Ethernet Switch Features Important to EtherNet/IP

Slides:



Advertisements
Similar presentations
1 UNIT I (Contd..) High-Speed LANs. 2 Introduction Fast Ethernet and Gigabit Ethernet Fast Ethernet and Gigabit Ethernet Fibre Channel Fibre Channel High-speed.
Advertisements

LAN Segmentation Virtual LAN (VLAN).
© 2006 Cisco Systems, Inc. All rights reserved. ICND v2.3—2-1 Extending Switched Networks with Virtual LANs Introducing VLAN Operations.
© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 3: VLANs Routing & Switching.
© 2006 Cisco Systems, Inc. All rights reserved.Cisco PublicITE I Chapter 6 1 Implement Inter- VLAN Routing LAN Switching and Wireless – Chapter 6.
© 2007 Cisco Systems, Inc. All rights reserved.Cisco Public ITE PC v4.0 Chapter 1 1 Addressing the Network – IPv4 Network Fundamentals – Chapter 6.
Switching & Operations. Address learning Forward/filter decision Loop avoidance Three Switch Functions.
Implementing Inter-VLAN Routing
Multi-Layer Switching Layers 1, 2, and 3. Cisco Hierarchical Model Access Layer –Workgroup –Access layer aggregation and L3/L4 services Distribution Layer.
© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 3: VLANs Routing & Switching.
Copyright © 2015 John Wiley & Sons, Inc. All rights reserved. 8-1 FitzGerald ● Dennis ● Durcikova Prepared by Taylor M. Wells: College of Business Administration,
1 Chapter 8 Local Area Networks - Internetworking.
Lesson 1: Configuring Network Load Balancing
Ethernet Frame PreambleDestination Address Source Address Length/ Type LLC/ Data Frame Check Sequence.
Hubs & Switches Ethernet Basics -10. There is only so much available bandwidth, in some instances it can be dynamic An overabundance of data on the network,
(part 3).  Switches, also known as switching hubs, have become an increasingly important part of our networking today, because when working with hubs,
LOGO Local Area Network (LAN) Layer 2 Switching and Virtual LANs (VLANs) Local Area Network (LAN) Layer 2 Switching and Virtual LANs (VLANs) Chapter 6.
Connecting LANs, Backbone Networks, and Virtual LANs
HiVision SNMP Software.
Introduction to IT and Communications Technology Justin Champion C208 – 3292 Ethernet Switching CE
Chapter 6 High-Speed LANs Chapter 6 High-Speed LANs.
Connecting LANs, (network devices) Backbone Networks, and Virtual LANs Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction.
Chapter 4: Managing LAN Traffic
© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 3: Implementing VLAN Security Routing And Switching.
Connecting LANs, Backbone Networks, and Virtual LANs
– Chapter 5 – Secure LAN Switching
Network Security1 – Chapter 5 – Secure LAN Switching Layer 2 security –Port security –IP permit lists –Protocol filtering –Controlling LAN floods (using.
1/28/2010 Network Plus Network Device Review. Physical Layer Devices Repeater –Repeats all signals or bits from one port to the other –Can be used extend.
S3C2 – LAN Switching Addressing LAN Problems. Congestion is Caused By Multitasking, Faster operating systems, More Web-based applications Client-Server.
Module 8: Ethernet Switching
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 4 Switching Concepts.
15.1 Chapter 15 Connecting LANs, Backbone Networks, and Virtual LANs Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or.
Computer Networks 15-1 Chapter 15. Connecting LANs, Backbone Networks, and Virtual LANs 15.1 Connecting devices 15.2 Backbone networks 15.3 Virtual LANs.
© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 3: Implementing VLAN Security Routing And Switching.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 8 Virtual LANs.
Semester 3—LAN Switching Chapter 2 Objectives  By the end of this chapter we will be able to perform tasks related to: – Various LAN Communication Problems.
Click to edit Master subtitle style
Sem1 - Module 8 Ethernet Switching. Shared media environments Shared media environment: –Occurs when multiple hosts have access to the same medium. –For.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 9 Virtual Trunking Protocol.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 8 Virtual LANs Cisco Networking Academy.
Chapter 3 - VLANs. VLANs Logical grouping of devices or users Configuration done at switch via software Not standardized – proprietary software from vendor.
McGraw-Hill©The McGraw-Hill Companies, Inc., 2004 Connecting Devices CORPORATE INSTITUTE OF SCIENCE & TECHNOLOGY, BHOPAL Department of Electronics and.
Switching Topic 2 VLANs.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 3 v3.0 Module 7 Spanning Tree Protocol.
McGraw-Hill©The McGraw-Hill Companies, Inc., 2004 Chapter 16 Connecting LANs, Backbone Networks, and Virtual LANs.
Virtual Local Area Networks (VLANs) Part II
Chapter 4 Version 1 Virtual LANs. Introduction By default, switches forward broadcasts, this means that all segments connected to a switch are in one.
W&L Page 1 CCNA CCNA Training 2.5 Describe how VLANs create logically separate networks and the need for routing between them Jose Luis.
Cisco Confidential © 2010 Cisco and/or its affiliates. All rights reserved. 1 Multicasting within UCS Qiese Dides.
1 VLANs Relates to Lab 6. Short module on basics of VLAN switching.
© 2008 Cisco Systems, Inc. All rights reserved.Cisco ConfidentialPresentation_ID 1 Chapter 3: VLANs Routing & Switching.
CISCO NETWORKING ACADEMY Chabot College ELEC Ethernet Switches.
15.1 Chapter 15 Connecting LANs, Backbone Networks, and Virtual LANs Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or.
+ Lecture#8: VLAN Asma AlOsaimi Topics VLAN Segmentation VLAN Implementation VLAN Security and Design 3.0.
Networks and Security Great Demo
Ethernet Packet Filtering - Part1 Øyvind Holmeide Jean-Frédéric Gauvin 05/06/2014 by.
Instructor Materials Chapter 5: Network Security and Monitoring
© 2002, Cisco Systems, Inc. All rights reserved.
software features Highlight
Networking Devices.
Optical-Based Switching Solutions
Planning and Troubleshooting Routing and Switching
– Chapter 5 – Secure LAN Switching
Configuring EtherChannels and Switch Troubleshooting
Chapter 5: Network Security and Monitoring
IS3120 Network Communications Infrastructure
Routing and Switching Essentials v6.0
Chapter 3: Implementing VLAN Security
Best Practices for Configuring Stratix Managed Switches
Presentation transcript:

