ERT 216 HEAT AND MASS TRANSFER INTRODUCTION

Slides:



Advertisements
Similar presentations
Electronics Cooling MPE 635 Mechanical Power Engineering Dept.
Advertisements

Quiz – An organic liquid enters a in. ID horizontal steel tube, 3.5 ft long, at a rate of 5000 lb/hr. You are given that the specific.
Introduction Lecture PE 313 Mass Transfer (I) Dr. Noha Said Yousef.
217 – Sunday - from 10:30 to 1:20 Lecture: E 217 – Sunday - from 10:30 to 1: –Sunday - from 8:30 to 10:20 Tutorial: E232 –Sunday - from 8:30 to 10:20.
Conduction & Convection Quiz 9 – TIME IS UP!!! A flat furnace wall is constructed with a 4.5-inch layer of refractory brick (k = Btu/ft·h·
ERT 216 HEAT & MASS TRANSFER Sem 2/
Basic law of heat conduction --Fourier’s Law Degree Celsius.
Convection in Flat Plate Turbulent Boundary Layers P M V Subbarao Associate Professor Mechanical Engineering Department IIT Delhi An Extra Effect For.
So Far: Conservation of Mass and Energy Pressure Drop in Pipes Flow Measurement Instruments Flow Control (Valves) Types of Pumps and Pump Sizing This Week:
Temperature, Heat, and the First Law of Thermodynamics
Heat Transfer Chapter 2.
Chapter 2: Overall Heat Transfer Coefficient
MECh300H Introduction to Finite Element Methods
ChE 201 Chemical Engineering Calculations I Fall 2005/2006 Course Description: System of units and dimensions. Stoichiometry. Ideal and non-ideal gases,
CE 318: Transport Process 2 (Heat and Mass Transfer) Lecture 18: Convective Mass Transfer (Chapter 28) NSC 210 4/16/2015.
Chapter 4 Fluid Flow, Heat Transfer, and Mass Transfer:
Fabric Material Properties Aaron Packard Me En 340 Heat Transfer 16 April 2007.
Geankoplis Singh&Heldman
Meshal Khaled Al-Saeed Dr. Malik Al-Ahmad
Introduction to Convection: Mass Transfer Chapter Six and Appendix E Sections 6.1 to 6.8 and E.4.
© Fluent Inc. 8/10/2015G1 Fluids Review TRN Heat Transfer.
Wittaya Julklang, Boris Golman School of Chemical Engineering Suranaree University of Technology STUDY OF HEAT AND MASS TRANSFER DURING FALLING RATE PERIOD.
Heat Transfer Lecture 1.
ADVANCED MASS TRANSFER
 Course : Physical Chemistry  Course Code: ERT 108  Course Type: Core  Unit : 3  Pre-requisite of ERT 206 Thermodynamics  Lecturers: › Miss Anis.
Heat Transfer in Structures
STEADY HEAT TRANSFER AND THERMAL RESISTANCE NETWORKS
ERT 321 PROCESS CONTROL & DYNAMICS
Engineering Materials EMT 110 Semester /2013 BY: PUAN NURUL AIN HARMIZA ABDULLAH.
Heat Transfer Equations For “thin walled” tubes, A i = A o.
First Day Material Course identification and general information  Title and code: Thermo-Fluid ME384  Program: mechanical engineering  Level: level.
Biosystems engineering
MISS NOR FAUZIAH BINTI ZAINUDIN ERT 214/4 Material and Energy Balance.
CBE 150A – Transport Spring Semester 2014 Non-Steady State Conduction.
So Far: Conservation of Mass and Energy Pressure Drop in Pipes Flow Measurement Instruments Flow Control (Valves) Types of Pumps and Pump Sizing This Week:
Introduction Lecture Prepared by Dr. Riham Hazzaa.
ERT 216/4 HEAT & MASS TRANSFER Sem 2/ Prepared by; Miss Mismisuraya Meor Ahmad School of Bioprocess Engineering University Malaysia Perlis.
ERT 216 HEAT & MASS TRANSFER Sem 2/
Objectives Calculate heat transfer by all three modes Phase change Next class Apply Bernoulli equation to flow in a duct.
Lesson 13 CONVECTION HEAT TRANSFER Given the formula for heat transfer and the operating conditions of the system, CALCULATE the rate of heat transfer.
Objectives Finish with Heat transfer Learn about Psychometrics Psychometric chart.
By: Narendra Babu N M110247ME THERMAL ANALYSIS OF MICROPROCESSOR.
Department of Chemical Engineering King Saud University Separation Processes – I CHE 316 Prof. Mohammad Asif Room 2B45, Building 3
Presented By: Pritesh K Jaradi
External Flow: Mass Transfer Chapter 7 Sections , 7.7, 7.8.
(Heat and Mass Transfer) Lecture 17: Unsteady-State Diffusion
Convection in Flat Plate Boundary Layers P M V Subbarao Associate Professor Mechanical Engineering Department IIT Delhi A Universal Similarity Law ……
Objectives Review: Heat Transfer Fluid Dynamics.
INTRODUCTION TO CONVECTION
Heat Transfer Equations For “thin walled” tubes, A i = A o.
1._____process that forms clouds (water cycle 2) 2.____ layer of atmosphere that weather occurs in (atm layers) 3._____ process that adds heat and changes.
FORMS OF HEAT TRANSFER. CONDUCTION CONVECTION.
Teaching Innovation - Entrepreneurial - Global
Heat Transfer Introduction and Conduction. Conduction  If a temperature gradient exits in a continuous substance, heat can flow unaccompanied by any.
Fourier's law of heat conduction
Prof. Mohammad Asif Room 2B45, Building 3 Tel: Department of Chemical Engineering Separation Processes.
Heat Transfer by Convection
Heat Transfer Su Yongkang School of Mechanical Engineering # 1 HEAT TRANSFER CHAPTER 6 Introduction to convection.
Transferência de Energia e de Massa Energy and Mass Transfer Lecture 1: Introduction to the subject and to the course 1.
Introduction to Food Engineering
ERT 214 Material and Energy Balance / Imbangan Bahan dan Tenaga
ERT 213 INTRODUCTION TO PROCESS INSTRUMENTATION
Conservation of Mass and Energy
ERT 108 Physical Chemistry INTRODUCTION
BDD Heat Transfer Kamil Abdullah D212 – 212 |
CHEMICAL ENGINEERING…..
Process Heat Transfer Course Code: CHPE302
Environmental Management
Effects of Free and Forced Convection on the Convection Coefficient and Time to Steady State for Various Objects Christian Roys, Jon Zywusko, and Julie.
Chemical Engineering Department
Presentation transcript:

