyle Chau.
UV / visible Spectroscopy
Spectrophotometry Chapter 17, Harris
Lecture 3 Kinetics of electronically excited states
Spectrophotometric Analysis
Outline Final Comments on Titrations/Equilibria Titration of Base with a strong acid End-point detection Choice of indicators Titration Curve method Start.
Introduction to Infrared Spectroscopy
Absorbance of Electromagnetic Radiation
Spectrophotometry: An Analytical Tool. PGCC CHM 103 Sinex IoIo I Cell with Pathlength, b, containing solution light source detector blank where I o =
Lecture 5. UV-VIS Spectroscopy. Ultraviolet and Visible Absorption Spectroscopy When matter absorbs electromagnetic radiation in the domain ranging from.
UV-Vis spectroscopy Electronic absorption spectroscopy.
Chapter 2 Quantitative.
Time out—states and transitions Spectroscopy—transitions between energy states of a molecule excited by absorption or emission of a photon h =  E = E.
Introduction to Instrumental Analysis - Spectrophotometry
Fluorescence Spectroscopy 1Dr. Nikhat Siddiqi. Principles Interaction of photons with molecules results in promotion of valence electrons from ground.
KHS ChemistryUnit 3.4 Structural Analysis1 Structural Analysis 2 Adv Higher Unit 3 Topic 4 Gordon Watson Chemistry Department, Kelso High School.
1 University of Petra Faculty of Science & Arts Department of Chemistry Seminar I.R Spectroscopy By Firas Al-ouzeh Supervisor : Nuha I. Swidan Summer 2007.
BCHM 313 – Physical Biochemistry
Absorption Spectroscopy See you on the Dark Side of Biochemistry.
10-1 Application of IR Raman Spectroscopy 3 IR regions Structure and Functional Group Absorption IR Reflection IR Photoacoustic IR IR Emission Micro.
Different methods for structure elucidation. Spectroscopy: Studying the properties of matter through its interaction with different frequency components.
Structure Determination by Spectroscopy Mass spectroscopy Ultraviolet-visible spectroscopy Infrared spectroscopy Nuclear magnetic resonance spectroscopy.
441 Chem CH-2 Ultraviolet and Visible Spectroscopy.
TOPIC D: SPECTROMETRY AND SPECTROSCOPY. Mass spectrometry is used to detect isotopes. mass spectrometer uses an ionizing beam of electrons to analyze.
Spectrophotometry: An Analytical Tool
Chem. 31 – 4/1 Lecture.
States and transitions
Chapter 2: IR Spectroscopy Paras Shah
Chapter 6 An Introduction to Spectrometric Methods Spectrometric methods are a large group of analytical methods that are based on atomic and molecular.
Asa Arjoon U6 Chemistry Presentation on Visible and Ultraviolet Spectroscopy Name : Form : Subject :
© 2014 Pearson Education, Inc. Mass Spectrometry, Infrared Spectroscopy, and Ultraviolet/Visible Spectroscopy Paula Yurkanis Bruice University of California,
SPECTROPHOTOMETRY. Spectrophotometry Determines concentration of a substance in solution –Measures light absorbed by solution at a specific wavelength.
Outline Start Chapter 18 Spectroscopy and Quantitative Analysis.
Lecture 7 Mass Spectrometry UV/Vis Spectroscopy
Lecture 21 UV/Vis Pick up Lecture Problem 7 This Week in Lab: Work on 1st Synthetic Next Week in Lab: Ch 9 Final Report Due Synthetic #2 PreLab Due.
Ch 10 Pages ; Lecture 24 – Introduction to Spectroscopy.
California State University, Monterey Bay CHEM312
UV SPECTROSCOPY Absorption spectra.
Infrared Spectroscopy
Isaac Newton showed that a glass prism could be used to split sunlight into a spectrum in Further studies by William Wollaston in 1802 revealed.
Chem. 31 – 6/30 Lecture. Announcements I Lab –Supplement to Co/Cr Lab has been posted online AP2.2 due Quiz 4 today No Class on Monday (July 4 th )
Chem. 133 – 3/9 Lecture.
441 Chem CH-2 Ultraviolet and Visible Spectroscopy.
Principles and practice of Spectrophotometer
Absorption Spectroscopy
Chem. 31 – 10/25 Lecture.
Spectrophotometer Dr . S. Jayakumar.
Spectrophotometry: An Analytical Tool
UV SPECTROSCOPY Absorption spectra.
Introduction and Principle of IR Spectrophotometry
UV-VISIBLE SPECTROSCOPY Dr. R. P. Chavan Head, Department of Chemistry
Electronic Spectroscopy Ultraviolet and visible
Analytical methods Prepared By Dr. Biswajit Saha.
Light and Matter Main Concept:
P. 235.
P. 235.
化工群英文示例 沙鹿高工 簡佩琳.
Absorption Spectroscopy
A SEMINAR ON Ultraviolet-Visible Spectroscopy
Organic Chemistry Molecules and Colour.
Introduction During the last years the use of Fourier Transform Infrared spectroscopy (FTIR) to determine the structure of biological macromolecules.
Spectrophotometric Analysis
UV- Visible Spectrophotometry
Presentation transcript:

