Let Me Dance VER 1.11a

JP1 CD OUT MOTOR JP9 PRINT JP4 S/W IN JP3 CD IN MOTOR JP7 CASE MOTOR JP6 U/D MOTOR JP12 SS2 JP13 SS1 JP5 COIN JP2 BILL INIT SETUP S/W LET ME DANCE CONTROL BOARD JP11 DC POWER INPUT Copyright 2006 K-river Entertainment. All rights reserved.

[CO IN TEST] [UP/DW TEST] [CASE TEST] [CD OUT TEST] 1 IN 2 GND 1 IN 2 GND 1 IN 2 GND 1 IN 2 GND

[JP2 BILL] [JP1 CD OUT MOTOR] GND 2 BAD SENSOR 3 GND 4 GOOD SENSOR 5 MOTOR ( ㅡ ) 6 MOTOR (+12V) 1 White 2 White 3 White 4 White 5 White 6 Red 1 +12V 2 INHIBIT 3 +12V 4 BILL INPUT 5 GND 6 GND

[JP5 COIN] [JP3 CD IN MOTOR] X 2 GND 3 TRANSMIT PULSE 4 +5V 5 +5V 6 RECEIVE INPUT 7 CD IN SENSOR 8 MOTOR ( ㅡ ) 9 MOTOR (+12V) 1 X 2White 3 White 4 White 5 White 6 White 7 White 8 White 9 Red 1 +12V 2 X 3 COIN INPUT 4 INHIBIT 5 X 6 GND 1 Red 2 X 3 Gray 4 Yellow 5 X 6 Black

[JP7 CASE MOTOR] [JP6 U/D MOTOR] GND 2 DOWN SENSOR 3 GND 4 UP SENSOR 5 X 6 MOTOR ( ㅡ ) 7 MOTOR (+12V) 1 White 2 White 3 White 4 White 5 X 6 White 7 Red 1 GND 2 CASE SENSOR 3 MOTOR ( ㅡ ) 4 MOTOR (+12V) 1 White 2 White 3 White 4 Red

[JP9 PRINT] [JP11 DC POWER IN] DRY CONTACT (COM) 2 DRY CONTACT (N.O) 1 +12V 2 GND 12

[JP13 SENSOR 1] [JP12 SENSOR2] GND 2 IN 3 +12V 1 GND 2 IN 3 +12V

[CON4] SWITCH1 2 SWITCH2 3 SWITCH 3 4 GND

1 Set-Up 2 Board Reset 3 PARK 4 Free 5 GND Black Blue SW Yellow SW Red SW White SW [ SETUP SW Connection ]

1 White 2 White 100cm 2 1 YEONHO : SMH Black 2 Black 100cm Terminal ( Y Circuit) Yellow 2 Yellow 100cm Red 2 Red 100cm 2 1 ( Y Circuit) Terminal JP4 (Set-Up) JP17 (Board Reset) JP3 (Park) JP16 (Free) [SETUP SW WIRING]

Shield Electric wire (4P) 5Ground Blue 6 White 2 INHIBIT Black 1 DC +12V Red 5 Red 2 Black 8 Blue 9 White AMP P PIN : [ BILL ] Molex : cm U.S.A. ICT DC 12V 1.If in the CD, CD Case and Paper is out the Bill Acceptor will not Receive the bills. 2. During the process the machine will not receive any bill. 3 INHIBIT +12V Yellow 3 Yellow 4 Signal Green 7 Green