Presentation Flytec The new Flytec 6040 balloon instrument GPS for position and speed Graphical display New wind layer display Can work with existing TT34 envelope temperature transmitters Based on the proven concept of 6020/6030 instruments for Hang gliders and Para gliders Instrument firmware flashable at any time. New software download from Flytec website Optimized power management with two battery banks for standard AA cell alkaline batteries or rechargeable NiMH batteries Optional Bluetooth connection to a cellular phone for online tracking

Presentation Flytec Available Displays The main page Variometer GPS Compass Free Selectable user fields Alarms and Info GND Speed

Presentation Flytec Available Displays The wind layer page (new) Variometer User selectable fields Wind layers Signal strength from the TT34

Presentation Flytec Available Displays The Airspace map display Your actual track The most important values Waypoints CTR margins (Open air format, editable by user, also wildlife protection areas are available) Variometer CTR Information

Presentation Flytec The wind layer display Ascending phase Start, scale is fixed to 100m Ascending PhaseThe scale is at its end The scale moves while still ascending The pilot changes the zoom out to 500m (3500m scale)

Presentation Flytec The maximum altitude is reached The wind layer display Descending phase The balloon begins to descend Landing

Presentation Flytec Functions The Keyboard

Presentation Flytec User fields Altitudes and Speed Alt 1 mAlt1 as User field in m (corrected with QNH) Alt 1 ftAlt 1 as Userfield in ft (corrected with QNH) Alt 2Reference height (if desired can be set at 0) Alt 3Cumulated gained height Alt GPSGPS Altitude FL (ft)Flight Level not adjustable by the user GND speedground speed*(=GS) Speed and time Wind SpeedWind strength measured with the vane wheel (For estimating the wind strength at start place TimeTime (GPS sync.) FlighttimeFlight time since take off Factory set data fields * Only available if GPS active The factory set data fields can be personalized You can chose between three pages with different sets of data fields on each page

Presentation Flytec User fields Temperatures TempAmbient temperature Env. TempEnvelope temperature Max. Env.Max envelope temperature Navigation TrackFlight direction (course)* BearingDirection to chosen destination* Dist to WPDistance to chosen destination (waypoint)* Dist.T.CylDistance to the circumference of a waypoint cylinder in case of a competition route Dist. T. TakeoffDistance to start or flight recognition (acceptance)* Dist. t. GoalDistance to goal calculated along a route* Dist to CTRDistance to the nearest control zone Factory set data fields * Only available if GPS active

Presentation Flytec Alarms Alarms are displayed in the lower two text lines. They will be announced by an unobtrusive beep  Sink alarm  Max. envelope temperature of the manufacturer reached ( settable in the Basic Settings)  Max. envelope temperature personal setting reached  CTR – approach 2D  Low battery alarm TT34

Presentation Flytec Functions Altitude Alerter  A minimum or a maximum altitude alarm is settable. If the balloon goes over or under this thresholds an unobtrusive beep will sound. Additional, a level holder can be set and the instrument sends a signal via an interface, for burner control or autopilot functions. Max Min Level

Presentation Flytec Flight recording Recording starts with 20m altitude change and vario >0.5 m/s for longer than 30 seconds. Recording ends with the ESC key. It is possible to switch off this recognition to record continuously The IGC file contains the track, GND Speed, the envelope temperature and the ambient temperature.

Presentation Flytec Approvals File format of the IGC file is according to FAI IGC standard. Altimeter according FAR Part 43 App E or TSO-C10b Variometer according TSO-C8b AS394A or TSO-C8d

Presentation Flytec Flychart Flight analysis Program