Spectroscopy Energy of a molecule can be written (to a reasonable approximation) E = E kinetic +E rotational +E virbational +E electronic +E nuclear Molecules, M, tend to sit in their lowest el and vib state. When electromagnetic radiation is incident on M, if emr is resonant with an energy gap to another state of M, then M can be ‘pushed’ into new level: spectroscopy is the measure of that energy and how easily it happens. Microwave: rotations; Infrared: vibrations; UV-visible: electronic (+vibns).

Absorbance Bonds  Molecules  Spectroscopy Molecules are 'glued together' by electrons between the atoms. ~ Two electrons per bond. Approximation: electrons can be put into independent orbitals (with defined spatial characteristics). Two of Opposite spin. Two types of bonds are important for bio molecules:  (sigma) bonds look like s-orbitals when viewed along the bond axis.  (pi) bonds look like p-orbitals (dumbbells) when viewed down the bond axis Also non-bonding pairs, e.g. lone pairs on N & O Ultra violet/visible (UV/vis): how much energy is required to push electrons to new orbitals. Infra red (IR): strong bonds high cm  1, bends low cm  1

 electron systems  electrons are held less tightly than  electrons  so require less energy to excite to unoccupied orbitals Many biological systems have alternating = and  bonds making conjugated systems: electrons held even less tightly  coloured compounds. E.g.  -carotene Most biomolecule spectroscopy used is  or n 

Electrons  bonds  structure. UV/visible light: ~ 180 nm – 800 nm, energy h  hc/ causes electrons to go to higher energy levels. required depends on electron rearrangement needed. In solution: broad bands due to diff. vibrational levels in excited state & molecules having slightly different energy levels. UV: –350 nm Vis: 400 nm – Excited electronic state Ground electronic state Ground vibn’l level rr

Absorption spectra of DNA & proteins With proteins and DNA the transitions we usually study are n   * and    * so can access them with normal spectrometers. Below 200 nm need nitrogen purging because O 2 absorbs

Polarization of transitions Direction electrons move during a transition Often defined by the symmetry of the molecule    * transitions are in the plane of the chromophore Absorbance Absorbance: A = log(I o /I) = log(intensities in/out) Beer Lambert A =  cl,  extinction coefficient (units?), c concentration, l length (cm) Oriented samples and polarised light: only light whose electric field pushes the electrons along the polarisation direction causes a transition

Proteins Far UV (250 – 180 nm) dominated by peptide group Many buffers absorb here — so beware! First n  * 210 – 220 nm, weak (  ~100 cm  1 dm 3 mol  1 ) First  * 180 nm, stronger (  ~ 7000 cm  1 dm 3 mol  1 ) In  -helix only has a component at 208 nm ?? n  * transition 175 nm, charge transfer between amides Side chains absorb in this region: aromatics, Asp, Glu, Asn, Gln, Arg & His. Usually small.  * n  *

Proteins Near UV — 'aromatic' side chains. Tryptophan: Indole side chain, absorbs 240 – 290 nm, 3 or more transitions,  ~5,000 cm  1 dm 3 mol  1 Tyrosine: 274 nm,  ~1400 cm  1 dm 3 mol  1 Phenyl alanine: 250 nm,  ~200 cm  1 dm 3 mol  1 Cystine (disulfides): 250–270 nm,  ~300 cm  1 dm 3 mol  1 pH: tyrosine & tryptophan have protonation sites that directly affect conjugation of chromophore tyrosine -OH, pK a ~ 10.9 shifts from 275 nm to 295 nm hemes, flavins, pyridoxal phosphate, metalloprotiens have intense UV or visible absorption bands.