Ethernet Switch Features Important to EtherNet/IP Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Switch Features are Important The proper selection of switches to be used in real-time (I/O) EtherNet/IP networks is critical. There are several features that are very important and can provide the appropriate infrastructure for your application. The following features need to be considered: Required: Full-duplex capability on all ports IGMP Snooping Port Mirroring Recommended: VLAN Auto-negotiation and manually configurable speed/duplex Wire-speed switching fabric SNMP for switch management IEEE 802.1D Spanning Tree Protocol Desirable: see last slide Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Copyright © 2005 Rockwell Automation, Inc. All rights reserved. Full-duplex Full-duplex capability on all ports: Full duplex capability eliminates collisions on the wire due to the separate transmit and receive channels for each device. Combined with the speed of switches available today, delays related to collisions or traffic in the switch can be made negligible. The end result is you can achieve a high degree of determinism with an EtherNet/IP network and it works well for I/O control. Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Internet Group Multicast Protocol (IGMP) Snooping IGMP snooping constrains the flooding of multicast traffic by dynamically configuring switch ports so that multicast traffic is forwarded only to ports associated with a particular IP multicast group. Switches that support IGMP snooping “learn” which ports have devices that are part of a particular multicast group and only forward the multicast packets to the ports that are part of the multicast group. Sends out IGMP polls to determine who is in a multicast group to plant network Listens to the polls and responses to determine who is in each multicast group Layer 3 Switch or Router Layer 2 Switch Layer 2 Switch Controller I/O (Multicast Producer) (Consumer) Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