ERT 216 HEAT AND MASS TRANSFER INTRODUCTION BY MRS AZDUWIN BINTI KHASRI 19 FEBRUARY 2013

LECTURER Mrs. Azduwin Khasri (C) Miss Mismisuraya Meor Ahmad Mr.Lee Boon Beng PM Dr Kassim

MRS.AZDUWIN BINTI KHASRI B.Eng.Hons Chemical Engineering UKM M.Eng.Chemical Engineering UTM azduwin@unimap.edu.my 013-7239950/ +04-9768190

COURSE OBJECTIVES CO1: Ability to calculate mode of heat transferred CO2: Ability to calculate mode of mass transferred CO3: Ability to evaluate heat transfer knowledge as well as designing heat transfer equipment

(Panduan/Guidelines) TEACHING PLAN Minggu/Week Kandungan Kursus / Course Contents (Panduan/Guidelines) Pensyarah/Lecturer Week 1 (18 Feb-22 Feb ) Introduction Define and discuss the mechanism of heat transfer. Recognize and calculate fourier’s law. Differentiate conduction, convection and radiation. Recognize and calculate thermal conductivity of materials Mrs. Azduwin Khasri Week 2 -4 (25 Feb-15 Mac) Principles of steady-state heat transfer: Conduction heat transfer Calculate the conduction heat transfer through flat slab, hollow cylinder, hollow sphere, flat slab in series, multilayer cylinder, combined convection and conduction and overall coefficient, conduction with internal heat generation and critical thickness of insulation of cylinder -- Lab 1: Thermal Conductivity of Liquid and Gas -- Lab 2: Linear and Radial Heat Conduction

TEACHING PLAN Miss Mismisuraya Week 5 – 6 (18 Mac-29 Mac) Principles of steady-state heat transfer: Convection heat transfer Calculate the convection heat transfer through forced convection heat transfer inside pipe (dimensionless no.), heat transfer coefficient for laminar flow inside pipe, heat transfer coefficient for turbulent flow inside pipe, heat transfer coefficient for transition flow inside pipe, heat transfer coefficient outside various geometries in forced convection and natural convection heat transfer -- Lab 3: Free and Force Convection Heat Exchanger Miss Mismisuraya Week 7 (1April-5 April) Principles of steady-state heat transfer: Radiation heat transfer Calculate the convection heat transfer through radiation from small object from surrounding, emission of radiation, black body, gray body and combined radiation and convection ******** Mid-Term Examination 1

TEACHING PLAN Mid-Semester Break PM Dr Kassim Week 8 (8 April-12 April) Mid-Semester Break Week 9 - 10 (15 April-26 April) Heat transfer equipment: Heat Exchanger Calculate the heat exchanger through the overall heat-transfer coefficient and Fouling Factors, types of heat exchanger and methods required for the design of heat exchanger . Heat transfer equipment: Evaporator Define and Discuss the types of evaporation equipment, processing factors, methods of operation of evaporators and evaporation of biological materials. Calculate the heat and mass balances for evaporators, effects of processing variables on evaporator operation, boiling point rise of solutions and enthalpy-concentration charts of solutions -- Lab 4: Plate Heat Exchanger PM Dr Kassim Week 11 (29April-3 May) Heat transfer equipment: Dryer Define and Discuss the general drying methods, types of dryer, vapor pressure of water and drying of biological materials. Calculate the humidity, wet bulb temperature, adiabatic saturation temperature, moisture and rate of drying curves Week 12 (6 May-10 May) Heat transfer equipment: Agitated Vessel Define and discuss the equipment for agitation. Calculate the power used in agitated vessel, agitator scale-up, mixing times and heat transfer in agitated vessel