Protein concentration from UV absorbance  (280 nm, tryptophan) = 5,700 mol  1 dm 3 cm  1  (280 nm, tyrosine) = 1,300 mol  1 dm 3 cm  1 So can determine protein concentration using:  280 = (nW (5690) + nY(1280) + nC(120)) Equation is valid provided:- ·no contribution from light scattering ·no other chromophore (e.g. cofactor) in the protein ·no other absorbing contaminant, e.g. nucleic acids Alt. 1 mg/mL av. abs = 1.1±0.5 Or 1.55  A  A 260 = mg protein/mL (accounts for nucleic acid contamination) up to 100% error Or use chemistry to create visible molecules from reaction with peptide backbone  need standards with similar response

Absorbance spectra

Nucleic acids Near UV absorbance of nucleic acids due (almost) exclusively to planar purine and pyrimidine bases Backbone from 190 nm Each 'simple' band observed is a number of transitions Ligands bind  change DNA A and ligand A. Intercalators upon DNA binding: red shift (4-20nm) & hypochromoism (  up to 50% A) and less structured spectrum

DNA melting curves A 40 80/  C dA/dt DNA absorbance as a function of Temperature: helix  coil transition. DS  SS  + ~ 10% Abs. T m is 50:50 DS:SS. Maximum of derivative is ~ T m Determine thermodynamic data from shape of curve. AT rich T m lower than GC rich A increases due to loss of  -  stacking interaction (cf. intercalators)

Protein infra red absorbance Use cm  1 as energy unit Amide I C=O stretch: solution ~ 1690, solid ~ 1650 cm  1 Amide II N-H bend: solution ~ 1600, solid ~ 1640 cm  1  -helix + unordered: 1650 cm  1  -sheet:1618, 1632, 1661 cm  1  -turns: 1660  1679 cm  1 non H-bonded C=O: 1700 cm  1 Use D 2 O in most cases. CaF 2 cells BSA 20 mg/mL 0.1 mm pathlength D 2 O

Extinction coefficients  varies with species,, and concentration. To determine  (ideally) 3 independent weighings + 2 serial dilutions  Beer Lambert Law. Often use single point, but beware! Watch effects of pH — changes species & hence .

Binding constants from UV  usually changes when two molecules bind. Simple e.g. change pH to add or take proton.  1 : extinction coefficient of species 1 x 1 :mole fraction of species 1 A: total absorbance c tot : total analyte concentration etc Isosbestic points (constant absorbance during a titration where the total concentration of analyte stays the same, but species is in more than one form) means that it is in two states.

Determine the concentration of p-nitrophenol (PH) and its conjugate base (P - ) at pH = 7.2 from the data at 315 nm. A 315 (pH=4.5)=0.55; A 315 (pH=10.3)=0.08; A 315 (pH=7.2)=0.30 A(pH=7.2) = {[PH] 7.2  + [P - ] 7.2  (P  l  0.55/(5  10  5 ) = 11,000 moles  1 dm +3 cm  1  (P 0.08/(5  10  5 ) = 1,600 moles  1 dm +3 cm  1 [PH] 7.2 =(5  10  5 )  x 1 ; [P  ] 7.2 =(5  10  5 )  x 2 =(5  10  5 )  (1  x 1 ) A(pH=7.2) = 0.30 = 5  10  5 [11,000x 1 +1,600(1-x 1 )] X 1 ={0.30/(5  10  5 )  1,600}/{11,000  1,600} = 0.47 X 2 =1  0.47=0.53 [PH] 7.2 =(2.3  10  5 ); [P  ] 7.2 =(2.7  10  5 ) NB if pH = 7.2, then [H + ] = 10  7.2 So equilibrium association constant for H + and P  is: K assoc =[PH]/{[P  ][H + ]}=(2.3  10  5 )/{(2.7  10  5 ) 10  7.2 }=1.4  10 7

Roles in spectroscopy of: 1. Electromagnetic spectrum, esp. frequencies and wavelengths of UV, visible and IR 2. Lenses 3. Mirrors 4. Gratings and monochromaters 5. Prisms and quarter/half wave plates and monochromaters 6. Photoelastic modulators 7. Diode detectors 8. Photomultiplier tubes 9. Why does Beer-Lambert law work (relate to definition of absorbance) 10. IR light source 11. Data processing of photon count to plot on screen. 12. Compensation of lamp energy variations