IGMP Snooping - continued Normally, a commercial layer 2 switch that “supports” IGMP snooping needs a router (which could be a layer 3 switch) to send out the IGMP polls in order to learn what devices are part of the multicast group. *** IMPORTANT *** Some industrial layer 2 switches support IGMP snooping without the requirement for a router or layer 3 switch to be present to send out the IGMP polls. to plant network Note that none of the multicast traffic hits the router Layer 3 Switch or Router Layer 2 Switch Layer 2 Switch Controller I/O (Multicast Producer) (Consumer) Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Copyright © 2005 Rockwell Automation, Inc. All rights reserved. Port Mirroring Port Mirroring: Port mirroring refers to the ability to direct a duplicate of the frames being transmitted on one port to another port. This allows a traffic analyzer to be connected to a switch and have the ability to monitor the traffic on a given port. Without port mirroring, an analyzer is not able to see frames on other ports. Traffic analyzers are used extensively by people who support Ethernet networks. Therefore, it is critical that a switch is selected that supports port mirroring so that a traffic analyzer will function correctly on the network. Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Virtual Local Area Networks (VLANs) The benefits of VLANs are that a switch can be configured to handle two isolated networks without the traffic from one network burdening the other. IP multicast traffic from VLAN 1 will not reach VLAN 2. For multicast traffic, you could accomplish the same thing with IGMP snooping. However, a VLAN will also block unicast and broadcast traffic, and adds a measure of security between networks. I/O Controller1 PC Controller2 1 2 3 4 5 6 7 8 VLAN 1 VLAN 2 Switch Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Auto-negotiation / Manually Configurable Speed/Duplex Auto-negotiation and manually configurable speed/duplex: Auto-negotiation allows devices to select the most optimal way to communicate without the user having to configure the devices. If a manually configured device is attached to an auto-negotiation device there can be problems which result in a high rate of CRC errors. While all 100 Mbps devices are required to support auto-negotiation, most existing 10 Mbps devices do not. Two other areas where this switch feature can be helpful include when fibers converters are used in a system (auto-negotiation is not supported by fiber links) and to eliminate potential incompatibilities in the implementation of the auto-negotiation by different device vendors. Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Wire-speed Switching Fabic Wire-speed switching fabric: The switch fabric capacity is a measure of the maximum traffic that a switch can handle without dropping a packet. Wire speed switching fabric refers to a switch that can handle the maximum data rate of the network on each of its ports. Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Simple Network Management Protocol (SNMP) SNMP, Simple Network Management Protocol, is a TCP/IP protocol used to obtain statistical information about a device. SNMP software is very popular with network managers. It allows a network manager to view and modify a wide variety of network parameters, and also provides a common way to manage many diverse vendor products utilizing a single Network Management Tool. Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

IEEE 802.1D Spanning Tree Protocol Ethernet infrastructures can be designed to provide redundant backbone connections for improved fault tolerances. The Spanning Tree Protocol is to ensure that although multiple paths may exist between two devices connected to the infrastructure, only a single path will be used for communications at any one time. The switch should have the ability to enable and disable this feature on a per port basis. Copyright © 2005 Rockwell Automation, Inc. All rights reserved.

Desirable Switch Features IEEE 802.1p Frame Prioritization IP address blocking Restricts traffic to IP Addresses in specific range (down to one) DHCP Option 82 Limited DHCP Server (for small systems) Auto-restore of switch config on replacement Per port broadcast and multicast storm control Port Trunking for applications with many switches Various security functions Copyright © 2005 Rockwell Automation, Inc. All rights reserved.