TEACHING PLAN Week 13-15 (13 May-31 May) Principles of Mass Transfer Calculate the mechanism and principles of mass transfer through FIck’s law, moleculardiffusion in gases, liquids and solid, molecular diffusion in biological solution and gels and convective mass transfer. -- Lab 5: Liquid Diffusion Coefficient ******** Mid-Term Examination 2 ******** Lab Test MR. Lee Boon Beng Week 16 (3 June -7 June) Study Week Week 17 - 20 (10 June-5 July) Final Examination

FAIL FINAL EXAM FAIL THE COURSE!!! EVALUATION Peperiksaan/ Examination: 70% Mid Term Examination 1 = 10% Mid Term Examination 2 = 10% Final Examination = 50% Kerja kursus/course work: 30% Laboratory :10% Integrated project :10% Assignments /Quizzes :10% FAIL FINAL EXAM FAIL THE COURSE!!!

LABORATORY Thermal Conductivity of Liquid and Gas Linear and Radial Heat Conduction Apparatus Free and Force Convection Heat Exchanger Plate Heat Exchanger Liquid Diffusion Coefficient

MRS MAIZATUL & MR MOHYUDDIN LAB SCHEDULE WEEK EXP 1 EXP 2 EXP 3 EXP 4 EXP 5 TUTORIAL (T) TUTORIAL (LECTURER) LAB (LECTURER) LAB (GRA) 1 INTRODUCTION 2 A1 A2 A3 A4/A5 A6/A7 GROUP B MRS AZDUWIN MISS MISMISURAYA MRS MAIZATUL & MR MOHYUDDIN 3 B1 B2 B3 B4/B5 B6/B7 GROUP A 4 5 PM DR KASSIM 6 7 MR LEE BOON BENG 8 MID TERM BREAK 9 10 11 12 13   14 15 16 STUDY WEEK 17 EXAM WEEK 18 19

LAB GROUPING SYABIL AHMAD SABRI GROUP A GROUP B Group: A1 AINAN TASNEEM BINTI RIDZUAN LEE YEN FONG PANG CEI HUAI NURUL AMIRA ROSMANI BINTI MOHD RAWI Group: B1 AIN FATIN HUSNA BINTI MOHD KHAIRUL AMIN LO SHAO TING NORHASLINA BINTI MOHD TARMIZI SYABIL AHMAD SABRI Group: A2 BEH ZHIKUAN MAS MELOR BINTI HASSAN NUR SIHA BINTI ABD RAHMAN NURUL IZZATIE BINTI ISHAK Group: B2 AMERA NOORDEKA BINTI ADNAN MOHAMAD SABRI BIN JUFRI NUR SYAIRAH BINTI SAFFARUAN NURUL SYAFIQAH BINTI AHMAD FISAL Group: A3 CHOO YEN MEI MOHAMAD ZHAFRI BIN ZAILANI NUR SYAZWANA BINTI HASMADI NURWAFAA BINTI ZUKIMIN Group: B3 CHIN HUI SIAN MONICA ELEN MATHEW NADING NUR ZULAIKHA BINTI MOHD MOHNI NORFARHAZAIMA BINTI BAKRI Group: A4 FARISHA NABELLA BINTI ABDUL MALIK MUHAMAD FITRI BIN MOHD ALI MUSTAWI NUR ZURIANA BINTI ZABIDI PANG CHIEN HAN Group: B4 CHUA EI MAY MUHAMMAD ABDUL FATAH BIN ABDULLAH PEGGY WONG LEH JIUNN NURUL ASYIQIN BINTI ABDUL HALIM Group: A5 HEMAVATHI KRISHNAN MUHAMMAD ARIF BIN MUSA NURFARHANA BINTI MAZLIN RABIATUL ADAWIYYAH BT ARIFIN @ MO'AIN Group: B5 HEW CHOOI MEE MUHAMMAD SUHAIL BIN MOHD ISA NURNADIA BINTI JAIS SANTHINI A/P BALAKRISHNAN Group: A6 KOH WAN WEN NIK NURUL ATIKAH BINTI AMRAN NURSYAKILA BINTI ROSLAN SHAIKH MOHD AIMAN BIN SEFF AHMAD Group: B6 NURSYAZALINA BINTI IDRIS THANURSHA A/P GOPALA KRISHNAN TOH YEE LEEN MUHAMMAD LUQMAN BIN MD RAZALI Group: A7 LAILATUL AZIZAH BINTI MOHKILISAN SITI NURUL NADZIRAH BINTI ADAM SOON VINNY Amirah ajid Group: B7 NOR AMALINA BINTI ROSLAN TEY LI PING ZULIANA BINTI MUHAMAD RIDZWAN KRISHNAMURTHY Nur athirah

TEXT BOOK

Q & A THANK YOU